A·1600kg•carsuspension system·lowered·10 cm•when the chassis is fixed-on-it. Moreover, the oscillation-amplitude decreases by 50% each cycle. Calculate the- values of (a) the-spring constant-k| (b) the damping constant c-for the spring and shock-absorber system-of one wheel, assuming each wheel-supports -400-kg.¶ (c) the damping frequency of the system

A·1600kg•carsuspension system·lowered·10 cm•when the chassis is fixed-on-it. Moreover, the oscillation-amplitude decreases by 50% each cycle. Calculate the- values of (a) the-spring constant-k| (b) the damping constant c-for the spring and shock-absorber system-of one wheel, assuming each wheel-supports -400-kg.¶ (c) the damping frequency of the system

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A spring mass system with a natural frequency fn = 20 Hz is attached to a vibration table. Thetable is set to vibrate at 16 Hz, with a maximum acceleration 0.25 g. Answer the followingquestions. Justify your answers d. What is the maximum acceleration of the mass assuming the packaging can be modeled asa viscous damper with a damping ratio of 0.2?e. Is the motion of the mass in phase or out of phase with the motion of the table?
1. Mass suspended simple harmonic motion (measured from equilibrium position), displacement, velocity, and acceleration are x = 75mm, 450 mm/s, a = -442.5 mm/s^2. Period of Vibration and the amplitude of motion. 2. A uniform of rod of mass m = 3kg is supported by a pin at its midpoint c and is attached to a spring constant k = 120 N/m. If end A is given a small displacement, and released, determine the T of it resulting motion A k = 120 N/m = 3kg m = B
A 0.450kg mass oscillates at the end of a spring with the stiffness of 250 N/m. Thedamping force is proportional to the velocity –av and a= 8.50 kg/s. what is the frequencyof oscillation? What is the damping constant for a critically damped system?
A 0.600kg mass oscillates at the end of spring that has a spring constant of 300N/m. theinitial amplitude is 0.500m . the damping force is proportional to the velocity, -av. If theamplitude decreases from .50m to 350m in 2.50s . What is the damping constant ?Is thesystem underdamped, critically damped or overdamped?
A vibratory system consists of a mass 12.5 kg, a spring of stiffness 1000 N/m, and a dashpot with damping coefficient of 15 Ns/m. The value of critical damping of the system is (a) 0.223 Ns/m (b) 17.88 Ns/m (c) 71.4 Ns/m (d) 223.6 Ns/m
An underdamped shock absorber is to be designed for a motor cycle of mass 200 kg(m). When the shock absorber is subjected to an initial vertical velocity due to a road bump, the resulting displacement-time curve is to be as indicated below. Find the necessary stiffness and damping constants of the shock absorber if the damped period of vibration is to be 10 sec(τd) and the amplitude x1is to be reduced to one-eighth in one half cycle. Example is attached
As illustrated in the figure below, the bedplate of an experimental diesel engine is supported on four springs to isolate the vibrations from the test frame. The effective weight of the diesel engine and bedplate is 43kg and the stiffness of each of the four springs is 250 kN/m. Using a simplified approach - by applying Newton's Second Law assuming a single degree of freedom system and ignoring damping - what rotational engine speed is best avoided? Bedplate Test engine Supporting springs Figure: Sketch of a test engine mounting arrangement Give your answer in rad/s to 1 decimal place.
The spring index of a helical spring is calculated by the following: (a) Ratio of wire diameter to mean coil diameter. (b) Force per unit cross-sectional area of spring (c) Force required to produce unit deflection (d)Ratio of mean coil diameter to wire diameter. Which one is correct? O a. Option (a) only O b. Option (d) only Oc. Option (b) only O d. Options (C) & (d) only
Obtain X1(s)/F(s) and then determine the damping coefficient C of the mechanical system below. m2 =160.1 kg, k =953.7 N/m, k, =1,451.7 N/m, b, =148.0 N-s/m. X1(t) x2(t) k2 f2(t) m2 k, b2 massless plate Sonraki
a mass-spring-damper system has a mass of 100 kg. In 60 s, its free response apmplitude decays such that the amplitude of the 30th cycle is 20% of the amplitude of the 1st cycle. Estimate the damping constant c and the spring constant k.
Q.4 A damped single degree of freedom mass-spring system is excited at resonance by a harmonic forcing function which has an amplitude of 40 N. The system has mass m of 3 kg, a stiffness coefficient k of 2700 N/m, and a damping coefficient c of 20 N·s/m. If the initial conditions are such that xo = 5 cm, and xo = 0, determine the displacement, velocity, and acceleration of the mass after t = 0.2 s.
A damped single degree of freedom mass-spring system is excited at resonance by a harmonic forcing function which has an amplitude of 80 N. It was observed that the steady state amplitude of the forced vibration is 6 mm. It was also observed that when the frequency of excitation is three times the natural fre- quency of the system, the amplitude of the steady state vibration becomes 1 mm. Determine the stiffness coefficient k and the damping factor š.