Caculde Q t for Hhe Otto Cycle AND desel cycle Using the following Conditions! Th= 2000 K Compression Ratro okto =10 Compression Ratio diesel = 15 Tc=423.15 K %D %3D Wner = Q Qc (heat ab sorbad i From Hot resorvior (het expelled to Cold re servxr Answer: 2. H(dresal) 1(otto) Otto: Pressure vs. volume C adiabatic process B - isochoric process D A volume (arbitrary units) Diesel: Pressure vs. volume в с adiabatic process - isobaric process D isochoric process A volume (arbitrary units) pressure (arbitrary units) pressure (arbitrary units)

Q: 10 Fig. (6) 8 MPa

A: Given Dataσx=8MPaθ=24°

Q: Consider the area shown in (Figure 1). Suppose that a=h=b=130 mm. Figure 1 of 1 h y=x Xy=11² Part A…

A:

Q: Consider the shaded area in (Figure 1). Take a 520 mm. Figure 150 mm 150 mm 100 mm 300 mm Determine…

A: The distance a=520 mm

Q: Write the formula used to determine the average shear stress?

A: shear stress is the stress produced due to shear force.

Q: Take P-21 kip (Figure 1) Figure 1 of 1 Part A Determine the average normal stress on the cross…

A: The average normal stress. Given: The load applied is P=21 kip.

Q: 34. Stress is given by the following formula: (choose correct sentences) a. 8 = 4 b. 8 == c. 8=Ex=…

A: Find  Stress is defined as. Types of Cast Iron

Q: Part A Locate the centroid y for the beam'os cross-sectional area. Express your answer to three…

A:

Q: Filler rod material is same base metal used in gas welding process. Select one: True False

A: Above statement is true.

Q: Part A If h = 340 mm, locate the centroid y of the cross-sectional area of the built-up beam.(Figure…

A: h=340 mmTo determine:The centroid

Q: Write the equation of the Centroid of an area?

A: The centroid of an area is the center of gravity of that particular area where the entire mass can…

Q: • Part A Determine the location j of the centroid of the beam's cross-sectional area. Neglect the…

A:

Q: How is the shear center determined?

A: Shear Center The shear center is a point on the section of the beam, from where the resultant load…

Q: When does the deflection of the beam become maximum?

A: The bending moment equation of the beam is given by the formula, M=EId2ydx2 Where,  y=deflection of…

Q: What is the ideal column?

A: An ideal column is one that is perfectly straight, made of a homogeneous material, and free from…

Q: A kick occurs because the pressure inside the wellbore annulus is higher than formation pressure. a.…

A: The kick formation depend on the pressure gradient in wellbore annulus and formation pressure.

Q: Grey cast iron, which contains between 2.5 and 4% carbon, has all or most of its carbon is…

A: We have to choose answer the above question