Ex. A pitot static probe is inserted into duct of air heating system parall to flow and the differential height of the water Colum is measured. The flow velocity and the pressure rise at the of the pitot-statics probe are to be determined For water p = 1000 kg/m3. for air p = 1.1 kg/m3 Air h-2.4 cm

Ex. A pitot static probe is inserted into duct of air heating system parall to flow and the differential height of the water Colum is measured. The flow velocity and the pressure rise at the of the pitot-statics probe are to be determined For water p = 1000 kg/m3. for air p = 1.1 kg/m3 Air h-2.4 cm

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Calculate the surface tension of the fluid (SG = 8.6) in the capillary tube below: Зтт h = 2mm e =…

Q: Water flows into the atmosphere from a nozzle and strikes a vertical plate as shown in the figure…

A: Diameter of pipe (D1) = 0.3m Area of pipe (A1) = Πd2/4 = 0.0706 m2 Diameter of the nozzle (D2) =…

Q: (Laminar flow) A fluid flows through two horizontal pipes of equal length which are connected…

A: To find diameter of second pipe

Q: A capillary tube of 1.3 mm diemeter is immersed vertically in water exposed to the atmosphere.…

Q: Darcy Experiment A set-up of Darcy Experiment involves measuring the pressure head at two…

A: Given data Hydraulic head at 1 (h1) = 66cm Hydraulic head at 2 (h2) = 54cm Travel distance (L) =…

Q: An orifice on the side of a tank discharges water under a head of 9 ft. if the diameter of the…

A: Coefficient of discharge: The ratio of actual discharge to the theoretical discharge is known as the…

Q: H.W1: Determine the pressure difference between points A and B in Fig below?

A: γ=ρg=ρ×9.81γbenzene=880x9.81 =8632.8 N/m3γmercury=13600x 9.81 =133416 N/m3γkerosene=850x9.81 =8338.5…

Q: 4-61. Oil flows into the mixing tank through pipe A at 0.05 m/s, and glycerin flows into the tank…

A: To find the average density-

Q: Taking the coefficient of compressibility of water to be 2200 MPa, determine the pressure increase…

Q: Stops Piston Gas m=5 A-0

A: Given: Patm=1 barm=50 kgA=0.01 m2g=9.81 m/s2

Q: Flow rate of a fluid (density = 1000 kg/m³) in a small diameter tube is 800 mm³/s. The length and…

A: Given:Density of the fluidρ=1000 Kg/m3DischargeQ=800 m3/sQ=800×10-9 m3/sLength of the tube(L)=2…

Q: 1- Water flows through a horizontal pipe at a rate of 9.1 L/s. The pipe consists of two sections of…

Q: (Laminar flow) A fluid flows through two horizontal pipes of equal length which are connected…

A: Total length of both pipe=2l To find diameter of second pipe

Q: Problem 1: Energy Equation Assuming steady flow of an ideal incompressible fluid, find the pressure…

A: g=32 ft/s2at point Adia of pipe=12 in=at point Bdia of pipe=6 inpressure head ()=2 ftvelcoty (vB)=8…

Q: An incompressible fluid flows through a horizontal pipe which tapers from a diameter of 2 cm to a…

Q: a.) Determine the pressure difference between the two vessels when the difference in the levels of…

Q: -0.13 Darcy Experiment A set-up of Darcy Experiment involves measuring the pressure head at two…

A: Given data h1 = 24 in h2 = 11 in Length of seepage (L) = 100 in

Q: A Differential manometéř Is ne points A and Bat the centre of two pipes. he pipe A(left limb)…

Concept explainers

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?

