:Answer a or b:- a) A variable capacitance and a resistance of 160 Q are connected in series across a 240-V; 50-Hz supply. Draw the complex or locus of impedance and current as the capacitance changes from 4µF to 28 µF. From the diagram, find (a) the capacitance to give a current of 0.6 A and (b) the Curmnt uhan the canacitance isIL uf

:Answer a or b:- a) A variable capacitance and a resistance of 160 Q are connected in series across a 240-V; 50-Hz supply. Draw the complex or locus of impedance and current as the capacitance changes from 4µF to 28 µF. From the diagram, find (a) the capacitance to give a current of 0.6 A and (b) the Curmnt uhan the canacitance isIL uf

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Find the equivalent inductance of the circuit shown in the figure. 0.06 H 0.04 H 0.06 H 0.06 H
An A.C Bridge as shown in the figure is used to measure unknown inductance L1. in companion with capacitance What would be the quality factor if the frequency is 1500 Hz & the various parameter are as below- 120V
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
Calculate capacitance Cand voltage U over resistance. What is the peak value of resistance's voltage? Voltage source e(t) = ésin(wt + 45°). Resistance R-50, circuit's total reactance X-50, inductance L =50mH, ê -40V and frequency f =50Hz. R L Give the answers to one decimal place. Do not write numbers in the complex number form! Absolute value of voltage source (RMS value): V Total impedance of circuit (absolute value): Capacitance: μF Absolute value of current (RMS value) supplied by voltage source: Phase angle of current: degrees Peak value of resistances voltage: 22 A
An RC circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 ohms and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
Q.4Determine the current flowing in the capacitor(-j25ohm) and its direction as shown in Figure below. Assume the voltage source to have negligible impedance.
1. Enumerate five formulas for series-parallel capacitances across Vt source and draw the circuit. 2. Enumerate five formulas for parallel-series capacitances across Vt source and draw the circuit.
An emf source with E=100 V, a resistor with R=80 ohms, and a capacitance with C=4 uF are in series.connected. While the current is 0.9A during the loading of the capacitor, the load on the plates of the capacitor ishow big is it (in uC)?
Find the equivalent inductance as seen from the terminals shown in the figure.
Three capacitors each of the capacitance C are given. The resultant capacitance 2/3 C Can be obtained by using them ? a)Two in parallel and third in series with this combination b)All in parallel c)All in series d)Two in series and third in parallel across this combination
2: A 10Q resistance is in parallel with 50µF capacitance and the current through the capacitance is: (ic=2sin100t+1.5sin200t+1.2sin400t) Ampere. Find the total dissipated power by the circuit? (Ans.: P,=9305W) Jel 50120ein 100oti20cin2000 Volt is oprlied
A capacitor in series with a 200 ohms resistor draws a current of 0.3 ampere from 120 volts, 60 hz source. What is the value of the capacitor in microfarad? a. 8.7 b. 9.7 c. 6.7 d. 7.7