A transformer is connected to a primary impedance of 2000 and a secondary impedance of 4500. The primary current is 600mA RMS. Calculate the magnitude of the secondary current. O 1.2A O 400mA O 2.5A O 100mA

Q: QUESTION 3 An inductor and a 330 ohm resistor are connected in series with a function generator. The…

A:

Q: 6. What is the effect of load inductance on the ripple current? 7. effect of chonnine

A: Effects of load Inductance on ripple current :

Q: The open circuit characteristics (O.C.C) of an alternator is drawn between O Eo V/S Ir O E, V/S Isc…

A: To find open circuit characteristics, the Terminal voltage of the alternator is open-circuited or…

Q: QUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function…

A:

Q: For the following circuit if the secondary voltage of the transformer is 20V rms, the output voltage…

A:

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: For the given data to limit 20Vrm

Q: A supply of 240V-50HZ feeds a highly inductive load of 502 througlH thyristor bridge that is…

A: The solution can be achieved as follows.

Q: Value of series impedance if inductance is 4mH , resistance is 40 ohm and frequency is 50 Hz.

A: Given values are =

Q: For the following circuit if the secondary voltage of the transformer is 20V rms, the PIV of the…

A:

Q: For the following circuit if the secondary voltage of the transformer is 20V rms, the output voltage…

A: Answer: 113.1 V (option-3)

Q: 10. Determine the peak-to-peak ripple and de output voltages in Figure 5. The transformer has a 36 V…

A: The full-wave bridge rectifier circuit is shown below:  The output voltage across the bridge…

Q: e input voltage to chopper circuit with a switching frequency of 100 Hz and Ton time as 2.0 ms is 10…

A: Given a chopper circuit having, Input voltage, Vs=10 V Switching frequency, f = 100 Hz On time,…

Q: • Show the voltage waveforms across each half of the secondary winding and across RL. Find the…

A:

Q: QUESTION 19 E-06, PC-02. Three inductors 15 mH, 15 mH and 15 mH are connected in series. What is the…

A:

Q: For the following voltage and current waveforms, the length of the current waveform parts are equal.…

A:

Q: A step up chopper has input voltage 110 V and output voltage 150 V. The value of duty cycle is.

A: Given a step up chopper with, Input voltage, Vin=110 V. Output voltage, Vout=150 V. Duty cycle, α=?

Q: For the following circuit if the secondary voltage of the transformer is 20V rms, the output voltage…

A: We need to find output voltage for given circuit

Q: foruier transform

A: a   x1t=e-at               =e-atut+eatu-tand we know,e-atut→FT 1a+jωHere,x1t=e-atut+eatu-t   →FT…

Q: The voltmeters in the figure measure RMS voltages. If V1 = 13 V and V2 = 3.5V what is V3? R L VI V2

A:

Q: QUESTION 16 E-06, PC-02. Three inductors 15 mH, 15 mH and 15 mH are connected in parallel. What is…

A:

Q: The complex volt amperes in a series circuit are (4300- j2500) and the current is (25+j43.3)A.Find…

A:

Q: • Show the voltage waveforms across each half of the secondary winding and across RL. • Find the…

A: In a full wave rectifier average output voltage is defined as, Vavg=2Vmπ Turns ratio and voltage in…

Q: Question 3 To reduce the power consumption, the capacitors should be located Complete Marked out of…

A: Answer 3: Locating capacitor as close as possible to the Load end will help to reduce losses within…

Q: The open circuit voltage of a transformer is 242 V and its % regulation is 2%, then the value of…

A:

Q: The primary and secondary coils of a transformer each have an inductance of 200 x 10-6 H. The mutual…

A: Given, Primary and secondary inductance of coil, LP=LS=200×10-6 H Mutual inductance between winding,…

Q: For the circuit shown the RMS ratting current of the Thyristor greater or Firing angle=50 Degree 1:2…

A: This is centre tap full wave Rectifier.  Find the rms value ?

Q: Value of series impedance if inductance is 5mH , resistance is 4 ohm and frequency is 50 Hz.

A: Given values are =

Q: The conversion of an AC to DC Source is by using the A) Commulator B) None of these C Round ring…

A: The commutator is used in the DC generator to convert the AC voltage into a DC voltage.

Q: The peak voltage for a 60 Hz sinewave with rms voltage of 208 V is: O 507 V 145 V 294 V O703 V

A: Given: RMS voltage, Vrms=208 V. Frequency, f=60 Hz. Peak voltage, Vm=?

Q: Q6) The waveform of the voltage obtained after rectification is of a -----nature and therefore…

A: AC signal has both positive and negative half cycle where as dc has only positive voltages.…

Q: A transformer is connected to a primary impedance of 2kQ and a secondary impedance of 1000. The…

A: We need to find out current on secondary side of transformer.

Q: A transformer with a primary voltage V = 15/15° V has a turns ratio of 1: 5. What is the secondary…

A: In this question , transformer primary voltage is given...We have to find transformer secondary…

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.