Air enters a converging-diverging nozzle with low velocity at 2.4 MPa and 120°C. If the exit area of the nozzle is 3.5 times the throat area, what must the back pressure be to produce a normal shock at the exit plane of the nozzle? The back pressure to produce a normal shock is MPa.

Q: Q.4. Air is fed from a large reservoir, where the temperature and pressure are 280 K and 300 kPa…

A:

Q: Air enters a nozzle at 200 KPa, 360 K and a velocity of 180 meter per second . Assuming isentropic…

A: Given: T = 360 K V = 180 m/s k = 1.4

Q: A converging diverging nozzle is supplied by air from large reservoir where the temperature is 400K.…

A: Temperature T0 = 400 K Velocity at inlet section V1 = 120 m/sCp = 1005R = 287 y = 1.4

Q: Steam at a velocity of 60 m/s and 250°C and 7 bar absolute is expanded through a nozzle to 200 C and…

A:

Q: Consider steady adiabatic airflow in a duct. At section B,the pressure is 600 kPa and the…

A: Given data

Q: Helium expands in a nozzle from 220 psia, 740 R, and negligible velocity to 15 psia. Calculate the…

A: Consider the diagram shown below for the nozzle. Since the inlet velocity is negligible, the inlet…

Q: The stagnation density after the shock (px= 55 kPa, Tx= 335 ,K, vx= 525 ms-1) 0.77 kgm-3 O 0.42…

A:

Q: Alr enters a turbine at a pressure of 2 MPa and a temperature of 830 K. The air exits at a pressure…

A: Given data,TurbineP1=2 MPa   P1=Inlet pressureT1=830K      T1=Inlet temperatureP2=50 kpa    P2=Exit…

Q: When we think of nozzles, we normally think of flow passages whose cross-sectional area decreases in…

A:

Q: Need asap in 30 min i will give like

A: Given,

Q: What would the nozzle pressure (in kPa) be if the sonic flow with Helium in the nozzle has a total…

A: A nozzle is mechanical equipment where the pressure energy of the working fluid gets converted into…

Q: 5- An aircraft is flying at an altitude of (12000 m) (T = 216.65 k, P = 0.193bar) at a Mach number…

A:

Q: An ideal nitrogen gas enters an adiabatic diffuser at 178 kPa, 280.15 oK and 275 m/s, and it leaves…

A:

Q: Compressed air from the compressor of a gas turbine enters the combustion chamber at T1 = 700 K, P1…

A: Given:To find:The Mach number at the duct exit.The drop in stagnation pressure.

Q: 4- Air at stagnation pressure of 600 kpa and stagnation temperature of 530 K enters a frictionless…

A:

Q: Air enters a frictionless duct with V₁ = 70 m/s, T₁ = 600 K, and P₁ = 350 kPa. Letting the exit…

A: To Find : The entropy change at intervals of 200 K. Given : The inlet velocity is v1=70 ms The…

Q: Helium is heated as it flows subsonically through a 10 cm × 10 cm square duct. The properties of…

A:

Q: The normal shock wave moves toward the back tank at an underexpansion flow regime during the…

A: In this problem, it is asking what will happen with normal shock wave in under-expansion flow.

Q: 1- For unchoked c-d nozzle, the supersonic flow through the diverging part can be attained by:…

A: 1. c ans Notwithstanding, for the supersonic stream, this conduct is turned around, and expanding…

Q: Q1) For isentropic air flowing through a converging-diverging nozzle, complete the sentences below…

A: NOTE: As per our expert guidelines we are supposed to answer only one (first) question at a time and…

Q: (b) Steam is expanded isentropically in a convergent-divergent nozzle from 15 bar pressure and 380…

A: Steam nozzle : Steam nozzle is a passage in which heat energy of steam is converted into kinetic…

Q: with a velocity of 175 m/s at an angle of 21° to the axial direction (in the direction of engine…

A:

Q: An axial-flow compressor is to compress air from 27°C and 1 atm to 5 atm. The mean blade speed is…

A:

Q: onsider a converging nozzle, with exit air velocity of Ma=1.

