Calculate the power in the compressor, W(kW)Calculate the power-heat in the exchanger, Q(kW)Calculate the power in the turbine, W(kW) An open gas turbine cycle operates on air according to the sketch below:(2)P=3.7 atmT-430 KH2-431.43 kJ/kgZ2-20 mu2= 600 m/sCompressor(1)P=1 atmT-300 KH1-300 kJ/kgZI=10 mul= 200 m/sWHeat ExchangerQ(3)P=3.7 atmT-820 KH3-843.98 kJ/kg23-20 mu3=600 m/sTurbineP-1 atmT=570 KH4-575.59 kJ/kg24-10 mu4- 300 m/sThe compressor and the turbine are both frictionless and adiabatic. The flow process througheither of them may be considered reversible. Assume the air behaves as an ideal gas with constantspecific heat and Cp-1.004 kJ/kg*K.

Answered: alculate the power in the compressor,…

alculate the power in the compressor, W(kW) Calculate the power-heat in the exchanger, Q(kW) Calculate the power in the turbine, W(kW)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

3. The power output is 30 hp to a centrifugal pump that is discharging 900 GPM at which operates at 180 rpm against a head 120 ft., 220Volts, 3 phase, 60Hz. If the pump is modified to operate at 120 rpm, assuming its efficiency is constant, determine the discharge in GPM, the theoretical head it imparts to the liquid and the power input to the pump 4. A fan is used to provide ventilation in a tunnel requires a 3-kW electric motor to deliver 360 m³/hr. at a static pressure of 300mm of water has operated at speed of 500 rpm. It was later found out that the air to be delivered needs to be increased to a 420 m³/hr. If the fan size remains constant find the pressure in meters of water.
Q3: A distillation column is separating acetone(more volatile component) from ethanol. As pictured, there are two feeds with flow rates F₁=100 mol/hr and F₂-200 mol/hr. Feed 1 has z₁-0.7 and is saturated liquid. Feed 2 has z2 0.4 and is a superheated vapor (q=-0.1) where approximately 1 mol of liquid will vaporize on feed stage for each 10 mol of feed. We desired xd-0.95 and xw-0.05. How many stages are needed to achieve this separation? Ln/Vn=0.64.
Cn yu do question 6
The air entering the turbine with 1200 K and 1200 kPa expands to 100 kPa pressure in two stages. When the air is reintroduced to 1200 K at a constant reheat pressure of 350 kPa and both expansion stages are ideally realized: a) Total expansion work (kJ/kg) b) Intermediate heating amount (kJ/kg) c) Calculate the rate of increase in work according to the stepless (without reheating) expansion. Features for air: k=1,4, R=0,287 Jkg K,F1,005 klkg K k = 1.4 R = 0.287 kJ/kgK Cp = 1.005 kJ/kgK %3D
a.) What are the different types of fans used in air-conditioning systems? Discuss their applications and relative advantages and disadvantages. b.) Air from an air-conditioned room is exhausted into atmosphere through a grill. The quantity of air passes through the grill is 20 cubic meter minute. The duct area leading to the grill is 0.12 m2. The static pressure behind the grill is 3 mm of water. Find the effective area of grill exhausting the air into atmosphere. Take the pressure loss passing through the grill as 0.5 mm of water. Solve both a and b Asap please , I will rate
A) A large Francis turbine having the following specification: diameter of runner outside (1.5m) and runner width (0.135m). The turbine produce (16 MWatt) below the height of 260m at rotation speed (600 r.p.m). If the discharge is (7m/s) and flow velocity at the end of draft tube is (16 m/s). Taking zero velocity of whirl at outside and blade thickness approach to zero. Find the overall and hydraulic efficiency, although find the angles between velocity of runner, relative velocity and velocity of flow.
The figure below depicts a water supply pump drawing from a reservior. Water is withdrawn from the reservoir with water surface elevation of 200-feet (Point #1 in the figure), by a pump whose inlet eye (Point #2 in the figure) is located 6-feet above the water surface elevation. The reservoir water temperature is 80° F, and the pump delivers 2 cubic feet per second of water from a steel inlet pipe 8 inches in diameter. What is the Net Positive Suction Head available for the condition just described. 1
A pump operates at 600 W, the mass flow rate of the liquid is 1 kg/s, at the inlet the fluid is stagnate, and velocity at exit is 12 m/s, the mechanical efficiency of the pump is: Select one: a. 0.90 O b. 0.91 O c. 0.92 O d. 0.89 e. none of the mentioned
Can yu do question 2
8. A turbine passes 67.5 kg/h of steam at 200 km/h at 8 MPa and leaves at 0.5 MPa as wet steam with a speed of 90 km/h and a specific volume of 0.189 m3/kg. d. What must be the steam input conditions (T,H) to turn on a device that consumes 30 kW? and. What is the mass and volumetric flow rate of the water at the outlet? F. What is the input and output area?
For the purpose of acting as an air-cooled water chiller, an ammonia refrigerant vapor compression system is deployed. It is functioning with an evaporator temperature of 0 degrees Celsius and a condenser temperature of 40 degrees Celsius. The refrigeration produced by the system is equal to 15 tons.Find out: a. The temperature of the discharge and the mass flow rate of the refrigerant that is being circulated.b. The piston displacement that can be considered theoretical for the compressor.c. The work that can be done by the theoretical compressor.d. The heat that is not allowed to escape through the condenser.e. The Carnot coefficient of performance and the actual COP of the cycle.f. The volume of air that is supplied in the condenser if the air comes in at 30 degrees Celsius and exits at 34 degrees Celsius.g. The LMTD and AMTD of the condenser h. The water flow rate of the chiller assuming that the water enters the evaporator at 10 degrees Celsius and exits at 5 degrees Celsiusi. The…
Explain two types of turbine which depend on the action of water on the moving blades.