Air 40 m, 2 cm

Q: A mechanical device pumps the fluid from a depth of 150 m under steady conditions. The density of…

A: Given data  depth=150m  density of fluid=1020 kg/m2  efficiency =70%  velocity of fluid =150m/s…

Q: air flows in a duct at the rate of 0.056 m3/s. Determine the pressure drop (kPa) between the 6 and 3…

A:

Q: In a hydroelectric power plant as shown in the figure, 100 m3/s of water flows froman elevation of…

A: Given Volumetric flow = 100 m3/s Elevation = 130 m Overall efficiency = 0.8 % To find Electric power…

Q: Question 3 Water enters a U-shape pipe at 50 kg/s mass flow rate at inlet 1 and leaves the U-shape…

A: Given:P1 = 300 kPaP2 = 200 kPaP3 = 100 kPad1 = 5 cmd2 = 10 cmd3 = 3 cmDensity of water = 1000…

Q: Notes: a) b) c) A simplified sketch of the thermodynamic system showing cylinder/piston at initial…

A:

Q: Consider incompressible, frictionless flow of a fluid in a horizontal piping. The pressure and…

A: Given,  P1 = 150 kPa v1 = 1.25 m/s P2 = 140 kPa Density = 700kg/m3 v2 = ? By applying Bernoulli's…

Q: Two long pipes in parallel are used to carry water between two reservoirs. The diameter of one pipe…

A:

Q: In a pumping system handling water, the level in the suction tank is 3.2m below the pump shaft…

A:

Q: A pump is being used to transport a liquid food product (ρ = 1250 kg/m3, μ = 1.5 cP) from a holding…

A:

Q: As shown in the figure water is discharged to the atmosphere at sea level by means of a dividing…

A:

Q: (a) A storage tank is connected to a piping system as illustrated in Figure P1. Water at temperature…

A: Major and minor losses are the most common types of energy losses in fluid flow across a pipe…

Q: Water at 10°C flows from a large hydroelectric plant reservoir through a cast iron pipe with an…

A: Given: The temperature of the water, T = 10°C The diameter of cast iron pipe, d = 750 mm = 0.75…

Q: Water is flowing through a circular pipe made of cast iron with a diameter of 26 cm. If Reynolds…

A: Given,  Flow of water through pipe Reynolds number (Re) = 105 Concept: Since Reynolds number (Re)…

Q: →Water is being pumped from a reservoir with water surface elevation of 12 m to another reservoir at…

A:

Q: A drainage hole (assumed to be a smooth edged orifice) is opened at the bottom of a storage tank…

A:

Q: A 2-kW pump is used to pump kerosene (p = 0.820 kg/L) from a tank on the ground to a tank at a…

A: Given,Power P = 2 KW = 2000 WDensity of kerosene = (rho = 0.820 kg / L)Elevation differences between…

Q: Air is flowing through a venturi meter whose diameter is 2.6 in at the entrance part (location 1)…

A:

Q: Water at 5°C is drained from a large reservoir using 2 horizontal copper pipes connected in series…

A:

Q: In a pumping system handling water, the surface level of water in the open suction tank is 3m below…

A: The suction level below the pump center is hs=3 m. The delivery level above the pump center is hd=21…

Q: A pump has a required NPSH of 3.0 m. Assuming that the pump is elevated at 3.5 m above sea level,…

A:

Q: Water is sent to a cylindrical tank with a height of 3 m and a diameter of 1 m through a pipe with a…

A:

Q: The diameter of a Pelton wheel is 0.7 m. The pressure head in front of the nozzle is 200 m and the…

A:

Q: diameter tube at a rate of 0.6 m3/s and leaves through a 25 cm diameter tube. cm in diameter With a…

A:

Q: air pressure above the water is . The required NPSH of the pump is 8.2 m. The suction pipe has a…

A:

Q: Water, an incompressible fluid, is flowing in a horizontal pipe at a velocity of varg = 1.15 m/s.…

A:

Q: Water is flowing through a venturi meter whose diameter is 7 cm at the entrance part and 4 cm at the…

A:

Q: Water at 5°C is drained from a large reservoir using 2 horizontal copper pipes connected in series…

A:

Q: In a pumping system handling water, the surface level of water in the open suction tank is 3m below…

A: Inlet conditions, diameter of pipe=d1= 7.62 cm =0.0762 m discharge =Q= 0.0126 m3/s friction factor =…

Q: Water in a duct of area 0.1 m2 has an average velocity of 7 m/s. The duct tapers slowly to 0.4 m2.…

A: Given data: The area of the duct at section 1 is, A1 = 0.1 m2. The average velocity at section 1…

Q: Petrol of specific gravity 0.85 is to be pumped through a 1.2 km pipeline to a petrol  station. The…

A: Given: The specific gravity of fluid, γ = 0.85 The length of the pipe, L = 1.2 km = 1200 m The…

Q: Water flows through a horizontal verturi meter whos inlet diameter is 31 cm and throat diameter is…

A:

Q: Water is being pumped from a  reservoir with water surface elevation of 12 m to  another reservoir…

A: Given that, Elevation of water, he=12 m,Elevation of reservoire, hr=69 m,Flow rate of water, Q=25…

Q: Water at 20C is pumped at a constant rate of 9 m3/h from a large reservoir resting on the floor to…

A: Given:Water temperature, T=20oCWater flow rate, Q=9 m3/h=93600m3/s=0.0025 m3/sThe point of discharge…

Q: 1. The water in an 8-m-diameter, 3-m-high above-ground swimming pool is to be emptied by unplugging…

A:

Q: Determine the discharge of a flowing fluid from a nozzle, whose specific gravity is 1.3, the nozzle…

A:

Q: A pressurized tank of water has a 10-cm-diameter orifice at the bottom, where water discharges to…

A: In order to proceed with the given problem, the following assumptions need to be taken into…

Q: Water at 20 oC is pumped at a rate of 9.0 m3/h from a large tank resting on the floor(open to the…

A:

Q: Water at 60 deg. F is pumped from a reservoir to the top of a mountain through a 6-in SCH 120 pipe…

A: Givend=6in=6×0.0254=0.1524 mV=12 ft/s=12×12=144 in/s=144×0.0254=3.6576…

Q: As shown in figure below, oil can be siphoned from a tank using a flexible hose, provided that the…

A: Given dataPoint B is below point A by 6.71 mPressure at point C = 90.257 kPaDensity of oil = 890…