Answer: (a) Tmax= psi ( b) σma psi

Q: How do you convert gpm to ft?

A: A cross-sectional area's flow of fluid is measured in gallons per minute. In simple terms, it…

Q: What is meant by ephemerides?

A: Ephemerides is a term related with astronomy and celestial navigation.   Ephemerides is a table…

Q: Part C is the only one I need worked out.  Thanks!

A:

Q: Whose responsibility is it to create the as-built BIM? Architect / Engineer to complete designers'…

A: This question is related to the Building design from Civil Engineering.

Q: What is kinematics? What is meant by pitch, yaw and roll?

A:

Q: What is susbtainable design?

A: Answer Introduction Sustainable design is defined as these are those that seek to minimize the…

Q: Draw the complete shearing force diagram and bending moment diagram for the beam shown below. State…

A: A beam is simply supported at two ends. Two UDLs of 500 N/m at each end 0.3 m from the supports A…

Q: of CAG. 2) D= 9M.

A: Here, B & d are the actual dimension of rectangular region which is inside the circle. After…

Q: What is shear starin rate?

A: Shear rate:

Q: Distinguish between intermittent system and continuous system of water supply

A: In Intermittent system water supply is divided into several zone and each zone is supplied with…

Q: What is gravity dam?

A: The gravity dam can be defined as it is a mass concrete structure which is made up of stone or…

Q: Is there anything special about a CPLD

A: Several different types of the PLDs which means programmable logic devices are existed such as FPGA,…

Q: delermine wether G) is analytic ornot.

A:

Q: +4

A: Given

Q: (Figure 1) Express your answer with the appropriate 0 Submit μA 6 a 1₂= 26.268 108 mm Previous…

A:

Q: Differentiate force system based on line of action.

A: A force is a push or pull on an object caused by its interaction with another object.

Q: y thermal bridging? thank you if you will answ

A: A thermal bridge, also known as a cold bridge, is a section of a building with much higher heat…

Q: what is mercury manometer? own words

A:

Q: A 3% ascending grade meets a descending grade at the vertex at station 2+050 and elevation 100m with…

A:

Q: Q/Classification the water tanks according placement?

A:

Q: dx?

A: Hello, here i am answering to this problem according to our guyidelines so i can provide solution…

Q: A- In Fig.A , If the resultant force acting on the bracket is to be 642 N directed along the…

A: (A) in Fig AHorizontal force component of 300 KN force =300×cosθθ is the angle of force with…

Q: Find the critical path , time of executed of the projects and draw the activity by arrows Activity…

A:

Q: 5. Provide the missing bearings of the following=

A: solution Given line ABForward bearing =N44°38'E the whole cicrle bearing =44°38'as we know back…

Q: Discuss  in  details coagulation

A: Coagulation is defined as the process of converting smaller dissolved solids into larger particles…

Q: May I trouble you to solve the problem (b)

A: Find: The reactions at the supports and draw the bending moment diagram.

Q: P-80 N 40 F=200 N 200 mm W=140 N 1 V3 C= 20 Nm FIGURE C 100 mm H 90 N 200 mm 400 mm 6. An angular…

A:

Q: What is beam

A: The amount by which a beam deflects upon its cross-section, bending moment and shear force. For…

Q: Do the demands of a user vary from those of a system?

A: User access security refers to integrated processes where authorized users have access to a computer…

Q: Station End area fill (sf) Distance (ft) Volume (cy) 150 + 00 360 150 + 50 3,500 50 151 + 00 10,400…

A: use mean area method to find the volume mean area is found out by using Amean=A1+A22volume V=…

Q: installed in the front lawn and along one side and seeded the remain- der with 3.5 pounds per 1,000…

A:

Q: List some benefits of using hand-level instruments.

A: A hand level instrument is a device which is used  for rough levelling.  It is mainly used for small…

Q: What does it mean that a room has good sound control ?

A: Good sound control of room can be done by soundproofing of the room. This can be done if pressure of…

Q: Organize the ten (10) scrambled words given and create a horizontal network diagram that shows the…

A: ACTIVITY                                                                             PREDECESSOR…

Q: The bars AB and BC of the structure are of length 4 m each. A load of 10 kN is placed at D and…

A:

Q: Define the term Underabsorption of Over-Head?

A: Let’s first understand the definition of overhead: Overhead refers to the continuing business…

Q: What are Frontal Inversions?

A: Inversion is used when metrological inversion of temperature takes place. It is an alteration from…

Q: Orothgeomitric on graphical paper

A: Approach to solving the question:Please see attached photos for the detailed solutions. Thank you.…

Q: P₁ 3 m E B P₂ 3 m- D 4 m

A: Given TrussLoadsTo find out Zero force members

Q: What are servomotors?

A: Servomotors are used in cars to control its speed.

Q: What is Constructive Acceleration?

A: The constructive acceleration is defined as “when a failure occurs the contractor accelerates the…

Q: 100 KN

A:

Q: 3. The tractor is used to lift the 250-kg load B with the 28m-long rope, boom, and pulley system. If…

A: Determine tension in the rope,T=?