Blocks A and B have masses of 10 kg and 20 kg respectively. The coefficient of static friction between Aand B is 0.20, between B and C is 0.10 and at D, 0.15. Block B impends to slide up the 30°- incline plane.(A) Draw the FBD of block A(B) Draw the FBD of block B(C) What is the weight of the hanging block that will maintain static equilibrium?Note: Use T1 and T2 for tension on the tight side and slack side of the cord respectively.20'w/

The forces acting on the body A and B are, gravitational force downwards, frictional force opposite…

Answered: Blocks A and B have masses of 10 kg and…

Similar questions

A 27.9 kg lamp is suspended from the ceiling by two wires that each makes an angle of 27.4º with the vertical. What is the tension in the wire? Use g=9.8m/s
A 1,420-N crate is being pushed across a level floor at a constant speed by a force F of 350 N at an angle of 20.0° below the horizontal, as shown in the figure a below. F F 20.0° b (a) What is the coefficient of kinetic friction between the crate and the floor? (Enter your answer to at least three decimal places.) 20.0⁰ (b) If the 350-N force is instead pulling the block at an angle of 20.0° above the horizontal, as shown in the figure b, what will be the acceleration of the crate? Assume that the coefficient of friction is the same as that found in part (a). m/s² Need Help? Read It
A 1,480-N crate is being pushed across a level floor at a constant speed by a force of 350 N at an angle of 20.0° below the horizontal, as shown in the figure a below. F 20.0° / 20.0° a b (a) What is the coefficient of kinetic friction between the crate and the floor? (Enter your answer to at least three decimal places.) (b) If the 350-N force is instead pulling the block at an angle of 20.0° above the horizontal, as shown in the figure b, what will be the acceleration of the crate? Assume that the coefficient of friction is the same as that found in part (a). m/s²
The figure shows a section of a cable-car system. The maximum permissible mass of each car with occupants is 2200 kg. The cars, riding on a support cable, are pulled by a second cable attached to the support tower on each car. Assume that the cables are taut and inclined at angle 0 = 39º. What is the difference in tension between adjacent sections of pull cable if the cars are at the maximum permissible mass and are being accelerated up the incline at 0.85 m/s²? Number Units Support cable- Pull cable
A 2.03 kg book is placed on a flat desk. Suppose the coefficient of static friction between the book and the desk is 0.482 and the coefficient of kinetic friction is 0.262. How much force is needed to keep the book moving at a constant speed once it begins moving?
A rope exerts a force of 50 N on a box to keep it stationary. If the box is on a plane inclined 25° from the horizontal and the coefficient of static friction is 0.29, calculate the normal force exerted on the box.
A 26.8 kg box sits on a ramp at an angle of 13° above the horizontal. If the coefficient of static friction between the box on the ramp is 0.215, what minimum applied force is required to keep the box at rest?
What is the magnitude of the static friction force required to keep a 2.00 kg block resting on an inclined plane at an angle 25 degrees? If the angle was increased, such that the incline plane was steeper, would the magnitude of the static friction force required to hold the block at rest increase, decrease, or stay the same?