An industrial load consumes 10 kW at a power factor of 0.80 lagging from a 240-V, 60- Hz, single phase source. A bank of capacitors is connected in parallel to the load to raise the power factor to 0.95 lagging. . • Find the required reactive power in KVAR. Find the required capacitance of the capacitor bank in µF.

Q: Calculate the Period T and Frequency f.

A:

Q: Control system A/ Define following :- transfer function, transient response, and the type of the…

A:

Q: An industrial installation has a power factor of 0.85 in backward. The demand is 150 KVA, and the…

A: In the given questions we need to calculate the type of compensator, reactance of the compensator…

Q: An LED is to be connected into a 24-volt DC circuit. If the LED has a maximum current flow of 20 mA,…

A: In case of ideal led we can use Rs = Vs/If In case of practical diode Rs= Vs- Vf/If

Q: A sinusoidal AC voltage source has the equation, e=311sin377t, find the maimum voltage Rm, the RMS…

A: The solution is given below

Q: For the circuit  find the Thévenin equivalent withrespect to the terminals c,d

A: To calculate Thevenin equivalent impedance, short circuit the voltage source and assume a voltage…

Q: wire is carrying a direct current of 20 A and a sinusoidal alternating current of peak value 20 A.…

A:

Q: A sinusoidal voltage having a maximum amplitude of 625 V is applied to the terminals of a 50 n…

A: Average Value of a signal:  It's that steady state equivalent of a time varying signal which would…

Q: The sinusoidal current waveform having the maximum value of 10 A, then the R.M.S value is

A: The value of peak current is given as: I=10A The value of RMS current is given as: IRMS=I2

Q: An AC series circuit has R=300 ohms, L=0.90H, and C=2.0microfarad with a generator of 50V andw= 1000…

A:

Q: Find the DC value and RMS value from this image in below. , I want the solution in a detailed…

A: The RMS (Root Mean Square) value, also known as the effective or square root of the mean of the…

Q: A wire is carrying a direct current of 20 A and a sinusoidal alternating current of peak value 20 A.…

A:

Q: 1. How much value of capacitance should you place to correct the power factor of a load consisting…

A:

Q: A 480-V rms, 60 Hz source supplies a load having a total impedance of 50 angle 60° Q. Find the…

A:

Q: Calculate the current drawn from the source with and without the capacitor connected. Determine the…

A:

Q: 4. The AC generator in the circuit shown below supplies voltage with amplitude 5.0 V at frequency…

A: Given V=5 V f=336 Hz

Q: two devices are connected across a source where F= 60 Hz. If the 2 rms values of the voltage drops…

A: The solution is given below

Q: phase of 0 degrees, and its frequency is 5000 rad/s. a)Find VTH and ZTH for the thevenin equivalent…

A:

Q: For the below sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 0.2ms/cm and…

A: time division - time/cm=0.2ms/cm voltage division volt/cm=1V/cm

Q: Consider the sinusoidal given in the figure below, determine the amplitude, period, frequency and…

A:

Q: supplies

A:

Q: A harmonic analysis of the current drawn by a CFL yields the following data. Find the rms value of…

A: We have an data of CFL lamp with harmonics as shown in table and corresponding currents of that…

Q: 5. An impedance draws a current i(t) = 10sin(wt-30°) ampere from a voltage v(t) = 220cos(wt-65°)…

A: As per our company guidelines we are supposed to answer only first three subparts kindly repost the…

Q: The 60 Hz AC source and 240 V rms voltage provides a power of 5000 VA

A:

Q: An alternating current varying sinusoidally with a freq. of 50 c/s. has a r.m.s. value of 35 A.…

A:

Q: What is the value of form factor of sinusoidal voltage?

A: form factor is the ration of the rms value to the average value

Q: The maximum transferred average power to a load without restrictions calculated in terms of the RMS…

A:

Q: A 480-V rms source supplies a load that absorbs 100 kW at a 0.7 lagging power factor. A capacitor is…

A: The solution is given below

Q: 7 Find the average and effective values of voltage for sinusoidal waveform shown in Figure. Vm = 100…

A: Given Waveform in the question, Form the above figure, it can be observed that the waveform is an…

Q: volue of v(f' (c) A current flowing through a 52 resistor has a periodic waveform as shown in Figure…

A: The solution is given below

Q: What are the customary units for real power? For reactive power? For apparent power?

A: Given: To describe the customary units for real power is shown as:

Q: The average Power to the Plant n Figure 0.707 10gging. The generator is Sinu- in waveform with w-377…

A: In this question , we have to find the value of capacitance used to improve power factor....

Q: The rms value of the resultant current in a wire carries a dc current of 10 A and a sinusoidal…

A: Given- dc current- Id=10 A, ac current- Ia=20 A, To Find- The rms value of the resultant current…

Q: the waveforms in the same x-axis. Clearly indicating the peak value and the period of each waveform…

A:

Q: The total reactive power of an AC circuit having power factor of 0.85 leading is 40kVAR. The true…

A:

Q: A load is connected across a 25,000 Volts, 60 Hz source and draws a current of 90 A rms. If the…

A:

Q: When a load is connected to a power line with a frequency of 230V (rms) 50 Hz, it draws 4250 W of…

A: Given Vs=230V f=50Hz PL=4250 watt power factor,cosφ=0.85  → φ=31.78° So reactive power of load,…

Q: (b) An engineer is required to analyse a sinusoidal waveform for the voltage and current using…

A:

Q: An engineer is required to analyse a sinusoidal waveform for the voltage and current using…

A:

Q: For the next three items, consider a series R-L-C circuit energized by a sinusoidal voltage source…

A: In this question, we need to determine the phase angle between voltage and current. Also need to…

Q: 12.53 A capacitor and resistor in series have an impedance of 1.34/-45 k2 at 400 Hz. Find the…

A: Given data, A capacitor and a resistor are in series. The impedance is, Z=1.34∠-45° kΩ. Frequency,…

Single Phase Induction Motor

The single-phase induction motor or engine consists of a single rotating phase in the stator and a rotating cage in the rotor. When phase one supply is connected to the stator winding, a magnetic field is generated. In the pulsating field, the rotor does not rotate due to inertia. So, a single-phase import motor does not start and requires some initial methods.