Superheated steam from boiler expands in turbine from initial pressure p₁ = 230 bar and initial temperature T₁ = 577 °C topressure p₂ = 1 MPa. Isentropic efficiency of turbine ns is 0.8. Steam mass flow rate am,h is 146 kg/s.Read from h,s-chartEnthalpy of superheated steam hEnthalpy after isentropic expansion h₂,sCalculate:Enthalpy at the turbine outlet h₂Power of turbine PMW

The power can be obtained by,where, themass flow rate.. is the inlet or initial enthalpy. is the…

Answered: P₁ = 230 bar and initial temperature T₁…

Engineering

Mechanical Engineering

P₁ = 230 bar and initial temperature T₁ = 577 °C to ss flow rate am,h is 146 kg/s.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Q/A uniform flow with a velocity of 4 m/s is flowing over a source placed at the origin. The…

A: Given: Uniform velocity (U)=4m/sStagnation points= (-0.35,0)

Q: Please solve the problem quick & correctly. (1) What is the velocity leaving a jet engine (air) when…

A: The change in temperature, T1 - T2 = 220 C

Q: Density of air at the exit nozzle

A: Given; The temperature and pressure of air in a large reservoir are; T1=400 K P1=3 barConverging…

Q: H2O gas enters a convergent-divergent nozzle, with pressure 5 MPa, and temperature 2000∘ C. Flow…

A: Given: To = 2000+273 = 2273 K Po = 5 MPa Correct option: 1100 m/s

Q: Water (density 1000 kg/m) flows through an inclined pipe of uniform diameter. The velocity. pressure…

A: Bernoulli's equation states that if a fluid is ideal, incompressible and steady, then the total…

Q: rne delivéred procating air co e and 10 cm sta rolumetric effic

A: given:volume delivered =0.42×103m3bore diameter d=8cmstroke length=10cm

Q: 54. Engine for an airplane (Fth = 30.6 kN, A, = 2.8 A2, p1 = 101.3 kPa, T1 = 12 °C, v1 = 105.4 m-s1,…

A: By using the momentum integral equation P1A1-P2A2-Fth=m˙v2-v1 ....(1) Now the mass flow rate is…

Q: A, = 0.001184 m², A2 = 0.001065 m², p2 = 142 kPa, T2 = 133 °C, v2 = 294 m-s", find (a) Remaining…

A: Given data: Cross-sectional area at section 1, A1=0.001184 m2 Cross-sectional area at section 2,…

Q: As shown in figure Ql, air flows through a converging nozzle from a large tank and into receiver. At…

Q: Construct the flow.chart (diagram) and compute the total heat required to convert 250 g of ice…

Q: equal to 3.0. Find Me, Pe, and the loss in stagnation pressure (Poi - Poe). Repeat for a ock at the…

A: Given Image,

Q: 31. Find the altitude of a supersonic airplane (T = - 52 C°, v = 730 m-s) when the time between…

Q: Air is kept in a tank at pressure Po = 689 KPa abs and temperature To = 17°C. If one allows the air…

A: Given: Stagnation pressure = 689 kPa Stagnation temperature = 17+273 = 290 K Exit pressure = 101.325…

Q: In a nozzle, steam enters at T = 673.15 K and P = 800,000 Pa while u = 10 m/s. It exits at T =…

A: What is the ratio of the inlet and outlet diameters (D1/D2)?

Q: What is the mass of a saturated mixture of water with a quality of x = 0.2, T = 185°C, occupying a…

A: Givenx=0.2T=185°CV=3m3

Q: y the help of a fan ,air is drawn through a pipe of diameter 0.5 m. The temperature of air is 20°c…

Q: A piston PDP has a 5-in diameter and a 2-in stroke andoperates at 750 r/min with 92 percent…

A: Given data as per the question diameter =2 in stroke =5 in volumetric efficiency =92 % Calculations…

Q: H2O gas enters a convergent-divergent nozzle, with pressure 5 MPa, and temperature 2000∘ C. Flow…

A: Givenstagnation temperature = 2000 deg C stagnation pressure = 5 MPa exit temperature = 909 K

Q: he entropy change across a normal shock wave (Tox= 505 K, vx= 490 ms-1)

A: Given data: Tox = 505 K Vx = 490 m/s For air, specific heat, cp = 1.005 kJ/kg.K = 1005 /kg.K Gas…

Q: A test section in a wind tunnel is at Ma = 2.5, T = 15 °C, and P = 35 kPa (abs). The fluid is air.…

Q: In isentroipc flow VP/pY =const. O P/py =const O P/p =const. O p?/p?y =const.

A: Isentropic flow is described by flowing gases through narrow opening (or any dimension) ,in this…

Q: 6.2 An ideal gas, following the relationship (P v = 75 m²/s²), flows in a horizontal pipe at a…

A: The ideal relation is The inner diamter of plate is The pressure drop is The length is The pressure…

Q: Air is discharged from a large tank through a convergent nozzle of 25 mm diameter. The air in the…

A: (a) To find: The mass flow rate of air. Given: The inside pressure is P1=150 kPa. The outside…

Q: 5) The McDonnell Dauglas F-15 Eagle has a convergent -divergent duct exhaust system. Assuming the…

A: To find:the temperature, the Mach number, pressure, area, and mass flow rate at the inlet.and at…

Q: Carbon dioxide convergent-divergent to a Lule of 60 m / s, 310 °C and 300 kPa in its case, it enters…

A: Nozzle: Nozzle is a device which having varying in cross section, in which pressure is reduced by…

