Ad.c. distributor is fed at both the ends. At feeding point A, the voltage is maintained at 235 v and B at 236 V. The total length of the distributor is 200 m and loads are tapped off as under: 20 A at 50 m from A 40 A at 75 m from A 30 A at 100 m from A 30 A at 150 m from A The resistance per kilometer of one conductor is 0.4 2. Calculate the currents per section, the minimum voltage and the point at which it occurs. Compute for the % voltage drop at this point of minimum potential.

Ad.c. distributor is fed at both the ends. At feeding point A, the voltage is maintained at 235 v and B at 236 V. The total length of the distributor is 200 m and loads are tapped off as under: 20 A at 50 m from A 40 A at 75 m from A 30 A at 100 m from A 30 A at 150 m from A The resistance per kilometer of one conductor is 0.4 2. Calculate the currents per section, the minimum voltage and the point at which it occurs. Compute for the % voltage drop at this point of minimum potential.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Pls do fast and i will rate instantly for sure Solution must be in typed form
I need answer within 20 minutes please please with my best wishes
The parameters of the _________equivalent circuit are defined in general terms for any operating conditions. a.hybrid-pi b.hybrid c.re d.pi
Explain the detailed process of Power Grid Extension
a) Classify the four categories of 3 phase power system faults we experience in our electrical power industry. b) Explain the emergence of such power systems fault as required in (question 1a)? c) Point out each type of fault specified under (a). d) Produce the (1D) design of the three-phase star connected faults stated under(b)
Give example scenarios in 'Power Grid Extension' and explain
EMF in a circuit is ____. a. Cause current to flow b. Maintains potential difference c. Increases the circuit resistance d. Decreases the circuit resistance e. None of the Choices
what is the receptacle load (after demand factors) for an office building with 250 receptacle outlets ? Explain
A final year project student, Raphael, learns in EEE307 that an oscillator circuit with a differential output can be built using single-ended tuned amplifiers like the one shown below: VDD C₁=R4₁ - Vout VinM₁ Fig. 3.1 Single-ended tuned amplifier schematic (image adapted from B. Razavi ©2012)
Transmission and distribution lines are important components of any power system study. Aluminium cable steel reinforced (ACSR) (with steel in the centre – as shown in Figure Q1 is normally chosen instead of copper for transmission Explain: (a)The choice of aluminium instead of copper (b)The need to use and place steel at the core
Analyse several voltage and current situations in different loading scenarios in a simplified radial (transformer to consumption) medium-voltage power system example. There are only 2 nodes in the 35 kV line – node 0 from the 110/35 kV and node 1 with one consumer. The physical characteristics of the line and the loading scenarios are individualized for each student – please see the attached file Excel “WM9P3 Task1 data” for your particular data set. Briefly reflect on the complexity of the calculations for known input or output voltage, as well as for fixed or voltage-dependent consumption in this simple power system model. Analyse and discuss the sensitivity of the voltage drop [in % of amplitude and the degrees of phase] with respect to the current level [in %] and to the power factor.
5