An alternating current is represented by the equation: i(t) = 150sin 628t Calculate; 1.The frequency, 2.The period, 3.The ratio of the rms value to the average value, 4. The time taken from t = 0 with the function rising positively to reach a magnitude of + 100 A for the second and fifth time 5. The time taken from t = 0 with the function rising positively to reach a magnitude of - 100 A for the first time

An alternating current is represented by the equation: i(t) = 150sin 628t Calculate; 1.The frequency, 2.The period, 3.The ratio of the rms value to the average value, 4. The time taken from t = 0 with the function rising positively to reach a magnitude of + 100 A for the second and fifth time 5. The time taken from t = 0 with the function rising positively to reach a magnitude of - 100 A for the first time

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

a) Write down the expression of instantaneous voltage for an AC voltage having a Peak value of 220 Volts and a frequency of 50 Hz provided at time t=0, the instantaneous voltage is 220 Volts. What is the instantaneous voltage of the source at time “t = 5 seconds” What is its RMS voltage? b) Two 200Ω resistances are connected in series with one 0.5 H Inductance and two 100μF Capacitance with the power supply of part (a). (i)Draw the circuit diagram of the above network (ii)What is the total impedance of the circuit (iii)What is the max current that flows through the Inductance? (iv)What is the max current that flows through each of the Capacitance? (v)What is the power dissipated in the circuit (vi)What is the power factor of the circuit (vii)What is the resonance frequency of the circuit? (viii) What is the maximum power dissipated by the circuit when it is in resonance
Solve for the following problems. Round off your answers to 2 decimal places. Show your complete solution.
Determine the RMS Noise Voltage when the noise readings measured at several times has these values: 25mV= 2 times, -22mV = 3 times, 10mV and - 72mV = 8 times.
A current wave consists of two components 1. A DC current of 10A and 2. A sinusoidal AC current of peak value 5A and frequency 50Hz a. Write the expression of the current wave taking t=o at an instant where the AC component is ZERO and increasing in positive direction b. Find the average value of the current wave. c. Find the RMS value of the current wave.
Find the RMS value of the waveform depicted below. Given A = 5, a = 2, b = 7, and T = 10 Hint: You will probably want to express the waveform as a piecewise function. A 0 t=a t=b a+b T 2T V t
The rms current in a 33.0-0 resistor connected to an AC source is 2.80 A. (a) What is the rms voltage across this resistor? V (b) What is the peak voltage of the AC source? V (c) What is the average power dissipated by the resistor? W (d) What is the maximum current across this resistor? A
Show the steps
3 An alternating voltage is given by v= 75 (sin_200nt - 0.25) volts. Find: (a) The amplitude (b) The peak-to-peak value (c) The rms value (d) The periodic time
Determine: (i) Average Value, (ii) RMS value, (iii) Form factor, and, (iv) Peak factor for the following waveform i(1) A 1012 10 0 1 2 3 4 5
Find the rms value of the periodic function described in figure below. Assume that Vi= 2 mV, V2= 4 mV, V3= 6 mV, and va= 8 mV. v (V), V3 V2 TO T5 20 25 30 35 40 45 I (ms) - V2 - V3 V4 1 cycle www
The equation of alternating voltage isgiven by ν = 325.22 ???314?.Find (i) RMS value (ii) Frequency (iii)Average value.
Find the RMS value of the waveform depicted below. Given A = 5, a = 2, b = 6, and T = 13 Hint: You will probably want to express the waveform as a piecewise function. A www a+b T 2T t=a t=b 0 t