(a) What is the physical significance of energy of activation ? Explain with diagram.(b) In general, it is observed that the rate of a chemical reaction doubles with every 10 degree rise in temperature. If the generalization holds good for the reaction in the temperature range of 295 K to 305 K, what would be the value of activation energy for this reaction ?[R = 8.314 J mol-1 K-1]

Q: What is the reaction A,? 600 N 60° A 2 m- 2 m

A:

Q: An electron has a constant acceleration of 3.2 m/s², At a certain instant, its velocity is 9.6 m/s.…

A: Given data: Acceleration, a=3.2 ms2 Velocity, v=9.6 ms Time, t = 2.5 s

Q: There is a hollow spherical conductor. There is a charge q inside, surrounded by an uncharged…

A: Step 1:Step 2: Step 3: Step 4:

Q: A particle starts from rest at a position x(0) = 0. Find the velocity v(t) and position y(t) of the…

A: To determine the equations for velocity and position of a particle with the given acceleration…

Q: When Ethanol is burn in the presence of Oxygen. Carbon Dioxide (CO2) and water (H2O) molecules are…

A: Given data-

Q: tank of carbon tetrachloride has a mass of 784 kg

A:

Q: A gas undergoes a cycle in a piston-cylinder assembly consisting of the following three processes:…

A:

Q: A gas is compressed under isothermal condition. The change of pressure is from 800 atm. to 803 atm.…

A: given Isothermal conditionchange in pressure=800 atm to 803 atm

Q: In wastewater treatment plants, ammonium ion is removed from the water by raising the pH to form…

A: a) The equilibrium reaction that describes the process of ammonium conversion to ammonia is given as

Q: Question 36 The EMC represents a region where properties of the wood begin to change. Select one: O…

A:

Q: FIND THE REACTION

A:

Q: A certain parallel-plate capacitor is filled with a dielectric for which k = 6.50. The area of each…

A: (1) Deelectric constant(2) Area of each plate(3) Distance between plates(4) Electric field between…

Q: An elementary particle produced in a laboratory experiment travels 0.319 mm through the lab at a…

A: Step 1:Distance travelled by the elementary particle is 0.319mmRelative speed is 0.953cStep 2:The…

Q: AB = 7000 Ib 30°

A:

Q: Air undergoes a polytropic process in a piston-cylinder assembly from p₁ = 1 bar, T₁ = 295 K to p2 =…

A:

Q: If the reaction rate coefficient of BOD is 0.3 1/d at 20 oC, what will it be if the temperature is…

A:

Q: 1. The symbol of Helmholtz free energy is

A: To find : Helmholtz free energy is denoted as.

Q: Please help me solve these 2 problems for my homework

A: PROBLEM 1. 1. Carnot Efficiency (η):Carnot efficiency relates the temperatures of the hot and cold…

Q: 6. Radium decomposes at a rate proportional to the amount present. In 100 years, 100 mg of radium…

A: To determine: amount of Radium left after given time half-life of radium   Given, Initial amount…

Q: Period 6 is unusual in several ways.(a) It is the longest period in the table. How many elements…

A: Period 6 accommodates a total of 32 elements from Cesium (At. No. 55) to radon (At. No. 86). Out of…

Q: Consider a copper wire with a diameter of 1.99 mm. (a) What is the drift speed of the electrons in…

A: The answer provided follows the correct methodology for calculating both the drift speed and the…

Q: The radioactive isotope of lead, PB-209, decays at a rate proportional to the amount present at time…

A:

Q: C A D B E 10 cm 40 cm 40 cm 10 cm vo uniform rods AB and CE, each of weight 20 N and length 1 m, e…

A: W=20N L=1m

Q: Question 2: True or False? Please give simple reason for each of them. (1) Diffusion is a time and…

A: (1) True. Diffusion is a time and temperature-dependent phenomenon by atomic transport. Diffusion…

Q: Suppose you have a "box" in which each particle may occupy any of 10 single-particle states. For…

A: For two identical fermions, the 10 possibilities to put both fermions in the same single-particle…

Q: Steam in a piston-cylinder assembly undergoes a polytropic process, with n = 2, from an initial…

A: Given data:Initial specific volume, V1​=1.75440ft3Initial pressure,  p1​=450lbf/in2Initial specific…

Q: Determine the magnitude of the reaction By (N) of the figure shown. 4 /2.000 N 400N/m 1.5 m B. 600…

A: Given:- To find:- Reaction at B

Q: Henry's law constant for transferring 02 from air into water, at room temperature, mmol - is 1.3…

A: Given data: Henry's law constant at room temperature, k = 1.3 m-mollt-atm Partial pressure, P = 0.21…

Q: In an ion exchange process, which ion has a higher affinity for exchange: Potassium ions (K+) or…

A: Calcium ions has a very high affinity. According to the  general principles  The higher the charge,…

Q: Two particles each have a mass of 6.1 x 10-2 kg. One has a charge of +5.0 x 106 C, and the other has…

A:

Q: A brass rod and an aluminum rod are 90.00 cm and 90.06 cm, respectively, at 20°C. At what common…

A: At what common temperature will the two rods be exactly the same length?

Q: Assume an ideal-gas equilibrium holds for the following reaction: SO2 + 02 + SO3 Draw a qualitative…

A:

Q: Determine the number of protons and neutrons in each isotope Na 11 protons, 12 neutrons O 12…

A:

Q: Sel 10 only: 1. Which one has low Si + Al elements, land Earth crust or oceanic Earth crust? 2.…

A: 1) heavier minerals are found in lower parts of crust. But mineral like Al are not found in oceanic…

Q: What is the calculated value of the cell potential at 298K for an electrochemical cell with the…

A: Solution; Given Data; EAg+/Ay=+0.80,  E°Al3+/Al=-1.66 vTherefore  E°ceu=+0.80-(-1.66)…

Q: Q) Determineif each statement is true or false. If false, correct/rewrite the statement which is…

A: Given :- concentration gradient is ratelf change of gradient with respect to time in steady state…

Q: Find the smallest value of P for which the 400-lb crate in the figure below will be in equilibrium…

A: FBD of the given problem:

Q: Hydrogen is allowed to diffuse through a palladium plate that is 0.008m thick at 500°C. The…

A: The concentration gradient (dC/dx) across the plate can be approximated by, dxdC​=ΔxC2​−C1​​…

Fluid Materials

In general terms, anything that flows can be termed as a fluid. In other words, a fluid is any substance that cannot resist shear forces and deforms continuously under the application of external shear forces. Fluid materials differ completely from solid materials such as metals and alloys. For instance, if we consider two infinitesimally small cross-sectional areas of fluid materials and solid materials, and apply shear forces to these elements, both the elements will undergo deformation. Upon releasing the shear force, the element of the solid materials will regain its original orientation, but the element of the fluid materials will keep on deforming continuously under the action of the shear force.