Air is compressed from 100 kPa and 22°C to a pressure of 1 MPa while being cooled at a rate of 16 kJ/kg. The volume flow rate of the air at the inlet conditions is 150 m/min, and the power input to the compressor is 500 kW. Determine (a) the mass flow rate of the air and (b) the temperature at the compressor exit.

Q: Air is to be compressed from 3 bar and 303K to pressure of 15 bar in a multistage compression…

A: a multipart question about a simply supported beam subjected to a thermal load and an axial point…

Q: A transmission case measures W = 0.30 m on a side and receives a power input of P; = 150 hp from the…

A:

Q: Find the specific work done in a Rankine cycle if the steam supplied at 650 kPa and 0.9 dry and the…

A: The given parameters are:Pressure at which steam is supplied (P1) = 650 kPaDryness fraction (x) =…

Q: A converging-diverging nozzle is used to accelerate water at the state of superheated steam. The…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: #2: Your boss tells you that water at 68 F is flowing in a cooling tower loop at a rate of 35 gpm,…

A: Disclaimer: Since you have asked multiple question, we will solve the first question for you. If you…

Q: Consider the transmission case of Problem 1.23, but now allow for radiation exchange with the…

A: Given Data:Pi=150 hPTsur = 30oCThe emissivity () is 0.80.W= 30 mThe efficiency ()is 0.93.

Q: 4. (20 points) Water (25°C) flows at 4.5 gpm (gpm is gallons per minute) in the system shown below.…

A: a) flow rates will be same along the pipe assuming no change in density.   1 gpm =0.00006309 m3/s…

Q: Power for Pumping in Flow System. Water is being pumped from an open water reservoir at the rate of…

A: Given data: Mass flow rate of water = 2 kg/s Length of pipe = 1500 m Frictional losses in the system…

Q: Determine the compressor work input required to compress saturated liquid water isentropically from…

A: The work required to compress the liquid water which is saturated at the isentropic conditions is to…

Q: Using the first law of thermodynamics, analyze the cycle below in the thermodynamic equipment to…

A:

Q: A steady-flow 100% efficient water power plant has the following inlet and outlet conditions:…

A:

Q: At the commencement of compression in the reciprocating compressor of a refrigeration plant the…

A: Given:The compressor follows  at To find the work done, Internal energy and heat transfer through…