A: We have  a converging nozzle, with exit air velocity of Ma=1.

Q: Air flows through a constant area combustion chamber that has a diameter of 0.15 m and a length 5 m.…

A: D=.15 mL= 5m P0=1.4 Mpa T0=335 KM1=.55

Q: ir at 418.4°C enters a nozzle and exits at 482.4ms-1. Calculate the temperature at the exit. Give…

A:

Q: at 30°C and 101 kPa is drawn th ith throat area 0.025 m² and exi ge vacuum tank. Determine the

A: Given: po=101kPaTo=30oC

Q: Carbon dioxide (k=1.289; Cp=0.846 kj/kgK; R=0.1889 kj/kgk) enters a convergent-divergent nozzle at…

A: Given: V = 65 m/s k = 1.289 R = 188.9 J/kgK P = 300 kPa

Q: ing negligibi flow rate, area and fluid properties (p, T, p and v) at the tempera

A:

Q: Air flows steadily adiabatically through a pipe with a constant cross-sectional area. Air is fed…

A: here, flow through adiabatic duct so, stagnation temperature will same at outlet and inlet.from…

Q: In a convergent divergent passage normal shock wave forms in the divergent section. The mass flow…

A: subject : applied fluid mechanics

Q: A shock occurs in the nozzle when pres=p0,res = 3 atm and the Pitot tube measurement at the nozzle…

A: Shock location occurs when area ratio is 3.809. The answer is obtained using shock table and…

Q: 1 atm = 2116 lb/ft2 = 1.01 × 105 N/m2. Just upstream of a shock wave, the air temperature and…

A: Given Data: Upstream temperature is T1 = 288 K. Upstream pressure is P1 = 1 atm. Downstream…

Q: 2. Determine the back pressure necessary for a normal shock to appear at the exit of a…

A: Given:From one-dimensional isentropic compressible functions of an ideal gas table,For the given air…

Q: 1 atm = 2116 lb/ft2 = 1.01 × 105 N/m2. Consider the isentropic flow through a supersonic wind-tunnel…

A: Given Data Reservoir Properties  T0=500K    and P0=10atm Nozzle exit pressure P=1atm  Adiabatic…

Q: Inlet stagnation air pressure of a two-dimensional compressor cascade is 1.1 bar and inlet…

A: dear student please rate me p  stagnation air pressure = 1.1 bar Inlet stagnation temperature = 310…

Q: A steady adiabatic flow of perfect gas occurs between sections 1 and 2 of a duct. The Mach numbers…

A: Given data as per question Area at point 2 =4/3 A1 Calculations we know thatstagnation…

Q: 2. A gas stream (k=1.33) at 100 kPa and 723°C is passing at Mach number 0.7. Its temperature is…

A: To start with, we need to convert the given temperature from Celsius to Kelvin. The conversion…

Q: Consider supersonic flow of air through a 7-cm-diameter duct with negligible friction. Air enters…

A: Given Data Properties of air  R = 0.287 Kj/Kg-K CP = 1.005 Kj/Kg-K K=1.4 Inlet condition Ma1 = 1.8,…

Q: The flow downstream of intersecting shocks of opposite families (compression vs. expansion) adjusts…

A: Given The flow downstream of intersection shocks of opposite families adjust itself such that To…

Q: • R-134a enters a nozzle at 700 kPa and 120 °C and exits at 400 kPa and 30°C. Mass flows steadily…

A:

Q: Air is isentropically expanded from initial values 1500 kPa and 60°C to 400 kPa. What is the ratio…

A: Given Data: Initial pressure, P1=1500 kPa Final pressure, P2=400 kPa Initial temperature, T1=60 C

Q: Ideal gas Oxygen (O2) flows through a well-insulated (adiabatic) nozzle. The cross-section of the…

A: Given Data Initial pressure of the air is: P1=300 kPa Initial temperature of the air is: T1=400 K…

Q: For an ideal gas flowing through a normal shock, develop a relation for V2/V1 in terms of k, Ma1,…

A: Given Volume V2 and V1 Mass entity Ma1 and Ma2 Constant term k To find Mathematical relation between…