alternator is protected by balanced system has its neutral grounded through a resistance of 12 Ohm. The protective relay is set to operate when there is an out of balance current of 0.6 A in the pilot wires which are connected to the secondary of current transformer of ratio 800/5. Calculate: A- The percentage of protected winding -B- The resistance required to decrease the unprotected percentage by 15%.

alternator is protected by balanced system has its neutral grounded through a resistance of 12 Ohm. The protective relay is set to operate when there is an out of balance current of 0.6 A in the pilot wires which are connected to the secondary of current transformer of ratio 800/5. Calculate: A- The percentage of protected winding -B- The resistance required to decrease the unprotected percentage by 15%.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 100-KVA, 230-V/115-V, 60-Hz transformer was tested with the following results: Short-circuit test: 9.5 V, 326 A, 1200 W Open-circuit test: 115 V, 16.3 A, 1500 W Determine the KVA load at maximum efficiency and and the maximum efficiency at 0.8 power factor lagging.
Alternator voltage regulation is ............... % *
Which of the following is the range of excitating current (in percent) of its rated current for a small distribution transformer? 25 Equal to rated current 6 None of option OO0O
Find the elements of the equivalent circuit attributed to the secondary of a single-phase transformer. The no-load voltages in the primary and secondary circuit are 200 volts and 400 volts, respectively, with a frequency of 50 Hz. The primary no-load current at the voltage of 200 volts is 0.7 amperes and the loss of the core is equal to 70 watts. The resistance and reactance of the primary are 3.2 ohms and 1.25 ohms, respectively. The resistance and reactance of the secondary are 0.6 ohm and 0.07 ohm, respectively. Draw the equivalent circle, showing the values of its elements.
Laminated insulations coated with varnish are normally used in the transformer? A. to reduce reluctance of magnetic path B. to reduce the effect of eddy current C. to increase the reluctance of magnetic path D. to reduce the hysteresis effect
1) A 12 kVA, 4400V/230V, 50 Hz single-phase transformer has 150 secondary turns. Determine (a) the primary and secondary current,(b) the number of primary turns, and (c) the maximum value of the flux.
(b) A 100 kVA, 1000 V / 300 V, 50 Hz, single-phase transformer has an iron loss of 550 W and a full – load copper loss of 1400 W. Calculate its efficiency for a full load at 0.85 power factor. It has a secondary terminal voltage of 260 volts when loaded. Determine the regulation of the transformer.
Three 60-VA, 120/208-V, single-phase transformers are to be used to form a three-phase transformer. For each of the four connections. Determine: (a) phase voltages, (b) phase currents, (c) a-ratio (d) power rating.