AirPQuestion 5.1,2 m wide AB gate is articulated from pointA shown in the figure. The heights of thefluids are 6.2 m and 2.2 m for hị and h2,hịConsidering the measuredWaterrespectively.pressure P = 18 kN/m², find the magnitudeOilh2of the force *(kN) that will affect point B, inwhich the force provides the balance in ABgate (SGoil = 0,75).Figure 5(y= 10KN/m³)

Widht of the gate AB = 1.2mHeight of the water h1 = 6.2mHeight of the water h2 = 2.2mPressure =…

Air Question 5. 1,2 m wide AB gate is articulated from point A shown in the figure. The heights of the fluids are 6.2 m and 2.2 m for hị and h2, hị respectively. Considering the measured Water A pressure P = 18 kN/m², find the magnitude %3D Oil h2 of the force *(kN) that will affect point B, in which the force provides the balance in AB B gate (SGoil = 0,75). Figure 5 (y= 10KN/m³)

Air Question 5. 1,2 m wide AB gate is articulated from point A shown in the figure. The heights of the fluids are 6.2 m and 2.2 m for hị and h2, hị respectively. Considering the measured Water A pressure P = 18 kN/m², find the magnitude %3D Oil h2 of the force *(kN) that will affect point B, in which the force provides the balance in AB B gate (SGoil = 0,75). Figure 5 (y= 10KN/m³)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Sssoon
A fluid (sp. gr. = 0.9, u= 1.2 Pa-s) flows in a laminar state between two stationary parallel plates set 4 cm apart. If the steady discharge is 800 cm3/s per cm width of plates, the shear stress at distance 1 cm from either boundary is.
Qi/ 1- Find the value of h in the piezometer shown in Figure No. (1). 2- Find the value of pressure at the center of water layer. Q/Gage A shown in Figure No (2) reads 4 (Bar). Find the reading of Gage B. If the value of PA is not equal to the value of PB. Mention the REASON. Q3/ The curved hard submerged surface ab shown in Figure No. (3). 1- Find the value of pressure at each of the points a, b, c and d. 2-Draw the pressure distribution diagram on the horizontal submerged surface ca. Mention what is its SHAPE. Q./In Figure No. (4) the value of pressure of compressed air på in pipe No.(1) is 3.8 (Bar). Find the value of pressure of water på in pipe No. (2). 1m P=150 (KN/m2) compressed air 0.5 m P,=30(KN/m2) h Oil G oil =0.82 water 3.6m PA Pe piezometer 1.2m Mercury 2m Water A B Fig.(2) Fig.(1) B Pipe No.(2) X. P=100(KN/m2) water comressed Air Pipe No.(1) water h2=8m 4.5m h1 =10m water a 2.7m 2m Air (2) (1) b Fig.(3) Fig.(4) Mercury
Find the pressure gradient
the value of oil is - 0.8 asap 15 mins
A fluid (sp. gr. = 0.9, u= 1.2 Pa-s) flows in a laminar state between two stationary parallel plates set 4 cm apart. If the steady discharge is 800 cm³/s per cm width of plates, the shear stress at distance 1 cm from either boundary is.
A large plate is centrally placed inside a gap which contains two h different fluids with (u =4 u2 ). If the force per unit area due to shear acting on both side of plate is 50 N. Calculate the values of viscosity for the two fluids ( i.e p and u2). V= 0.5 m/sec 6 cm Plate
Gate AB in the figure below is 1 m long and 0,7 m wide. Determine the force (F) on the gate and the position x, the centre of pressure. 3m Oil (sp gr = 0.81) ㅗ 1m. 7m 1m 1
FLUID MECHANICS Pipe in ground is moving wet raw sludge down a slope at a 30 degree angle and an elevation difference of 300 ft. Where P1 = 17 psi and P2 = 23 psi, D1 = 2 ft, D2 = 0.9 FT, Flow Rate through pipe Q= 5.8 cfs and specific gravity Weight of water and pipe = 80 lbf and maximum vertical force that can be applied to surrounding soil = 800 lbf. Is vertical force greater than 800 lbf to keep system in balance? %3D Psi 2 FE = D, 2=23psi D2 =0.9 Ft 30°
Consider the pressurized horizontal pipe network consisting of three pipes arranged in series. The characteristics of each pipe are summarized in the table. The flow of water at Node A is Q = 5 cfs and the pressure head at Node A is yA = 200 feet. The temperature of the water is 60° F. a) Determine the friction head loss hfric in feet in Pipe 1. b) Determine the friction head loss hfric in feet in Pipe 2. c) Determine the friction head loss hfric in feet in Pipe 3. d) Determine the pressure head ys in feet at Node B. e) Determine the pressure head yc in feet at Node C. f) Determine the pressure head yo in feet at Node D. Flow Friction Pressure Diameter Length Friction (feet) (cfs) head Нead Pipe (inches) factor f Kpipe loss (feet) Node (feet) 1 16 500 0.011 5 A 200 2 12 1000 0.013 B 3 10 750 0.015 D Node Node Node Node A в D 5 cfs 5 cfs Pipe 1 Pipe 2 Pipe 3
4. An upright wine barrel contains 3 m depth of wine with relative density of 1.015. The barrel is 2 m in diameter and 4 m high. Since the barrel is closed, there is a pressure of y kPa (where y = 60 above the liquid surface. (a) Draw the free-body diagram of the barrel. (b) What is the total normal force in kg acting on the wall of the barrel? (c) What is its location from the ) due to air that fills the container bottom of the barrel in meters?