Answered: age was 11) What the voltage drop over…

age was 11) What the voltage drop over three conductors (with resistance of 0.2 ohms per 50m) supplying 18 A load located 100 m from the power supply? a) 7.2 V b) 3.6 V c) 10.8 V d) 21.6 V

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter17: Resistive-inductive Series Circuits

Section: Chapter Questions

Problem 1RQ: 1. What is the relationship of voltage and current (concerning phase angle) in a pure resistive...

See similar textbooks

Related questions

Q: Using nodal analysis, what is the power absorbed by the 2-ohms resistor?

A: Given circuit is,

Q: The voltage difference between points a and b is provided by a battery that has a voltage Vab= 24…

Q: Three resistors are connected in series across a 12-volt battery course. It has found to be that the…

A: Given, three resistors are connected in series across a 12-volt battery, Let, R1, R2 and R3 be…

Q: The sizes of the given circuit elements are given below. What is the average power delivered by the…

A: In a single-phase transformer dot convention of the winding is of importance. In the given circuit…

Q: lov

A: As we know that for measurement of current in a circuit we have to connect this Volt Meter in series…

Q: 55 Question 15 If a string of suspension insulator has tl units, each can withstand a maximum

A: In this we will find string efficiency...

Q: 4.0 Ω 5.0 Ω. 18 V 3.0 Ω 6.0 Ω

Q: Using the Volt-Ohm-Multimeter (VOM), explain how would you measure the voltage across a) R1, b) R2,…

A: In an electrical measurement, we have two types of measuring instruments. Analog instruments…

Q: In the circuit of the figure, calculate: a. The intensity of current passing through the 80 ohm…

Q: q 1 (a) Find the value of current i1 (using Current Division Rule) (b) and the power dissipation…

A: The given circuit is,

Q: Circuit Diagram: E 12V Apparatus: R1 20 1. DC Power Supply. 2. Resistors. 3. Digital Multimeter. 4.…

A: The circuit diagram and procedure table,

Q: 14.0 V 4.0n 6.00 10.0 V 2011

Q: What will be value of the voltage Vb?

A: From the given circuit diagram, node D can be considered as reference node. So, this node will be…

Q: Two heating units A and B are connected parallel across a 120-volt supply. Unit B takes twice as…

Q: 1.2 An electrical load consists of three resistances connected in series-parallel. The series…

A: The value of the series resistor, The value of parallel resistors, The voltage provided by a…

Q: Calculate the current and voltage values for the circuit components from the Kirchhoff's Current Law…

Q: 8. If a load is a 23KW 10, 240Vac, and you have THHN 90°C Copper conductors, what size will they…

A: Calculate the current flowing through the load,

Q: Two heating units A and B are connected parallel across a 120-volt supply. Unit B takes twice as…

A: Given

Q: 4) For circuit shown in Figure (4): Determine the voltage drop across 90. a) 17V 20 90 b) 15V c) 19V…

A: Given circuit is:

Q: If a string of suspension insulator has three units, each can withstand a maximum 11 kV and total…

Q: How is the multimeter connected to the circuit for current and voltage measurements? b) Write the…

A: In color banded resistor, each color describe a particular value and its function. The value and…

Q: State the Kirchoff's voltage and current law?

A: Statements of Kirchoff's voltage and current law.

Q: 15-A single phase load located 850 meter from the source the load consumes 80 Amp and operates in…

A: To solve above problem, one should know about resistance calculation of a material. The resistance…

Q: With switch SW1 closed and switch SW2 open, complete the following using the values from the table:…

A: The circuit is given asAccording to the question, when SW1 will be closed and SW2 will be open, the…

Q: 3. A voltage source delivers 4 amperes by means of a pair of conductors when the load is 5 ohms. The…

A: TO FIND THE MAXIMUM POWER THAT THE VOLTAGE SOURCE CAN SUPPLY , WE NEED TO FIND THE LOAD RESISTANCE…

Q: Consider the circuit in the figure below where the power supply open-circuit voltage and…

Q: Two heating units A and B are connected parallel across a 240-volt supply. Unit B takes thrre- times…

A: Voltages are same in parallel and Power is the product of Voltage and current So for same voltage…

Q: What will be the resistance of Ammeter in order to reduce the Loading Effect? a) Insulation b) High…

Q: Determine the source current for the circuit if V=498 Volts, R1=2,001 Ohms, and R2=3,3900hms. R1: ww…

A: it is asked to find the source current for given circuit

Q: Determine the currents I1, I2 and Iz for the electrical network shown in the following figure:

A: Write KVL in both loops, 50-5I1-20I3=0 .....130+20I3+10I2=0 ......2…

Q: Which of the following statements is true ? A. Power is additive in series and parallel circuits.

