Find the Ic(s) equation in the laplace domain of the current flowing through the capacitance in the circuit given in the figure below. Then substitute s=K for s in this equation to get a number called M. Then get the Ic(t) equation, which is the inverse laplace value of the Ic(s) equation. Substitute t=Q for t in the Ic(t) equation to obtain a number called N. In which option is the number closest to the M*N value given? Take the initial conditions of the elements in the circuit Vc(0)=A volts, IL(0)=B amps. 2001 2001 E L 2001 R1 Ic(t) R2 2001 below are the values Şekil E=50 Volt 2001 R1=13 ohm R2=24 ohm 01001119531 B C=1 farad 01997 L=1 henry 116 A= - 12 Volt 4.047 200 2.115 O 16- 19e 3.884 B=16 Amper 6-19531997 Q=4 saniye K=2 2001 6.302

Q: 3 μ 6 µF a E = 36V 4 μF 24 µF 12 µF Consider the circuit shown in the figure. What is the charge for…

A:

Q: Black to 0.3 0.291 0.00882 3 -2.999 0.036 0.089 0.4 0.364 0.411 Anode -5.999 0.5 0.6 0.7 12 -11.998…

A: Multimeter- It is an electronic device which is used to measure different parameter like voltage,…

Q: Draw the architecture of SAP1 & SAP2 and write down the difference between them.

A: The architecture of SAP-1 Architecture of SAP-2

Q: (a) Describe the main sources of power loss in a digital integrated circuit. (b) Calculate the…

A: Since, we answer only upto 3parts.So the solution of first three parts are as follows : The major…

Q: Recording Instruments Select one: a. Instruments that records the measured value over a period of…

A: In this question we will define recording instruments...

Q: What is the required resolution of an instrument if the product characteristic specification is 10.0…

A: The number of bits or portions that the output or displayed reading from a sensor or measuring…

Q: How many valence electrons does a donor atom have? Please choose one: a. 3 b. 4 c. one D. 5

A: Donor atoms are belongs to group V in periodic table.

Q: 1. The number of turns on the primary and secondary windings of a 1-0 transformer are 350 and 35 If…

A:

Q: ANSWER IT IN CORRECT & Explain THANKS

A: Make a (2) titles about this project: [About 10-Watt Audio Amplifier Circuit LM1875] A. B. 2.…

Q: "If lab is equal to 290.9852320 and lb is 1682110, Ic should be

A:

Q: 20. (SP)) (S) performs: a. PUSH S b. РОP D c. None

A: The given instruction is: SP←S

Q: 1. How iron loss in transfomer is minimized 2. On Cwhaf bushing size and comstouction is depending…

A:

Q: Plot x[J and xBn-3]

A:

Q: The maximum number of electrons in each shell of an atom is O a. 2 O b. 8 O c. 2n? where n is the…

A: Electrons are very important as they constitute the flow of currents.

Q: Describe the difference between donor and acceptor impurities.

A: For the given question we have to write the differences between donor and acceptor impurities

Q: (iii) 110001.1102x 1011.0012 (iv) 1011011010.102 by 11012

A: Given, Two set of two binary numbers. (1) multiplication of two binary numbers      Result is…

Q: in el Eocs) / Ei (s)

A: The solution can be achieved as follows.

Q: What is the required resolution of an instrument if the product characteristic specification is 10.0…

A: Resolution is the smallest change that the instrument can measure.  It is the least count…

Q: A transistor is used as a switch and the waveforms are shown below. The parameters are given as…

A: Given  Transistor as switch and waveforms as shown  Vcc=200 vVCE(sat)=1 vICS=100 AICEO=1 mArise time…

Q: A resistor was measured 13 times at the same time conditions with the following results (in ohms):…

A: Measured resistance values is given by: R1= 100 ohm R2= 996 ohm  R3 = 990 ohm  R4 = 995 ohm  R5 =…

Q: 1.17 Test data from four components are given below. Each test consists of a complete traversal from…

A:

Q: 4. For 3 hours of pure music, determine the amount of storage needed to record based on 2 channels.…

A: For a pure music, given that: Time taken to play (t) = 3 hours = 3×60×60= 10800 seconds; Number of…

Q: Power across R1 Watts Power across RB = Watts Power across Diode Watts

A: In this question we need to find a power across R1 , RB & diode

Q: 10 16 BCD Gray 3-code 10110111 FD 1011001 91 111001

A: Value of binary to decimal is given by:-  Num1 = 27×1+26×0+27×1+25×1+24×1+23×0+22×1+22×1+20×1…

Q: The width of the semiconductor is depends on the amount of impurities added to it. Select one: True…

A: Semiconductor is a matter which have the conductivity between the conductor and insulator. By adding…

Q: A synchronous generator has a constant mechanical input power of Po. In the fault followed by the…

A: Given  A1=1.6 A2=0.4

Q: Germanium Silicon Vo v2 V1 RL 1k 15 mi

A: The given circuit is,

Q: is the Decimal equivalent of (0.235) O a 0.103 O b. 0.306 OC 0.113 O d. 0.224

A:

Q: What does gv(E) represent? Select one: O a. The number of electrons in the conduction band between…

A: In this question,  We need to choose the correct options What is gv(E) represention?

Q: four parts are selected randomly and without replacement, what is the probability they are all from…

A: Here it is asked to find the probability with the informations given. Here properties of probability…

Q: A resistor was measured 13 times at the same time conditions with the following results (in ohms):…

A: Given: The measured values of a resistance 13 times are,…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.