After tasting the salt in the ocean water on a visit to the beach one day, you recall from chemistry class that the salt is thein the ocean water.A)solidB)soluteC)solutionD)solventJose makes two mixtures. Mixture one contains 10 g of salt dissolved in 50 mL of water. Mixture two contains 20 g of saltdissolved in 50 mL of water. Compare the concentrations of the two mixtures.5)A)Both mixtures are equally concentrated.KSign out

Answered: Image /qna-images/answer/8fef4c20-c9c4-4ee6-9c4f-7b1d46d01dd7.jpg

Answered: After tasting the salt in the ocean…

After tasting the salt in the ocean water on a visit to the beach one day, you recall from chemistry class that the salt is the in the ocean water. A) solid B) solute C) solution D) solvent

World of Chemistry, 3rd edition

3rd Edition

ISBN:9781133109655

Author:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan L. Zumdahl, Donald J. DeCoste

Chapter15: Solutions

Section: Chapter Questions

Problem 63A

See similar textbooks

Similar questions

Calcium carbonate, CaCO3, can be obtained in a very pure state. Standard solutions of calcium ion are usually prepared by dissolving calcium carbonate in acid. What mass of CaCO3 should be taken to prepare 500. mL of 0.0200 M calcium ion solution?
Addition of water to concentrated sulfuric acid is dangerous because it generates enough heat to boil the water, causing it to spatter out of the container. For this reason, chemists remember to add acid to water. In a dilution experiment, we calculate the amount of the more concentrated solution that must be measured out. If we place this concentrated solution (Figure 4.7) in the volumetric flask first, then dilute with water, we violate the caution Add acid to water. Describe a safer variation on the method shown in Figure 4.7 that allows the quantitative dilution of concentrated sulfuric acid. Figure 4.7 Preparing a dilute solution from a concentrated solution. (a) Draw the concentrated solution into a pipet to a level just above the calibration mark. (b) Allow the liquid to settle down to the calibration line. Touch the tip of the pipet to the side of the container to remove any extra liquid. (c) Transfer this solution to a volumetric flask. Again touch the pipet to the wall of the flask to ensure complete transfer, but do not blow out the pipet because it is calibrated for a small amount of liquid to remain in the tip. (d) Dilute to the mark with solvent. Frequently, especially with concentrated acids, it is best to have some solvent present in the volumetric flask before you add the concentrated sample.
What happens if you add a very small amount of solid salt (NaCl) to each beaker described below? Include a statement comparing the amount of solid eventually found in the beaker with the amount you added: a a beaker containing saturated NaCl solution, b a beaker with unsaturated NaCl solution, c a beaker containing supersaturated NaCl solution. A saturated sodium chloride solution.
Solutions of hydrogen in palladium may be formed by exposing Pd metal to H2 gas. The concentration of hydrogen in the palladium depends on the pressure of H2 gas applied, but in a more complex fashion than can be described by Henry's law. Under certain conditions, 0.94 g of hydrogen gas is dissolved in 215 g of palladium metal (solution density = 10.8 g cm3). (a) Determine the molarity of this solution. (b) Determine the molality of this solution. (c) Determine the percent by mass of hydrogen atoms in this solution.
A solution is formed by mixing 1 gal ethanol with 10 gal gasoline. Identify the solvent and the solute.
A patient has a “cholesterol count” of 214. Like manyblood-chemistry measurements,this result is measured inunits of milligrams per deciliter (mgdL1). Determine the molar concentration of cholesterol inthis patient’s blood, taking the molar mass of cholesterolto be 386.64gmol1. Estimate the molality of cholesterol in the patient’sblood. If 214 is a typical cholesterol reading among men inthe United States, determine the volume of such bloodrequired to furnish 8.10 g of cholesterol.
Silver ions can be found in some of the city water piped into homes. The average concentration of silver ions in city water is 0.028 ppm. (a) How many milligrams of silver ions would you ingest daily if you drank eight glasses (eight oz/glass) of city water daily? (b) How many liters of city water are required to recover 1.00 g of silver chemically?
One mole of CaCl2 is represented as where represents Ca and represents Cl. Complete the picture showing only the calcium and chloride ions. The water molecules need not be shown. What is the molarity of Ca2+? of Cl-?
Explain why the distinction between solute and solvent is not clear for some solutions.
How would you prepare from the solid and pure water (a) 0.400 L of 0.155 M Sr(OH)2? (b) 1.75 L of 0.333 M (NH4)2CO3?