An upward flow of oil (mass density 800 kg/m³, dynamic viscosity (0.8 kg/m-s) takes place under laminar conditions in an inclined pipe of 0.1m diameter as shown in the figure. The pressures at sections 1 and 2 are measured as p₁ = 435 kN/m² and p₂ = 200 kN/m². p2 2₁ 45° 5m F5 The discharge in the pipe is equal to

Q: Piezometric tubes are tapped into a pipe section as shown in the figure below. The liquid is…

A:

Q: Given the following information about a length of pipe: P1 = 440 kPa V1 = 0.0085 m/s z1 = 5 m v2 =…

A: Applying Bernoulli`s equation between point 1 and 2 in the given pipe flow:…

Q: In a smooth pipe of uniform diameter 30 cm a pressure of 60 kPa was observed at section 1 which was…

A:

Q: Water flows at a rate of 0.1 m³/s through the horizontal pipe transition as shown below. Pressures…

A: Q = 0.1 m3/s D1 = 0.1 m D2 = 0.2 m P1 = 19620 PaP2 = 49050 Pa

Q: pipeline connected to a reservoir discharges water 30 m below the free surface in  the tank. The…

A:

Q: The pressure heads are measured at two sections in a pipeline and are found to be 8.3 m at point A…

A: Step 1: Step 2: Step 3: Step 4:

Q: A straight pipe AB, of length 10 m, tapers from a diameter of 40 cm at A to 20 cm at B. The centre…

A:

Q: uid mechan

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: A straight pipe AB, of length 10 m, tapers from a diameter of 40 cm at A to 20 cm at B. The centre…

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?