An analog signal in the range 5V to 10V is to be converted to a digital signal with a quantization error of less than or equal to 0.391% for midtreadquantization. The quantization error is the maximum error occur after quantizing the analog signal.What is the required number of bits for this?SubmitYou have used 0 of 3 attemptsSaveVg =-5 Vwwos, R, = 20 k£NR2 = 40 k£2os, R3 = 80 k£2oS, R4 = 160 k£2What is the output voltage of the 4-bit weighted-resistor D/A in the above if the input is 0101? Assume Rp= 10KNWhat is the output v, in V?What is the maximum allowed tolerance (±percent) in the value of R so that the maximum error in the output is limited to +LSBquantized voltagevalue?SubmitYou have used 0 of 3 attemptsSaveans 123

In the first question we know that quantization error is half of the step size. With the help of…

An analog signal in the range 5V to 10V is to be converted to a digital signal with a quantization error of less than or equal to 0.391% for midtread quantization. The quantization error is the maximum error occur after quantizing the analog signal. What is the required number of bits for this? Submit You have used 0 of 3 attempts Save

An analog signal in the range 5V to 10V is to be converted to a digital signal with a quantization error of less than or equal to 0.391% for midtread quantization. The quantization error is the maximum error occur after quantizing the analog signal. What is the required number of bits for this? Submit You have used 0 of 3 attempts Save

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

The modulation techniques used to convert analog signal into digital signal are a. Pulse code modulation b. Delta modulation c. Adaptive delta modulation d. All of the above
The resolution of the ADC unit with the reference voltage value of 3V is set to 8 bits. If the voltage level applied to the ADC input is 1.67 V, what is the numerical value read? For numbers with commas, take 4 digits after commas.?
Convert the value to binary(10011001001.00100101)BCD
An analog signal is to be coded by an ADC. The signal contains significant frequencies up to 6MHz. The quantization error in any one sample value must be within ± 0.5% of the peak-to- peak amplitude range of the ADC. How many binary digits must each sample contain?
The modulation techniques used to convert analog signal into digital signal are a. Pulse code modulation b. Delta modulation c. Adaptive delta modulation d. All of the above
Write a note on digital signal.
[0 5] the signal in the volt range will be quantified. since n=4; a)Calculate what is the number of Qunta levels? b) Calculate what is the quantization interval? c)V=3.2 volts rounded to what quantization level? Let's draw with Quantalama level chart
Q1. Write the data (10010000)Gray in BCD code.
5- Discuss the effect of changing the number of bits on the recovered analog waveform. 6- Discuss the effect of changing the frequency of input analog signal on the reconstructed analog output signal.
There exists one or more discrete ime signal. What is it control system ? (a) discrete time or (b) continuous time
The need to use forward error control is to
digital signal processor