An energy meter measure the amount of power consumed by the load with respect to time. It is connected to a load of 20A, 230V at 0.55 power factor for an hour which rotates 325 revoluation for an one unit of energy. If so, calculate the revolutions made by the meter. O a. 822.25 O b. 850.25 O C 810.25 O d. 800.25

An energy meter measure the amount of power consumed by the load with respect to time. It is connected to a load of 20A, 230V at 0.55 power factor for an hour which rotates 325 revoluation for an one unit of energy. If so, calculate the revolutions made by the meter. O a. 822.25 O b. 850.25 O C 810.25 O d. 800.25

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

6. If the rms current through a 4.7 kn resistor is 4 mA, the peak voltage drop across the resistor is A. 4 V B. 18.8 V C. 26.6 V D. 2.66 V
... 0.25 A 120 V 60 Hz RL 1 k2 470 µF When the circuit is working normally, it has an rms secondary voltage of 12.49 volts. Considering the ripple voltage, what is thnimum dc load voltage?
Determine the value of Voltage Vs. 1:0.3 120 V 10 2 Vs 2) RMS O A. 418 Volts RMS O B. 612 Volts RMS O C. 324 Volts RMS O D. 198 Volts RMS O E. 236 Volts RMS
An alternator is generating power at 210 V per phase while running at 1600 rpm. If the speed of the alternator drops to 1200 rpm, the generated voltage per phase will be a. 180 b. 157.5 c. 150 d. 102.5
One single page energy meter operating on 230 Volt and 5 ampere for 5 hours makes 1940 revolutions. Meter constant is 400 revolution per kWh. The power factor of the load will be?
The RMS current through a 10 kO resistor is 5 mA. What is the RMS voltage drop across the resistor?
Solve the current's magnitude and angle. Note: Do not round off until final answer and round off the final answer to five decimal places.
For the waveform as shown in the figure 2, If the average voltage is 60.679 volt, Find the value of a, then determine the RMS voltage of the waveform. 10 0 a 90 180 270 360 a +360 450 540 alpha (degree) Voltage (Volt)
The graph below shows a voltage signal as a function of time. The dc voltage is 0. t1 = 39ms and t2 = 91ms. Determine the phase of the signal. Enter your answer in degrees rounded to one decimal place. If the answer is negative, be sure to include a minus sign.
Solve for 20 V rms supply. Thank you.