An impedance coil is connected in series

Q: The transient stability analysis should be performed based on which fault?

A: Transient stability analysis is used in the transfer function under various disturbances.

Q: A transformer is connected to a primary impedance of 2000 and a secondary impedance of 4500. The…

A: From given primary impedance and secondary impedance calculate turns ratio. Now , using turns ratio…

Q: 23. When the reactance of a series RC circuit increases, the current will a. increase b. decrease c.…

A: The reactance of the series RC circuit is increased.

Q: test is used to measure the iron losses of the transformer. A6

A: We need to tell about name of test which is used to measure iron losses.

Q: . Determine the equivalent impedance and the equivalent dmittance. 2n -j4n Zeg jion -jsn

A:

Q: 7- Determine the current direction in each of the following coils: TI S A S quib-

A: for the given coils that would around a iron bar it is asked to find the current direction

Q: In class A chopper with R-L load, the continuity of current increases as     duty cycle decreases…

A: Inductance has to be increased To increase the continuity of current the period of time should be…

Q: A transformer has a turn's ratio of 1:6. The primary current is 18A. What is the secondary current?…

A: Given data-Transformer turn's ratio is 1:6 that's mean.…

Q: Use 8x1 multiplexer to A'C' + BC + AC

A: Given:A boolean expression, F=A'C' + BC + AC,we need to implement: above boolean function using 8:1…

Q: Q2. A three phase full wave uncontrolled bridge rectifier has an AC input voltage of 90 V RMS at 60…

A: Given data, Supply RMS voltage Vr=90 V. Frequency f=60 Hz. Load resistance RL=440 Ω.

Q: When the turns ratio of a transformer is 20 and the primary ac voltage is 12 V, the secondary…

A: Given data: -Turns ratio n=20Primary voltage VP=12 VFind: -Secondary voltage VS

Q: A transformer with a 240-V ac primary voltage and a 6:1 turns ratio has an output voltage of O 1,440…

A:

Q: An RC series circuit is connected to a 277 volt 60Hz line. the apparent power of the ciruit is 8.2…

A:

Q: An AC series ciruit has an apparent power of 650 VA, and a true power of 475 watts. what is the…

A:

Q: bläi 5 When the number of poles increase then the electrical angle between the adjacent poles remain…

A:

Q: When a direct voltage of 90V is applied to a coil, 15A direct current flows from the source. When…

A: In d.c. analysis, under steady state condition a inductor will behave as SHORT circuit. The detailed…

Q: When the turns ratio of a transformer is 20 and the primary ac voltage is 12 V, the secondary…

A: The given data is shown below:

Q: Differential between the high temperature Low Sag Conductors and Convetional converters,

A: To differentiate  between the high temperature Low Sag Conductors and Conventional converters. The…

Q: In the case of wave winding, each-4 coil will have fewer turns (_ of thicker wire (higher current) W…

A: Wave winding

Q: True or False Salient pole generators rotate faster than other generators

A: Salient pole generators rotate faster than other generators. State true or false

Q: The following forward converter (for questions 8-12) has the following parameters. Vin=40V,…

A: Given Vin=40 VV0=10 VP0=50 WD=40%=0.4NP=16

Q: What frequency will be developed if the speed is 900 rpm

A:

Q: An alternating voltage Vp is applied to the primary coil of a step-up transformer having N turns on…

A:

Q: Delta to Wye Conversion with figure

A:

Q: What is the ignition phase R S T in each thyristorThree-phase AC voltage regulators delta connection…

A: We have to explain the ignition phase RST in each thyristor Three-phase AC voltage regulators delta…

Q: True or False Instrument transformers are used for extending the ranges of instruments in…

A: - There are two types of instrument transformers namely; current transformer and potential…

Q: The thickness of laminations used in a transformer is usually 0.4 mm to 0.5 mm O 14 mm to 15 mm O 25…

A:

Q: The open circuit voltage of a transformer is 242 V and its % regulation is 2%, then the value of…

A:

Q: The main purpose of using instrument transformers in AC measurement is to

A: Instrumentation transformer: The direct connection of AC ammeters ad Voltmeters can be avoided by…

Q: In this Design, the value of RB is determine +Vcc Relay coil 2₂ RB Intensity of illumination 2₁ Ο ΙΕ…

A: Consider the given diagram for the transistor with the photo-transistor.

Q: Shunt compensation can be installed near the Transmission Line Load Transformer Generator

A: In shunt compensation, these are connected in parallel with the power system transmission line. It…

Q: lary winding are 0.012 and 0.062 ected in delta and secondary in star

A:

Q: In Chopper operation lo is negative, the direction of power flow will be from to

A: Ans. load to source

Q: ex>A platinum-coil has aresistance of and 3.767 3-1462at 4o°c at 100°c find Rot and Ku? 40

A: The detailed solution is provided below.

Q: Is it possible to have 13 in the opposite direction of wha

A:

Q: A voltage of 100VAC is shown on the oscilloscope. What is the peak to peak voltage?

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: The application of shunt capacitor is high at the following transmission system substation buses…

A: In this question we will write application of shunt capacitor is high at which place....

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.