An aluminium cylınder has, a diarneter 07 4aƏ 4.80 cmo It has been hammered into a woll be and its length, nhych seen From Hthe wall can is So30 cm's An objest with a mass 071.20 X10kg objest with hung From the eoge the cylinder I7 the IS 07 er is nighgible ) Calcylate the shear stress on the cylınder (b) (alculate the vestical dealection o7the edge of mass o7 the cylinderis nigligable and the shear modulus 07 aluminium iŠ 3.0xlo NIm2 I5 3.0X10 he cylnder

Q: What is the indentation diagonal length in in, when a load of 0.60 kg produces a Vickers HV of 400?

A:

Q: A metallic bar of cross-section Ao = 103 mm² and length Lo = 0.1 mm, is subjected to = 1600 N, the…

A: Given: The cross section area of the metallic bar is 103 mm2.            The original length of the…

Q: force of 4.5N. calculate the pressure exerted by the pin on the board if the area of contact of the…

A: Solution:We know that:Pressure=ForceArea⇒P = FAApplying vlues we get:⇒P=4.5 N1.8×10-7 m2⇒P=2.5×107 W…

Q: Pls help ASAP

A: Concept: There are three forces that act on the jumper while bungee jumping they are, Force due to…

Q: A hollow, circular aluminum cylinder has been cut in half as shown below. The temperature at the…

A:

Q: 4. A single axial load of P = 60 kN is attached at the end C of the brass rod ABC. Knowing that E =…

A:

Q: A copper wire 4 m long has diameter of 1 mm, if a load of 10 kg. wt is attached at other end. What…

A: To find-(a) extension (l)=?(b) Lateral compression=?Given data-Length of wire (L)=4 mDiameter (D)=1…

Q: Suppose a 3.00N force can rupture an eardrum. If the eardrum has an area of 1.00cm², calculate the…

A: force = F = 3 N area = A = 1 X 10-4 m2 depth = h = ?

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).