An open circular cylinder of 15cm diameter and 100cm long contains water up to a height of 80cm. Find the maximum speed at which the cylinder is to rotate about its vertical axis so that no water spills.

An open circular cylinder of 15cm diameter and 100cm long contains water up to a height of 80cm. Find the maximum speed at which the cylinder is to rotate about its vertical axis so that no water spills.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The nozzle which furnished the water to a certain hydraulic turbine 275mm in diameter and has coefficients of velocity and discharge of 0.98 and 0.96, respectively. The nozzle is supplied from a 60cm pipe in which the water approached the nozzle with a total head of 330m. Compute the following: a. Energy per second delivered by the jet to the turbine. b. Energy measured in hp lost in passing through the nozzle.
As a civil engineering student, you may work after graduation at one of the municipal projects in your city, and it supposed you have an L-shaped gate hinged at O and located at the end of the reservoir to control the flowrate into a pipe to feed water to the city, as shown in the figure below. The pressure inside the pipe is atmospheric. Determine the minimum water depth h at which the water starts flowing into the pipe. Width = 4 ft Right-angle gate. Water Hinge 1-ft-diameter pipe 3 ft
4. A horizontal boiler drum 6m long and 3m diameter is provided with an orifice 100mm in diameter at its bottom. It contains water up to a height of 2.4m. Calculate the time taken to empty the drum.
A cylindrical tank 1m in diameter and 6m high contains 2m of water, 1.50m of oil (specific gravity = 0.8) and air under pressure of 20 KPa. If the 10cm diameter orifice located at the vertical side is 30 cm above the bottom of the tank, find the actual discharge at the orifice if C = 0.95.
Please answer, Hydraulics. Thanks
An open cylinder tank 1.2m height and 0.6m in diameter is completely filled with water and rotated about its axis at 260 rpm. Determine the radius up to which the bottom will be exposed and the volume of water spilled out of the
Please answer, hydraulics.
a) Water discharges at a rate of 5L/s through a nozzle. The jet, 25 mm in diameter, strikes a flat plate held perpendicular to its line of flow. Determine the magnitude of the force on the plate.
A pontoon 6m x 6m x 3m floats in water with a draft of 2m. The orifice at the bottom of the pontoon is 160mm in diameter with a coefficient of discharge of C= 0.60. Determine the time required for the pontoon to sink its top after opening the orifice at the bottom.
Two conical vertical tanks with the same radius of 2m are connected by a pipe line 7.5cm in diameter and 8m in length. The bigger tank with an altitude equal to 3.5m is initially full of water while the smaller tank with an altitude of 2m is empty. If the pipe valve is open to allow water to flow from the bigger tank to the smaller tank until it is full, find the height of the water remaining in the bigger tank.
Example 5&6.2: Water flows from a pressurized tank, through a 6-in-diameter pipe, exits from a 2-in- diameter nozzle, and rises 20 ft above the nozzle as shown in figure E5&6.2. Determine the pressure in the tank if the flow is steady, frictionless, and incompressible. Air (1) 20 ft 2 ft 16 in. Figure E5&6.1 2 in.
4. An open vessel 0.46-m in diameter, 0.60-m high and full of with water is rotated about its axis at such velocity that the water surface 100-mm from the axis makes an angle of 40 degrees with the horizontal. a. How many liters of water are lost? b. Compute the speed of rotation in rad/ sec.