Air at a mass flow rate of 2.5 kg/s is decelerated in a diffuser from 220 m/s, with A2/A1 = 3. The device loses 18 kW of heat during its steady state operations under the following conditions: 18 kW T1= 27 C AIR T; = 42 C, 101 kPa Determine the exit velocity and the inlet pressure of air.

Air at a mass flow rate of 2.5 kg/s is decelerated in a diffuser from 220 m/s, with A2/A1 = 3. The device loses 18 kW of heat during its steady state operations under the following conditions: 18 kW T1= 27 C AIR T; = 42 C, 101 kPa Determine the exit velocity and the inlet pressure of air.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

4. An open system has a mass flow rate of 1 kg/s the enthalpy, velocity, height of entry are: 232 KJ/kg, 91 m/s, and 98m. At exit these quantities are: 230 KJkg, 15 m/s, 3.35m. If the heat received by the system is 10 KJ/s. What is the work done by the system per minute?
The inlet of a nozzle is at 400K and the outlet is 300K. The nozzle operates with air as an ideal gas as the working fluid and the flow is isentropic. The flow velocity in the inlet is 2 m/s, vith pressure of 10 bar and di ameter of 15 cm. The gas constant for air is R = 0.287 kJ/kg*K. Solve for the outlet velocity and diameter.
.The refrigerant volume flow rate at the entrance of compressor wereobtained from a test on a twin cylinder single acting 15 cm x 20 cm, 320 rpmcompressor ammonia refrigerating plant 33 L/s. Determine the volumetricefficiency of the compressor.
The index of expansion n. Q5: A-Steam enters a turbine with a velocity of 35 m/s and specific enthalpy 2990 kJ/kg . the steam leaves the turbine with a velocity of 25 m/s and specific enthalpy 1530 kJ/kg . the heat lost tothe surroundings as the steam passes through the turbine is 23 kJ/kg .the steam flow rate is 32400kg/h determine the work output from the turbine in kilowatts. B- 0.018 m' gas at a pressure of 3.070 Kpa exnands to a pressure of 00207 according to
A turbine is driven by a system that enters the turbine at the ff. conditions: 200 kg/h, 39 atm, 501 deg C, 49 m/s linear speed. The steam exits at a point 8 meters below the inlet stream of the turbine with the following conditions: atmospheric pressure, 290 m/s speed. 69000 W of shft work is delivered by the turbine while 100 kcal/h heat is lost. What is the value of (a) expansion work and (b) flow work? If the value is zero, explain why is it so.If it cannot be calculated, explain why.
A nozzle is a device for increasing the velocity of a steadily flowing stream of fluid, At the inlet to a certain nozzle the enthalpy of the fluid is 3025 kJ/kg and the velocity is 60m's. At the exit from the nozzle the enthalpy is 2790 kJ/kg. The nozzle is horizontal and there is negligible heat loss from it. (a) Find the velocity at the nozzle exit. (b) If the inlet area is 0.1 m’and the specific volume at the inlet is 0.19 m²/kg, find the rate of flow of fluid (C) If the specific volume at the nozzle exit is 0.5 m kg, find the exit area of the nozzle. Dr. Hameed J. Khalaf Subject Lecture
The power of a steam turbine in a thermal power plant is 60 MW. Water vapor enters the turbine at 3MPa pressure, 4000C temperature and 50 m / s speed, 10 kPa pressure, 0.9 dry degree and 200 m / s speed leaves the turbine. Considering the turbine as adiabatic; 1-Find the mass flow of steam 2-Find the turbine outlet cross-sectional area, its ratio (A2 / A1) to the inlet cross-sectional area.
A turbine operating in a continuous flow works adiabatically. The water vapor enters the turbine at a temperature of 650 C and comes out with 20 kPa pressure and 85% dryness. Find the mass flow rate (kg / sec) required to generate 10 MW of power from the system (ignore KE and PE changes)
In turbochargers a turbine is directly connected to a compressor. The power harvested by the turbine is used to power the compressor. In the figure below a turbine runs on steam and powers a compressor on air. Air can be considered a perfect gas with k = 1.34, R = = 300K and a mass flow 0.28 kJ/kgk = 1bar, T₁ = and Cp 1.02 kJ/kgK. The air enters the compressor at p₁ rate of mdot = 5.9 kg/s and exits at p2 = 5.2 bars. The steam enters the isentropic turbine at P3 = 2 MPa, T3 = 320°C and exits at p4 = 100 kPa. State 2 Isentropic Compressor State 1 Air-perfect gas T₁ = 300K P₁ = 1 bar W Answer: tubine = ? State 4 Isentropic Turbine State 3 Steam T3=320°C P3= 2MPa What is the enthalpy at state 2? Please enter your answer in kJ/kg
Identify what is the system in this problem and write the general energy balance equation (no need to solve) A turbine is driven by a system that enters the turbine at the ff. conditions: 200 kg/h, 39 atm, 501 deg C, 49 m/s linear speed. The steam exits at a point 8 meters below the inlet stream of the turbine with the following conditions: atmospheric pressure, 290 m/s speed. 69000 W of shft work is delivered by the turbine while 100 kcal/h heat is lost. What is the specific delta H?
Gsider a turbojet powered airplane flying at a standard altitude of 9144 m at a veloc- r 804.67 kmph. The turbojet engine itself has inlet and exit areas of 0.65 and 0.42 m², respec- The velocity and pressure of the exhaust gas at the exit are 487.68 m/s and 0.3064 bar. pectively. Calculate the thrust of the turbojet.
pls correct this given this is my last attempt thanks