A: We will analyze each of the given statements and will see which one is correct and why and the one…

Q: A 50-ohm load dissipates 200W of power. How much is the voltage and current across the load? c. If…

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.

Q: With switch SW1 and SW2 both closed, complete the following using the values from the table:i.…

A: The circuit will be with both switch in close positionhere

Q: Three identically shaped segments of different materials have a voltage of 120 mV applied between…

Q: The type of cable used for a voltage of 25kV is called. Answer:

A: Need to find type of cable

Q: 2a Explain the concepts of Kirchhoff’s Voltage Law (KVL) and Kirchhoff’s Current Law (KCL) with any…

Q: xplain the different types of electrical loads in detail with at least one practical example for…

A: Different types of electrical loads: There are three different types of electrical loads based on…

Question

ronage T TUG as ne vi
11) What the voltage drop over three conductors (with resistance of 0.2 ohms per
50m) supplying 18 A load located 100 m from the power supply?
a) 7.2 V b) 3.6 V c) 10.8 V d) 21.6 V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is load regulation?
Power factor PF PF=______________ Define the units of VA and VAR?
Task 3 A three phase, four wire star connected load consisting of: ZR: a resistor of 9500 in series with a 3H inductor ZB: a resistor of 1950 ZY: a resistor of 1950 in series with a 4µF capacitor Using the equipment available in the power lab (Room T017), connect the given load to a three-phase supply available in the lab and: 3.1. Determine the current of each line and the neutral current and measure the total power supplied by the source. 3.2. Analytically, calculate all currents and the total power and compare with those obtained in measurements. 3.3. Device a method and measure the waveform of the neutral current. Discuss the obtained waveform and the reason for any distortion in the waveform 3.4. Validate your calculations using computer simulation
17 In the figure shown, the voltage V1 the voltage V2 by V₁ * out of phase. 40)
36. If the resistor R1 and R2 terminals are connected across each other. If theRory is 10 and R1 is twice the value of R2 what is R1?a. 15 ohmsC.3,33 ohmsb. 30 ohmsd. 6.67 ohms
Problem 1- Series en Parallel AC networks [19] Look at the circuit in Figure 1 and determine the following: A. B Zs (d) Current (I1) through impedance Z2. (e) Current (12) through impedance Z3. (f) Current (13) through impedance Z4. 220V;50HZ Figure 1 Z1 = 3 + j5 ohm Z2 = 10 + jo ohm Z3 = 5 + j15 ohm Z4 = 10 – j30 ohm Zs = 20 – j30 ohm Admittance and Impedance in rectangular notation. All currents and voltage in polar Take voltage as reference. notation.
please write your Introduction about this topic , and answer please in print font do not write in hand writing ? beceuse I want to copy it ?
If T = 0.6Z – 60° and A = 48cm find the position of the first voltage minimum on the line. Select one: O a. The first voltage minimum is at 2cm from the load. O b. The first voltage minimum is at 72cm from the load. O c. The first voltage minimum is at 8cm from the load. O d. The first voltage minimum is at –4cm from the load. O e. The first voltage minimum is at 20cm from the load. O f. The first voltage minimum is at 32cm from the load. O g. The first voltage minimum is at 44cm from the load. O h. The first voltage minimum is at 24cm from the load.
三 T AaBbCcDc AaBbCcDc AABBC T Normal 1 No Spac. Heading Paragraph Styles In the circuit pictured the current through R1 is 11 = 6A in the direction shown. a) Determine the current 14. Describe choice of node or loop (including direction of travel). b) Determine the current 13. Describe choice of node or loop (including direction of travel). c) Determine the Determine the potential difference Vgd = Vg Vd between points g and d.
Two impedances consist of resistance of (15 ohms and series connectedinductance of 0.04 henry) and (resistance of 10 ohms, inductance of 0.1 henryand a capacitance of 100 microfarad, all in series) are connected in series andare connected to 230 volts, 50 – Hz AC source. Find: (a) current drawn, (b) voltageacross each impedance, (c) individual and total power factor. Draw the phasordiagram.
The current lo of figure shown below ww
Q2/ Find Yous for the power system all reactance on a common base. Bus 3 j0.25 j0.10 j0.25 Bus 2 j0.125 Bus 1 j0.40 j0.20 j0.10 Bus 4