An 8 x 8 port multimode fiber reflective star coupler has - 8.0 dBm of optical power launched into a single port. The average measured optical power at each output port is - 22.8 dBm. Obtain the excess loss for the device and hence the total loss experienced by an optical signal in transmission through the coupler. B-

An 8 x 8 port multimode fiber reflective star coupler has - 8.0 dBm of optical power launched into a single port. The average measured optical power at each output port is - 22.8 dBm. Obtain the excess loss for the device and hence the total loss experienced by an optical signal in transmission through the coupler. B-

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

To put it another way: A BTS broadcasting information with 10 W of output power at 1800 MHz can only cover half the area as a BTS transmitting at 900 MHz. Describe the benefits and drawbacks of using the 1800 MHz BTS to cover the same area as the 900 MHz BTS.
7. Describe the operation principle of the MOSFETS-based digital gate shown in Figure 3. In your answer, explain the need to use n-channel and p-channel MOSFETS for such digital gates. VDD Figure 3 8. A particular optical waveguide is made from silicon with an air upper cladding and oxide lower cladding. The measured effective index of the waveguide at 1300 nm is 2.2 and the measured effective index at 1550 nm is 2.0. (a) Assuming a linear relationship between wavelength and effective index in the form of
3. Category 5 cable, commonly referred to as CAT-5, is a twisted pair cable for computer networks. The cable standard provides performance of up to 100 MHz. We would like to transmit information over a CAT-5 twisted pair cable at 500 megabits per second (Mbps). (a) Is a signal-to-noise ratio (SNR) of 30 dB adequate to transmit 500 Mbps? (b) What is the SNR required to just adequately transmit at 500 Mbps? Express your answer in decibels for the SNR
State and explain with diagram and reasons how the GaN LNA Receiver design can be modified with Network Traps to avoid bits of signal power loss and removing undesired harmonics of radiated signals in the Transceiver of figure 1 which finds use in several Giga Hertz Frequency for wireless communication applications.
5. A 20 kHz sine wave signal with amplitude = 5V, amplitude modulates a 10 MHz carrier wave with amplitude = 10V. Find the USB and LSB frequencies produced, Draw the frequency spectrum of the AM wave and mark all details with frequencies and amplitudes.