Question

Ex. A pitot static probe is inserted into duct of air heating
system parall to flow and the differential height of the water
Colum is measured. The flow velocity and the pressure rise at
the of the pitot -statics probe are to be determined
For water p = 1000 kg/m3. for air p = 1.1 kg/m3
Air
h-2.4 cm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: We have to determine flow velocity and pressure rise

VIEW

Step 2: Using Bernoulli's equation

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

H.W1: Determine the pressure difference between points A and B in Fig below? 3 Note: p = 1. 2kg/m', %3D air Pbenzen = 880kg/m', 13600kg/m, 3 3 %3D P mercury Kerosene Air To 41 10 cm 21cm 9cm cm 15 cm Benzene Mercury Water 3 Pkerosene = 850kg/m . Ans: P, - P%310.2 Кра B A
-8.33 -0.12 8.33 (1) 0.12 -L Darcy Experiment A set-up of Darcy Experiment involves measuring the pressure head at two piezometers separated a distance, L. Given the set-up shown, determine the hydraulic gradient if the hydraulic head at (1) is 66 cm, hydraulic head at (2) is 54 cm, and the travel distance is 100 cm. h (2) e - - - -
i need the answer quickly
The bin is used to store carbon tetrachloride, a cleaning agent for metal parts. If it is filled to the top, determine the magnitude of the resultant force this liquid exerts on each of the two side plates, AFEB and BEDC, and the location of the center of pressure on each plate, measured from BE. Take ρct = 3.09 slug/ft3.
Flow rate of a fluid (density = 1000 kg/m³) in a small diameter tube is 800 mm³/s. The length and the diameter of the tube are 2m and 0.5 mm, respectively. The pressure drop in 2m length is equal to 2.0 MPa. The viscosity of the fluid is
In fig. if H= 88 inches, the difference in pressure =---?(the fluid is water) Piezometer (static) tube- -Pitot tube 2 BAR CO -Fluid stagnates at point 2 (v₂ = 0) 357.6. lb/ft2 O 243 lb/ft2 O 457.6 lb/ft2. O
Heavy fuel oil flows at Q = 10 gallons per minute (gpm) in a horizontal steel pipe that connects two storage tanks. The diameter of the pipe is D = 1.5 inches. The length of the pipe is L = 100 feet. The depth of oil in the supply tank is 30 feet above the pipe entrance. The temperature of the oil is 60°F, the specific gravity of the oil is s.g.oin = 0.90, the specific weight of the oil is 56.13 lb/ft', and the kinematic viscosity of the oil is 0.00175 ft2/s. The pipe discharges into the bottom of the receiving tank. Neglect minor losses. a) Determine the pressure p at the pipe entrance in pounds per square foot (psf). b) Determine the velocity v in feet per second (fps). c) Determine the Reynolds number Re. d) Classify the flow based on the Reynolds number Re. e) Determine the Darcy-Weisbach friction factor f. f) Determine the friction head loss hfac in feet in the pipe between the two storage tanks. 8) Determine the depth of oil in feet above the exit from the pipe into the second…
2. Oil of specific gravity of 0.90 is discharging through a 100 mm circular sharp edge orifice in the end of a 120mm pipe. The pressure head on the center line of the pipe just upstream from the orifice is 9m of oil, and discharges takes place into a closed tank in which the vapor pressure is - 20 kPa. Use C = 0.68 and Cv = 0.97. Compute the discharge. 120 mm pipe P = - 20 kPa 100 mm orifice
Suppose a Venturi tube (placed in the horizontal position of Pipe BC in Figure 1) from the right (Fig.2). The radius of the wide part of the tube is 5.0 cm; the radius of the thin part of the tube is 2.5 cm. The tube of shape U is filled with the mercury of the density 13600 kg/m . Determine what heightdifference will be stabilized between the surfaces of the mercury in U-tube. Ignore the losses.
Ans is 82.7 ,Show complete work
1- Water flows through a horizontal pipe at a rate of 9.1 L/s. The pipe consists of two sections of diameters 10.16 cm and 5.08 cm with a smooth reducing section. The pressure difference between the two pipe sections is measured by a mercury manometer. Neglecting frictional effects, (a) determine the differential height of mercury between the two pipe sections. (b) How would the reading change if the manometer on the 2in pipe is replaced by a pitot tube? 10.16 5.08 h
Air in a room at T0 = 290 K and P0 = 90 kPa is to be drawn by a vacuum pump through a 3-cm-diameter, 2-m-long adiabatic tube equipped with a converging nozzle at the inlet. The flow in the nozzle section can be approximated as isentropic. The static pressure is measured to be 87 kPa at the tube inlet and 55 kPa at the tube exit. Determine the mass flow rate of air through the duct, the air velocity at the duct exit, and the average friction factor for the duct.