An aluminum hollow shaft 200 mm outside diameter, 100 mm inside diameter and 500 mm length from lathe chuck is to be face turned at end. Its end face is finished at rotational speed of 400 rpm using feed rate of 0.25 mm/rev. The side cutting edge angle or lead angle of the tool is 300. How much cutting time and maximum power is needed to finish the facing operation with 4 mm depth of cut. What is likely to be a perpendicularity error in this operation? Specific cutting energy kN = 0.025 W / mm3 (min and E = 50 %3D

An aluminum hollow shaft 200 mm outside diameter, 100 mm inside diameter and 500 mm length from lathe chuck is to be face turned at end. Its end face is finished at rotational speed of 400 rpm using feed rate of 0.25 mm/rev. The side cutting edge angle or lead angle of the tool is 300. How much cutting time and maximum power is needed to finish the facing operation with 4 mm depth of cut. What is likely to be a perpendicularity error in this operation? Specific cutting energy kN = 0.025 W / mm3 (min and E = 50 %3D

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

a. What is the elevation of liquid on end A? b. What is the elevation of liquid on end B? c. What is the elevation of liquid on end C? d. What is the elevation of liquid on end D? dont round off the values if its not the final answer. three decimal on the final answer thank you
Build the following part. Report the mass in pounds. Assume all dimensions are in inches. The material is Vanadium. (Located in the "Other Metals" folder in the material properties.) A = 1.72 B = 1.4 2.40 1.20 T .75 TYP 1.20 TYP .70 -1.00 TYP A A A+3.25 R.35 TYP -R.65 TYP CBORE FOR 5/16 HEX HEAD BOLT Ø.332 THRU ALL LØ813 V 235 .10- SECTION A-A 23. B B+1
how did it become 0.1077?
2. Given tungsten, steel, rubber, and aluminum, rank in decreasing manner by the amount of fractional increase in length under increasing tensile stress.
Hi, Could you please help with this question, if you need to take more credits then please feel free. showing working out if possible too please, Thank you
Please answer immediately thank youuuu
Fast plzz
I need the answer as soon as possible
In the last few steps, where did 0.4 come from?
Q6 Each cylinder of six cylinder internal combustion engine has a diameter of 60 mm and a stroke length of 400 mm. What is the engine capacity in litres? Give your answer to 2 decimal places.
Choose the correct answer below and show your solution completely. Make sure that your finals answer is 4 decimal places.