An open cylindrical vessel is filled with water with a depth of 45 centimeters. Its height is 90 centimeters and its diameter is 30 cm. Find the magnitude of the angular speed in radians per second such that the vortex is just at the bottom. (Ans. 28.00 radians per second)

An open cylindrical vessel is filled with water with a depth of 45 centimeters. Its height is 90 centimeters and its diameter is 30 cm. Find the magnitude of the angular speed in radians per second such that the vortex is just at the bottom. (Ans. 28.00 radians per second)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A 0.3 m diameter pipeline terminates nozzle of outlet diameter = 0.15 m. The free jet from the…

A: Dia of pipeline = 0.3 mOutlet diameter = 0.15 mDeflection of Jet = 90 degreeDischarge of water =…

Q: 60 N 20 0.2 2.5 m 30°

A: To find moment about point O

Q: Consider the following steady, two-dimensional velocity field: V (u, v) = (0.41 +2.1lx)7 +…

A: GivenV→=(0.41+2.1x)i+(-3.3-2.1y)ju=0.41+2.1xv=-3.3-2.1y at Stagnation pointu=v=0so,

Q: Water flows through the pump impeller at the rate of 0.04 m2 /s. If the blades are 20 mm wide and…

A: given- discharge Q=0.04 m3/sblade width B1=B2=2 cmInlet entrance angle α1=45ooutlet exit angle…

Q: If the 80kg cabinet is allowed to roll down the inclined plane, determine the acceleration of the…

A: m=80kg To find normal reaction at A and B

Q: 3. A tank in figure C is accelerated to the right and the width of the tank is 1 m. Determine the…

Q: A vertical U-tube with two legs 2 m apart is filled with water and rotated about a vertical axis 0.5…

Q: Using the method of virtual work, determine the reaction at D.

A: Free body diagram:-

Q: Starting from rest, a rocket is launched upward (a= 4.20 m/s2). At t= 6.85 sec, the motor shuts off…

Q: The opne-top and completely full cylindirical tank is rotated with a constant angulat velocity…

Q: An open rectangular tank, 10.64 m. high, 7.36 m. long, and 5.73 m. wide, has liquid (SG = 1.91) to a…

Q: From the system below, determine absolute Moment about point O. (absolute value only

A: The moment of a force about particular axis is calculated as follows, M = F dHere,M = Moment…

Q: Q.4 When gage A indicates a pressure of 120kPa gage, then cavitation just starts to occur in the…

A: Step 1

Q: 3. An open top cylindrical tank 1.65m in diameter and 3.5m high is 4/5 full of water. Determine the…

A: For a forced vortex flow The depth of vortex (Z)can be expressed as Where r is the maximum radial…

Q: Current Attempt in Progress (Buoyancy, force on plane surface) A cube, 4.0 ft on a side, weighs 2950…

A: To calculate the a)Magnitude of the force of the liquid on the inclined section. b) Location of the…

Q: 4.36. A jet of water falling vertically has a velocity of 24 m/s and a diameter of 50 mm at…

A: Given that: Velocity of water jet at 12m elevation, v1 = 24 m/sDiameter of jet, d = 50mm

Q: closed horizontal cylindrical tank 2.0 m in diameter and 3.5 m high is completely filled with fluid…

A: Given data in question Diameter 2m Height 3.5 m Specific gravity 1.3 Force acting 85 kN = 85×103 N…

Q: A sphere 850mm-diameter floats half submerged in a tank of oil (sg=0.90) 4. What is the total…

Q: Fig. 4 , a 2-in-diameter stream of water strikes a 4-ft-square door which is at an angle of 30° with…

A: The force exerted by the door on water will be normal to the door without friction. There are no…

Q: A jet of water who is dia is 5 cm strike a fixed cup with a velocity of 9.45 m/s and is deflected by…

A: The velocity of the jet before striking the cup (u) =9.45 m/s The velocity of the jet after striking…

Q: The average linear velocity of water at the entrance of a funnel is 0.7 m/s and it increases to 7…

A: Given: Velocity at entrance = 0.7 m/s Velocity at exit = 7 m/s Length of funnel = 0.105 m

Q: Work from first principles and show that for a free vortex the velocity vector at any point is…

Q: #3 the beam. Draw the shear and bending-moment diagrams for W lb/ft W-20 lb/ft

Q: A jet issues from the side of the tank under a head of a=4.36m. The orifice is positioned 5.94…

A: Determine the point it strikes a horizontal plane

Q: A closed tank 2m high and 1m in diameter contains 1.5 m water. The air in the space above water is…

A: Following are the given information. Closed tank height =2 m Closed tank diameter =1.0 m Height of…

Q: A light rod which is suspended by a rope as shown in the figure. The ends of the rod are in contact…

A: LET REACTION AT E=RE REACTION AT A=RA THESE REACTION will cause couple whic equal to couple caused…

Q: Determine the velocity of cylinder B if cylinder A moves downward with a speed of V₁ = 4 ft/s. E Y&

A: Given : Va = 4 ft/s Determine the velocity of cylinder B ?

