An automated blanking and forming line is designed to from 2 mm thick sheet, made from 2024 Aluminum, T4 temper, into a square sheet metal part. Elongation at 50mm 20% Young’s Modulus 70GPa Yield strength 325 MPa UTS 470 A) What is the force required to punch a square piece that is 500 mm on each edge? B) If the sheet blank was bent to a radius of 5 mm, what will be the radius after springback occurs? C) What is the required bend angle to achieve a 90° final bend angel for a bend radius of 5 mm?

Q: Rolling: A rolling operation is performed on a 5 mm thick sheet of low carbon steel (K=530, n=0.26…

A: Given:To find:

Q: c) A punch must cut a hole 30 mm diameter in a sheet of steel 4 mm thick. The ultimate shear stress…

A: Calculated force required.

Q: Which of the following stress or .10 strength parameters is used in the computation of the force in…

A:

Q: Please answer all parts

A: The Initial height of the cylinder is : H = 35.5 mm The force required to perform the operation is F…

Q: 23) The example for forming process is ___________. a. Extrusion b. Tempering c. Die Casting d. Gas…

A: Forming is a manufacturing process by which metal parts are converted into products through…

Q: 5. Consider forging a 2024 aluminum slab from the initial and final "brick" shapes shown below. The…

A: For the solution refer below images.

Metrology of surface finish

In general terms, the application of scientific principles in the study of measurements is known as metrology. When speaking about measurement, it could be of time, length, microstructures, grain structures, internal crystal discontinuities, surface roughness, measurements of angles, height, width, and so on. While coming to the domain of mechanical engineering, metrology is considered the science of measurements of surface finish, length, surface texture, and angles.