Air T 535°R c= 0.240 Btu/lb-°R Saturated liquid R-134a Tз, тз Wey = -0.2 hp Fan cv Throttling valve 4 5 Saturated vapor P5 P4 P4=60 lbf/in. 2 T2=528°R 2 Heat exchanger

Q: The expansion phase of a simplified diesel cycle is simulated by an air-filled piston-cylinder…

A: Given Data: The polytropic expansion constant is, n=1.4. The initial temperature is,…

Q: Enthalpy change of Nitrogen from inlet to the compressor and exit from Heat exchanger, ( ℎ1-ℎ3) in…

A: Given: Power consumed by compressor P = 50kW. Mass flow rate of nitrogen is m=0.25kg/s We know that,…

Q: An oil pump operating at steady state delivers oil at a rate of 11 lb/s through a 1-in-diameter exit…

A:

Q: A radiator by steam is used to heat a closed room. Heat is lost from the room to the outside at a…

A: The outside temperature of room is The dimension of room are The temperature inside the room is The…

Q: The figure belows shows three components of an air-conditioning system, where T3 = 95°F and m3 = 3…

A:

Q: Referring to the reversible heat pump cycle shown in the figure, p₁ = 14.7 lby/in². pa=34.7 lb/in².…

A:

Q: Assume 9.84 lb/sec of fluid enter a steady-state, steady-flow system with P₁ = 107.18 psia, p₁ =…

A:

Q: Steady-state operating data are shown in the figure for an open feedwater heater. Heat transfer from…

A: The ratio of the incoming masses and the rate of exergy destruction. Given: The ambient temperature…

Q: 1.1 Determine the electrical power supplied to a boiler when the temperature of the entering water…

A: Consider the following diagram for the boiler system, the heat input is Ql and heat loss from the…

Q: An oil pump operating at steady state delivers oil at a rate of 10 lb/s through a 1-in.-diameter…

A: All pumps are moving a liquid using basic forces of nature. The air is pushed out of the way when…

Q: The relation Δu = cv ΔT is valid for any kind of process, constant-volume or not.

A: Given data: *The initial temperature of the first system is T1i=20°. *The final temperature of the…

Q: Krypton in a closed system is compressed adiabatically from 94 K and 1 bar to a final pressure of 24…

A: Given: initial temperature→T1=94 K Initial pressure→P1=1 bar Final pressure→P2=24 bar Krypton is…

Q: Q1: 0.09 m³ of a fluid at 0.7 bar are compressed reversibly to a pressure of 3.5 bar according to a…

A: Assumption: Considering that the fluid to be Ideal gas. Given: A cyclic process 1-2-3-1: The…

Q: 1. As shown in the following figure, a diffuser has one inlet (i) and one outlet (e). Liquid water…

A:

Q: 4. Considering the Typical Energy Balance for gasoline engine, @ atmospheric condition of 1.013 bar…

A: Introduction: A four-stroke engine sometimes known as a four-cycle engine is a type of internal…

Q: 1. A tank containing 250 kg of kerosene is to be heated from 20°C to 40 °C in 15 minutes, using 4…

A: “Since you have asked multiple question, we will solve the first question for you. If youwant any…

Q: Sketch the cycle on ap−vdiagram. Considering a mass of air ofm= 0.5 kg, andassuming air as ideal…

A:

Q: Assume 2.30 lb/sec of fluid enter a steady-state, steady-flow system with P₁ = 105.73 psia, P1 =…

A:

Q: As shown in the figure, Refrigerant 22 enters the compressor of an air conditioning unit operating…

A:

Q: In adiabatic process, the system has Q=max. value O W=0 O U=0 O O Q = 0

A: The adiabatic process is the process main process of the thermodynamics. It is the process in which…

Q: 7. Through an isentropic process, a piston compresses 2 kg of an ideal gas at 150 kpa and 35 °C in a…

A:

Q: Assume 9.42 lb/sec of fluid enter a steady-state, steady-flow system with P₁ = 108.38 psia p₁ =…

A:

Q: Please state the assumptions and tables.

A: From first law of thermodynamics:∫δQ=∫ δW⇒QH.-QL.=W.where,QH.=Heat associated with high temperature…

Q: Figure P4.15 provides steady-state data for air flowing through a rectangular duct. Assuming ideal…

A:

Q: Air occupies a 0.5-m' tank. It starts at a pressure of 5 bar and a temperature of 300 K. Energy…

A:

Q: 1-2: 0.2 kg heating at constant pressure 1.05 bar at specific volume 0.1 m3/kg and work done -515 J.…

A:

Q: The figure belows shows three components of an air-conditioning system, where T3 = 105°F and m3 =…

A:

Q: One cubic meter of oxygen at initial pressure of 1 bar and a temperature of 17°C are compressed…

A:

Q: THERMODYNAMICS UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS. NO LONG EXPLANATION…

A:

Q: Air flows through a pipe. The inlet diameter is 0.3 m. At the inlet, the pressure is 2 MPa and the…

A:

Q: A pump is used to circulate hot water in a home heating system. Water enters the well-insulated pump…

A: Ans:- [ 0.6006 ] °R

Q: Develop the general energy balance applied to closed systems

A: The general energy balance for a closed system can be developed by using the conservation of energy.…

Q: Steam enters a turbine with a pressure of 30 bar, a temperature of 440 C, and velocity of 160 m/s.…

A: Note: As per our guidelines we are supposed to answer only the first 3 sub-parts. Kindly repost…

Q: Steam enters a turbine operating at steady state at 700°F and 450 lbf/in² and leaves as a saturated…

A:

Q: Assume 8.72 lb/sec of fluid enter a steady-state, steady-flow system with P1= 92.98 psia, ρ1 = 0.338…

A:

Q: Separate streams of air and water flow through the compressor and heat exchanger arrangement shown…

A:

Q: Q1: The gases in the cylinder of an internal combustion engine have a specific internal energy of…

A: Step by step solution is given below

Q: The figure belows shows three components of an air-conditioning system, where T3 = 95°F and m3 = 4.5…

A: mass flow rate of air = 167.89 lb/sec   not 55.90 lb/sec because the given mass flow rate of…

Q: As shown in the figure below, water behind a dam enters an intake pipe at a pressure of 24 psia and…

A: To find: The electricity generated and the value of power produced in dollar per day. Given: The…

Heat Exchangers

Heat exchangers are the types of equipment that are primarily employed to transfer the thermal energy from one fluid to another, provided that one of the fluids should be at a higher thermal energy content than the other fluid.

Heat Exchanger

The heat exchanger is a combination of two words ''Heat'' and ''Exchanger''. It is a mechanical device that is used to exchange heat energy between two fluids.