Answered: An unknown sample solution whose… | bartleby

Related questions

Question

Q4 (10 points)/
An unknown sample solution whose concentration is 2.33 x 10-3 g/L is placed in a 1.2
cm clear holder and found to have a transmittance of 34 %. The concentration of this sample
is changed such that its transmittance has increased to 49 %. Calculate the new
concentration of the sample.

Expert Solution

Step by step

Solved in 3 steps with 12 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

3.1 A wire of diameter d, length l and resistivity ρ forms a circular loop. A current entersand leaves the loop at points P and Q as shown in the Figure. Show that the resistance R ofthe wire is given by the expression (4) R = 4ρx(l − x) / π*d^2*l
PPROBLEM 3. An electromotive force, E(t), is applied to an RC circuit in which the capacitance is 100 µF and resistance 0.2 kn. S400 V 0 30 find the current i(t) if i(0) = 0. What is the current as t → o? Given E(t) = (50 V
High-end headphones (such as the likes of Audeze and HiFiMan) have a such high impedance compared to earbuds. If aneodymium driver of a headphones have a diameter of 40 mm and a thickness (note that this is a flat cylinder) of 2 mm, how much higher is its resistance compared to an earbuds with a diameter of 10 mm and thickness of 1 mm (ρ = 110 x 10^-7 Ωm).
Consider the circuit below. = 150 mF 16 kN Ry V2 = 24 V = 16 k. R2 V1 = 24 V 48 kQ Ra R, = 48 kN (a) What is the RC time constant of the circuit (in s)? X S 1140 (b) What is the initial current (in A) in the circuit once the switch is closed? A (c) How much time (in s) passes between the instant the switch is closed and the time the current has reached half of the initial current?
I have an RL circuit driven by 25 V battery with R=5 ohm, L = 4H. The current is ) at t=0. Find the energy dissipated by the resistor in the first ten seconds after the circuit is connected.
(a) In the figure what value must R have if the current in the circuit is to be 0.84 mA? Take ε1 = 1.9 V, ε2 = 3.4 V, and r1 = r2 = 3.1 Ω. (b) What is the rate at which thermal energy appears in R?
What capacitance should be used to produce a 2.00 MΩ reactance at 60.0 Hz?
In the U.S., where the standard is 120 V, a particular light bulb has a power rating of 100 watts. What will be its true power output if it is used in Europe, where the standard is 220 V?
A 4G phone has a data receiver with an inductance of 0.3 μH. When the capacitance is tuned to 2e-13 F, the signal is the strongest. The wireless frequency is _____ MHz.
High-end headphones (such as the likes of Audeze and HiFiMan) have a such high impedance compared to earbuds. If a neodymium driver of a headphones have a diameter of 40mm and a thickness (note that this is a flat cylinder) of 2mm, how much higher is its resistance compared to an earbuds with a diameter of 10mm and thickness of 1mm (p = 110 x 10-7 Am)
The current-voltage characteristics of a non-linear load is given in the figure. The load behaves as an open circuit if the absolute load voltage is lower than |E|. However, if v(t)>E| then the load behaves as a linear resistor. The linear resistor value is equal to i(t) Slope =1/R R=902 -E This non-linear load is connected to O E v(t) 220Vrms voltage source which is purely sinusoidal. If E=150V then; a) Skech the load current for one period, and give the important magnitude and time values on the figure. b) Calculate the average power of the load. Slope =1/R
High-end headphones (such as the likes of Audeze HifiMan) have such high impedance compared to earbuds. If a neodymium driver of a headphones have a diameter of 40mm and a thickness (note that this is a flat cylinder) of 2mm, how much higher is its resistance compared to an earbuds with diameter of 10mm and thickness of 1mm. (ρ= 110x10^-7Ω) Follow the format: Given: Required: Equation: Solution: Answer:

SEE MORE QUESTIONS