Answered: An oscillating voltage of fixed… | bartleby

Related questions

Question

An oscillating voltage of fixed amplitude
is applied across a circuit element. If the frequency of this voltage is increased, will the amplitude
of the current through the element (i) increase, (ii) decrease, or (iii) remain the same if it is (a) a resistor,
(b) an inductor, or (c) a capacitor?

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A V = 86-V source is connected in series with an R = 1.8-kΩ resistor and an L = 26-H inductor and the current is allowed to reach maximum. At time t = 0 a switch is thrown that disconnects the voltage source but leaves the resistor and the inductor connected in their own circuit. 1) How much time, in milliseconds, is needed for the current in the circuit to drop to 12 % of its value at t = 0? 2) How much energy, in millijoules, does the circuit dissipate during that time?
In a home stereo system, low sound frequencies are handled by large “woofer” speakers, and high frequencies by smaller “tweeter” speakers. For the best sound reproduction, low-frequency currents from the amplifier should not reach the tweeter. One way to do this is to place a capacitor in series with the 8.0 Ω resistance of the tweeter; one then has an RLC circuit with no inductor L (that is, an RLC circuit with L = 0). What value of C should be chosen so that the current through the tweeter at 200 Hz is half its value at very high frequencies?
In a damped oscillating circuit the energy is dissipated in the resistor. The Q-factor is a measure of the persistence of the oscillator against the dissipative loss. (a) Prove that for a lightly damped circuit the energy, U, in the circuit decreases according to the following equation. dU dt = −2βU, where β = R2L . (b) Using the definition of the Q-factor as energy dividedby the loss over the next cycle, prove that Q-factor of a lightly damped oscillator as defined in this problem is Q ≡ Ubegin ΔUone cycle = 1 R L C. (Hint: For (b), to obtain Q, divide E at the beginning of one cycle by the change ΔE over the next cycle.)
Consider a 10W, a 50µF capacitor and a 80mH inductor connected in series across a standard outlet. (a) By what angle is the voltage ahead of the current in this circuit?(b) What is the rms voltage across the capacitor?(c) What is the power dissipated in the inductor (only the inductor), in the capacitor and in the resistor? There are three answers?
A 2.8 kg body oscillates in SHM on a spring that, when extended 5.4 mm from its equilibrium position, has an 8.2 N restoring force. What are (a) the angular frequency of oscillation, (b) the period of oscillation, and (c) the capacitance of an LC circuit with the same period if L is 5.8 H?
(a) What is the resonant frequency (in Hz) of a resistor, capacitor, and inductor connected in series if R = 140 N, L = 3.0 H, and C = 4.0 µF? Hz (b) If this combination is connected to a source with a voltage amplitude of 100 V operating at the resonant frequency, what is the average power output of the source (in W)? w (c) What is the Q of the circuit? Q = (d) What is the bandwidth of the circuit (in rad/s)? rad/s