An infinite slope, with a slope angle of 14° made up of a cohesionless soil having o = 30° and y, = 20 kN/m³. It experiences seepage with the water table at the surface. (Assume, unit weight of water as Y„ = 10 kN/m³) %3D FOS against failure without seepage FOS against failure with seepage

An infinite slope, with a slope angle of 14° made up of a cohesionless soil having o = 30° and y, = 20 kN/m³. It experiences seepage with the water table at the surface. (Assume, unit weight of water as Y„ = 10 kN/m³) %3D FOS against failure without seepage FOS against failure with seepage

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The section through a long cofferdam is shown below, the coefficient of permeability of the soil being 6x10-8 m/s. Determine the quantity of seepage entering the cofferdam. T 5.50 m! 0 1 2 3 4 5 E As = 0.70 m +c 10 B to 15 m
b) What is the advantage for the Engineer in using Rankine's lateral earth pressure theory over Coulomb's lateral earth pressure theory? Surcharge q = 25 kPa 1.5 m Fine sand c'= 0 kPa ø' = 34 degrees y = 19.5 kN/m Sheetpile wall Silty sand e'= 15 kPa ø' = 28 degrees y= 20.0 kN/m 3.0 m WT 1.0 m Sandy Gravel c'= 0 kPa ø = 34 degrees y = 21.5 kN/m' (above & below the water table) 4.0 m Figure Q4
A soil profile shown is subjected to a load of 48 kN/m2 at the ground surface. The preconsolidation pressure of the clay Pc = 160 kPa. Determine the settlement of the clay layer caused by primary consolidation. Use Cs = 1/5 Cc. 48 kN/m2 ground surface 4m Sand Ys =16 kN/m³ ground water țablę 6m Y sat =18 kN/m³ Clay 3m 6m Ysat =19 kN/m³ Ans. 71 mm
Exercise: = A 15m-thick soft clay layer has following characteristics: Ysat 16 kN/m³, C₁ = Cy = 0,001 cm²/s, Co = 0.3, e = 1.46. Ground water level is at the ground surface. Soft ground is preloaded by a uniform load of 100 kPa combined with sand drains. Sand drains have following characteristics: diameter = 30 cm, spacing 2.5m, square pattern, length 15m. There are sand layers at the top & bottom of soft clay layer. Determine the time of preloading to reach the degree of consolidation U₁ = 90%. = =
Calculate the geostatic stress at point A, the soil unit wieght is 18 kN/m3. 6 m 1.6 m 3 m •A 1.5 m PLAN 6 m Vertical load 50 kN/m2 3 m SECTION Select one: O a. 24 kN/m2 o b. 44 kN/m2 OC 54 kN/m2 o d. 45 kN/m2
The soil profile at a site consists of a 2.0 m thick sand layerat the top, underlain by a 3.0 m thick clay layer. The watertable lies at a depth of 1.0 m below the ground level. Thebulk and saturated unit weights of the sand are 16.0 kN/m3and 19.0 kN/m3, respectively. The properties of the clay are:water content = 45.0%, specific gravity of the soil grains =2.70, compression index = 0.65, swelling index = 0.08, andoverconsolidation ratio = 1.5.a. The ground level is raised by placing a 1.5 m high compactedfill with unit weight of 20.0 kN/m3. What is theconsolidation settlement?b. When the consolidation due to the fill is completed,it is proposed to construct a warehouse imposing a uniform pressure of 40.0 kN/m2. What would be theconsolidation settlement due to the construction of thewarehouse?
The soil profile at a road construction site is as shown in figure (not to scale). A large embankment is to be constructed at the site. The ground water table (GWT) is located at the surface of the clay layers, and the capillary rise in the sandy soil is negligible. The effective stress at the middle of the clay layer after the application of the embankment loading is 180 kN/m². Take unit weight of water, Yw = 9.81 kN/m3. Embankment load boudi Sand GWT 2m y = 18.5 kN° it enit Clay Specific gravity, G̟ = 2.65 Water content, w = 45% Compession index, C. = 0.25 6m %3D %3D Impermeable layer The primary consolidation settlement (in m, round off to two decimal places) of the clay layer resulting from this loading will be
Effective Stresses in Soil Problem 3. A 4m thick of clay is overlain by 4m thick of sand. The ground water table is 1m below the natural grade line. Clay and sand have saturated unit weights of 19.5 and 17.3 kn/m³ respectively. Sand above the water retains water content of 30%. LL and void ratio of clay are respectively 60% and 27.3%. Specific gravity of sand solid is 2.7. 1. Find the compression index. 2. Find the moist unit weight of sand above the water table. 3. Find the effective soil pressure at mid clay layer.
A 650-kN column load is supported on a 1.5 m wide by 2.0 m long by 0.5 m deep spread foot-ing. The soil below is a well-graded, normally consolidated sand with g = 18.0 kN/m3 and the following SPT N60 values:Depth (m) 1.0 2.0 3.0 4.0 5.0N60 12 13 13 8 22 The groundwater table is at a depth of 25 m. Compute settlement of the footing using the gen-eralized elastic method with Christian and Carrier’s (1978) influence factors.
3. Compute the effective vertical pressure at the mid height of the clay layer. Problem 3. A 4m thick of clay is overlain by 4m thick of sand. The ground water table is 1m below the natural grade line. Clay and sand have saturated unit weights of 19.5 and 173 kn/m respectively. Sand above the water retains water content of 30%. LL and void ratio of clay are respectively 60% and 27.3%. Specific gravity of sand solid is 2.7. 1. Find the compression index. Find the moist unit weight of sand above the water table. Find the effective soil pressure at mid clay layer. 2. 3.
A 4-meter clay layer (e = 0 96 Gs = 2.84, Cc = 0.329) is overlain with 3-meter-thick sand layer (e = 0.89, G = 2.73) The water table is at the interface of the sand and clay layer, If a 2-meter-thick land fill (y = 17.45 kN/m3) is placed over the existing ground surface, compute the consolidation settlement (in mm.) of the clay layer. Hint Use the land fill's resulting pressure on the ground surface as the stress increase Round off to two decimal places. Activate Windows. A Moving to another question will save this response. K Question 7 of 20 Go to Setting to activate ASUS W D B
(c) The soil profile at a site consists of 2 m of clay (G, = 2.7, e = 0.5) overlying a deep deposit of gravel (G, = 2.55, e = 1.0). If the water table is at the top of the clay, determine the depth at which the effective vertical stress is 100 kPa.