Q: An open cylindrical vessel, 3m high and 1.50m in diameter is filled with water to a depth of 2.50m.…

A: we have to determine the volume of water allowed to escape through the orifice

Q: A 0.9 m diameter vertical cylindrical tank which is 1 m high and is open to the atmosphere contains…

A: Given data:- Diameter of the cylindrical tank (): 0.9 m- Radius of the cylindrical tank (): = 0.45…

Q: PROBLEM: Two wheels weighing "W" kN and 46 kN, respectively are connected by a rod of negligible…

A: Given:- 46kN To find:- Force of horizontal rod in kN W

Q: A horizontal water jet impinges against a vertical flat plate at 27 ft/s and splashes off the sides…

A: Horizontal water jet impinges against vertical flat plateVelocity of flow (V) = 27 ft/s Force…

Q: Using double integration method calculate the rotation at the free end of the beam.

A: Moment equation of the given canteliverMx=-10x22+5=-5x2 +5

Q: 3k The homogeneous disc with a mass of 5m is supported at point C. For small oscillations, determine…

A: Considering O as the center. There is the a small displacement in the clockwise direction, taking…

Q: The system is released from rest in the position shown with the spring unstretched. The collar A…

A: Given:Mass of the box B, mb=68 kgmass of the collar A, ma=48 kgspring constant, k=885.25 N/m

Q: (Buoyancy, force on plane surface) A cube, 3.6 ft on a side, weighs 2920 lb and floats half-…

Q: Using double integration method calculate the rotation at the free end of the beam. 10KN/m В 5KNM A…

A: Hello dear this is the solution of your problem The answer is found to be Rotation at free end…

Concept explainers

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q34. A 10 cm diameter jet of water éxerts a force of 2 kN in the direction of flow against a stationary flat plate which is inclined at an angle of 30° with the axis of the stream. Find, (i) Force normal to the plate (ii) Velocity of the jet (1) Mass flow rate of water kg/sec. Answer
(Buoyancy, force on plane surface) A cube, 4.9 ft on a side, weighs 2900 lb and floats half-submerged in an open tank as shown in the figure below. For a liquid depth of 10.4 ft, determine (a) the magnitude and (b) the location of the force of the liquid on the inclined section AB of the tank wall. The width of the wall is 7.2 ft. Show the magnitude, direction, and location of the force on a sketch. 10.4 ft (a) FR = (b) YR = 4.9 ft Liquid Cube V Wall width=7.2 ft 26° lb on centerline ft along wall from free surface
Solve.!
The average linear velocity of water at the entrance of a funnel is 0.7 m/s and it increases to 7 m/s at its end which is at a distance of 0.105 m. Determine the convective acceleration at the end of the funnel.
SITUATION. A 35kg disk rests on an inclined surface for which us=0.20 W P A B C 0 Zoom image Determine the reaction at B. a b
A 60° bend occurs in a water pipeline that reduces from 600 mm diameter to 300 mm diameter at the bend (inside bend angle 120). If the gauge pressure at the inlet is 172 KPa, determine the magnitude ad angle of the thrust on the bend when the flow is 0.85 m/s. Hint: start by calculating the initial and final velocities, then the final pressure. Next, analyze the pressure and momentum forces in the x and y planes.
11.7 (A/B). A solid shaft carrying a flywheel of mass 100 kg and radius of gyration 0.4m rotates at a uniform speed of 75 rev/min. During service, a bearing 3 m from the flywheel suddenly seizes producing a fixation of the shaft at this point. Neglecting the inertia of the shaft itself determine the necessary shaft diameter if the instantaneous shear stress produced in the shaft does not exceed 180 MN/m². For the shaft material G= 80 GN/m². Assume all kinetic energy of the shaft is taken up as strain energy without any losses. [22.7 mm.]
m2
QUESTION 4) Calculate the 12kN/m support reactions and hinge force in the system shown in figure. 6771 H 3m B 3m OG 10kN 4 5kNm A
Fluid mechanics
(Buoyancy, force on plane surface) A cube, 4.4 ft on a side, weighs 3110 lb and floats half- submerged in an open tank as shown in the figure below. For a liquid depth of 10.6 ft, determine (a) the magnitude and (b) the location of the force of the liquid on the inclined section AB of the tank wall. The width of the wall is 8.1 ft. Show the magnitude, direction, and location of the force on a sketch. 10.6 ft 4.4 ft Liquid (a) FR = centerline b) YR= all from free surface Cube A V Wall width 28° lb on ft along