As in the figure , find the value of the bending moment M, which can be carried safely, since the safety coefficient=1200 n/cm^2 in a cross-section steel bar with the effect of the mutual bending moment "M" from the two ends. In this case, calculate the radius of curvature.Find the largest shapeshifting rate in the cross section.(modulus of elasticity=2 * 10^5 = N / mm^2

Q: The solid shaft shown is made of a steel that is assu increased in magnitude until the shaft has…

A:

Q: An inverted T beam (refer to the Figure 4(a)) manufactured from material with the given stress and…

A:

Q: The beam shown in the figure below is subject to a moment of M = 10 kN.m as illustrated. Calculate…

A:

Q: An aluminum rectangular bar has a cross-section of 25 mm x 50 mm and a length of 500 mm. The Modulus…

A:

Q: The steel tie-bar shown in the figure has been designed to carry a tension force of 76 kN when…

A:

Q: The steel bar has the original dimensions shown in the figure. If it is subjected to an axial load…

A:

Q: A box section of length L = 6 m and cross-sectional dimensions of a 52 mm, b = 44 mm has wall…

A:

Q: .A steel beam structure has a rectangular cross-section as shown in Figure Q1. The beam is built-in…

A:

Q: (a) Try to find the slope of point A and point C after deformation. (b) Try to find the (vertical)…

A:

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.