An incompressible homogeneous fluid is flowing steadily in a variable diameter pipe having the large and small diameters as 15 cm and 5 cm, respectively. If the velocity at a section at the 15 cm diameter portion of the pipe is 2.5 m/s, the velocity of the fluid (in m/s) at a section falling in 5 cm portion of the pipe is

Q: Q4. B) Plotting the Energy Gradient Line (EGL) or Total Energy Line(TEL) and Hydraulic Grade Line…

A: Given, V1 = 36 ft/s  Hm = 0.25 ft

Q: In a stream line steady flow, two points A and B on a stream line are 1 m apart and the flow…

A: Distance s = 1 m, Velocity VA= 2 m/s, Velocity VB = 5 m/s, It is needed to find the acceleration of…

Q: Problem 5 Gasoline having a specific gravity of 0.8 is flowing in the pipe shown at a rate of 5…

A: Given that,Area at section 1 = 0.8 ft^2Area at section 2 = 0.2 ft^2Flow rate Q = 5 ft^3/sHead loss =…

Q: A venturimeter having diameter of 7.5 cm at the throat and 15 cm at the enlarged end is installed in…

A:

Q: The pressure in the outlet pipe from the reservoir is 61.3 kPa abs and h =15 m. Because of the…

A:

Q: As shown in the diagram, brine of specific gravity draining from the bottom of the large tank…

A: Given- 100 mm pipe Head h=20 m It is needed to find the velocity of flow along streamline at point…

Q: 3. If the velocity of flow in a 500mm diameter cast iron non- rigid pipe with modulus of elasticity…

A:

Q: A horizontal venturimeter with a 100 mm diameter throat section is used to measure the volume flow…

A:

Q: D₂ = 5 cm D3 = 6 cm D₁ = 4 cm The flow network carries the water at 20°C to exit pipe 4. The flow…

A:

Q: The pressure in a 3 cm diameter pipe is 400 kPa. What is the velocity of flow in the pipe

A:

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?