Air modeled as an ideal gas enters a turbine operating at steady state at 1040 K, 278 kPa and exits at 120 kPa. The mass flow rate is 5.5 kg/s, and the power developed is 1200 kW. Stray heat transfer and kinetic and potential energy effects are negligible. Assuming k = 1.4, determine: (a) the temperature of the air at the turbine exit, in K. (b) the percent isentropic turbine efficiency.

Q: Three m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 295 K,…

A: Given, Volume of tank =3 m^3

Q: Air is compressed adiabatically in a piston-cylinder assembly from 1 bar, 300 K to 6 bar, 600 K. The…

A:

Q: 23 m³/hr of air at 600 kPa, 330 K enters a well-insulated, horizontal pipe having a diameter of 1.2…

A:

Q: Which of the following relationships is valid

A: Given; A closed system of simple compressible susbstance,Neglect changes in kinetic and potential…

Q: Nitrogen, modeled as an ideal gas, flows at a rate of 4 kg/s through a well-insulated horizontal…

A:

Q: Please answer correctly. 2) Is it possible to reduce the volume of an ideal gas in a closed…

A:

Q: A rigid tank containing air is subjected to a reversible process in which it is heated from its…

A: Answer: The specific change in entropy is 0.760324 kJ/kg•K.

Q: Entropy generation outside system boundaries can be accounted for by writing an entropy balance on…

A: Entropy is associated with the irreversibility of a system, it denotes the degree o randomness of a…

Q: Steam at a massflow rate of 10 kg/s at 5 MPa and 600 °C enters an insulated turbine operating at…

A:

Q: 23 m³/hr of air at 600 kPa, 330 K enters a well-insulated, horizontal pipe having a diameter of 1.2…

A:

Q: aturated water vapor at 300°F enters a compressor operating at steady state with a mass flow rate of…

A:

Q: Water at p1 = 20 bar, T1 = 400oC enters a turbine operating at steady state and exits at p2 = 1.5…

A:

Q: An ideal gas is compressed adiabatically from 1.5 bar, 338 K to 9 bar.   The process is reversible,…

A: Given data as per the question Initial pressure =1.5 bar Final pressure =9 bar k =1.23

Q: Consider 5.0 pounds per minute of water vapor at 100 lb/in2, 500°F, and a velocity of 100 ft/s…

A: Given Data The mass of the water vapor is: ms=5 lb/min The pressure of the vapor is: P1=100 lbf/in2…

Q: In a gas apparatus, it was recorded that the expansion index was 1.26 and the molar mass of gas is…

A:

Q: EX Example 8.14 bar and 25°C and compresses it to 8 bar and 160°C. Heat transfer from the compres-…

A:

Q: Consider 4.8 pounds per minute of water vapor at 100 lbf/in2, 500oF, and a velocity of 100 ft/s…

A:

Q: Consider 4.8 pounds per minute of water vapor at 100 lbę/in2, 500°F, and a velocity of 100 ft/s…

A:

Q: Air as ideal gas enters a compressor at inlet pressure 96 kPa, T₁ = 27C and volumetric flow rate is…

A:

Q: gas enters an insulated steady flow system at 200 kPa, 27 ⁰C with an enthalpy of 214 kJ/kg and a…

A: In this question concept of conservation of energy is used. To find the enthalpy, SSFE equation is…

Q: 5. The entropy during adiabatic reversible process (a) increases decreases remains constant (d)…

A: These questions are based on the concept of thermodynamics.

Q: Consider 4.8 pounds per minute of water vapor at 100 lb/in², 500°F, and a velocity of 100 ft/s…

A: Given: The mass flow rate, m = 4.8 lbs/s The pressure at entry, P₁ = 100 psi The temperature, T =…

Q: onsider 4.8 pounds per minute of water vapor at 100 lbf/in2, 500oF, and a velocity of 100 ft/s…

A:

Q: Refrigerant 22 is enters a compressor operating at steady state as saturated vapor at 10 bar and…

A:

Q: This question requires the use of the Thermodynamic Property Tables supplied as additional material.…

A: As per honor code and answering guidelines I can answer 1st three subparts at a time.If you want…

Q: Consider you have an insulated mixing chamber at steady state. This control volume receives two…

A:

Q: Twenty m/hr of air at 600 kPa, 330 Kenters a well-insulated, horizontal pipe having a diameter of…

A:

Q: Saturated water vapor at 300°F enters a compressor operating at steady state with a mass flow rate…

A:

Q: calculate the final temperature (in C) when the process is isothermal.

A: for solution refer below images.

Q: Air modeled as an ideal gas enters a turbine operating at steady state at 1040 K, 278 kPa and exits…

A:

Q: 0.2 m³ of air at 4 bar and 130 °C is contained in a system. A reversible isothermally expansion…

A:

Q: 4. Air with a mass flow rate of 2.5 kg/s enters a horizontal nozzle operating at steady state at 480…

A:

Q: While the flag is waving on top of its pole during a windy day, unfortunately the pole bends…

A: Since flag is waving on top of its pole during a windy day, flag is subjected to wind force. Due to…

Q: Demonstrate it with formulas and calculations. b.If yes, determine the work, in kJ, for an adiabatic…

A:

Q: A 340 L tank contains steam, initially at 400°C, 3 bar. A valve is opened for 20 seconds and steam…

A: GivenV=340L=0.340 m3T1=400oCP1=3 bart=20sm˙o=-0.005 kg/s

Q: In a thermal power plant, an adiabatic steam turbine operating at steady state with inlet conditions…

A: NOTE: According to Bartleyby's policy, we shall answer only three sub-parts so kindly repost…

Q: 3. Water enters a turbine operating at steady state with an initial state of P₁= 40 bar and T₁=520°C…

A: (a) To find: The isentropic efficiency ηt. Given: The initial pressure is P1=40 bar. The initial…

Q: Air enter the compressor operating at steady state at 330K, 100 kPa and exist at 150kPa Stray heat…

A: During a thermal process, if the entropy of the substance remains constant, the process is termed…

Q: Carbon dioxide gas is compressed at steady state from a pressure of 1.5 bar and a temperature of 0°C…

A: The mass flow rate of The gas is carbon dioxide.The specific heat of gas is .The inlet condition is…