Q: An adiabatic, SSSF, single inflow/outflow nozzle has negligible kinetic energy on the inflow, and…

Q: Q1. Converging duct at steady one dimensional flow, Inlet section: p = 2.35 kg-m³, A = 0.59 m², v =…

A: Dear student, we are suppose to solve only one question. Please post other question as a separate…

Q: As3...Air at atmospheric pressure, 27 °C and %30 RH conditions and with a velocity of 3 m/s flows…

A: Given: The temperature of air, T1 = 27°C The relative humidity of air, w1 = 30% The area of pool, A…

Q: Q5. A duct of a friction length of fx/D = 124 is connected to a Duct reservoir. A nozzle is attached…

A: Given: Receiver pressure, Pe=103.4 kPafLD=12.4Nozzle exit area, Ae=6 cm2Nozzle inlet area, A3=9…

Q: A pipeline with diameter of 0.2 m. If the inlet pressure = 2400 kPa, outlet pressure = 2300 kPa,…

A: The length of the pipeline.Given:The diameter of the pipeline is .The inlet pressure is .The outlet…

Q: 58. Find the height of a supersonic airplane (v = 670 m-s1, T = - 44 C°) when the time between…

A: Given data:- Temperature, T=-44°C=-44+273=229K characteristic gas constant, R=287Jkg-K For air,…

Q: Q1// Air stream flow in a convergent- divergent nozzle, with a stagnation pressure of 120 kPa, the…

A: The nozzle is both convergent and divergent. The forward section of the nozzle is convergent,…

Q: The convergent-divergent nozzle in Figure 22 expands and accelerates dry air to supersonic speeds at…

Q: A C-D duct is connected to a large air reservoir with Po = 300 kPa, To = 400°K. The exhaust from the…

Q: the flow via a chemical reaction taking place inside the duct. Determine the heat transfer rate…

Q: H2O gas enters a convergent-divergent nozzle, with pressure 5 MPa, and temperature 2000∘ C. Flow…

A: Given: Let us consider the given, Stagnant Temperature, T0=2000°C+273=2273 k Exit temperature,…

Q: Given: Water (p = 1000 kg/m³) flows past a half body as shown in the figure. Pressure is measured at…

A: Given data: PA=160 kPaPB=90 kPa To find: Velocity of uniform stream, U

Q: Air from a reservoir at 20°C and 500 kPa flows through a duct and forms a normal shock downstream of…

A: Given data:The temperature of the air at the reservoir is .The pressure at the reservoir is The area…

Q: In a nozzle, steam enters at T = 673.15 K and P = 800,000 Pa while u = 15m/s. It exits at T =…

Q: the Figure (2), air flow in duct and heat is added between point 1 and point 2 by a rate of 420…

A: ⇒given data;⇒V1=100m/s⇒T1=500c =50+273 =323K⇒P1=50KPa⇒heat added (Q)=420KJ/kg

Question

Superheated steam from boiler expands in turbine from initial pressure p₁ = 230 bar and initial temperature T₁ = 577 °C to
pressure p₂ = 1 MPa. Isentropic efficiency of turbine ns is 0.8. Steam mass flow rate am,h is 146 kg/s.
Read from h,s-chart
Enthalpy of superheated steam h
Enthalpy after isentropic expansion h₂,s
Calculate:
Enthalpy at the turbine outlet h₂
Power of turbine P
MW
<J/kg
kJ/kg
kJ/kg

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: To find the power of turbine and and enthalpy at outlet, given, p1=230 bar, T1=577 C, P2=1 Mpa.

VIEW

Step 2: Solution

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 14 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Air is kept in a tank at pressure Po = 689 KPa abs and temperature To = 17°C. If one allows the air to issue out in a one-dimensional isentropic flow, the flow per unit area at the exit of the nozzle where P = 101.325 KPa is Blank 1 kg/m2-s. For air, Use R = 287 J/kg-K and Mol. Wt. = 29.1 *Express your answers in whole significant figure without decimal value and without unit*
Q1. A turbojet aircraft flying at speed of 1645 km/h and altitude of 9000 m. A supersonic intake was designed with a conical center body, which generated one oblique shock wave and normal shock wave at the inlet of the aircraft. The deflection of the conical center body is a 10°. Calculate the fluid flow properties and velocity at the aircraft inlet of the intake. Assume a weak solution. Take: R= 0.287 kJ/kg K, and Cp=0.9 kJ/kg K.
P.6.3 Substitute the equation du, into equation Su du, dr and integrate to show the shear rate at a pipe wall for power law fluid in steady state flow is du, 8u 3n +1 dr AP Hint: 1,(2L) = -AP, (Tr)= T, 2L
The pressure drop across a turbine is 200kPa. The flow rate is 0.25m3/min. WHat is most nearly the power output of the turbine?
Kindly answer this question thank you
Water enters at section 1 at 10 m/s with sp gr of 0.998 and alcohol enters sections 2 at 6 m/s with sp gr of 0.8. Pipes 1, 2 are of 3 cm in diameter and pipe 3 is of diameter 4 cm. Compute the exit velocity and density of the mixture. Assume ideal mixing of incompressible fluids. Please provide complete solution
typing clear urjent i will give 5 upvotees
V, = 176 m-s1, T, = 25 °C, p, = 298 kPa, (Design condition), Ae = 0.014 m?, pb = 110 kPa, determine m° and A?
(5) (a) Air flows adiabatically through a duct. At point 1 the velocity is 240 m/s, with T₁ = 300 K and P=150 kPa. Compute (a) To1, (b) Po1, (c) Po1, (d) Mal, (e) Vmax, and (f) V*.