(a) What is the cost of heating a hot tub containing 1510 kg of water from 10.0°C to 40.0°C, assuming 75.0% efficiency to take heat loss to surroundings into account? The cost of electricity is 9.00¢/(kW · h) and the specific heat for water is 4184 J/(kg - °C). (b) What current was used by the 220 V AC electric heater, if this took 4.95 h? Additional Materials O Reading

Q: When initially at 25 C, the power being supplied to a 555 Ohm resistor in a circuit is 7.5 W. Over…

A:

Q: A Cu wire of diameter of 2 mm and length of 1 m initially at room temperature of 300 K is applied a…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: A solar cell has a light-gathering area of 10 cm² and produces 0.2 A at 0.8 V (DC) when illuminated…

A:

Q: A common flash focus is rated at 310 mA and 2.90 V, the respective current and voltage values under…

A: Current is Voltage is Resistance of filament at temperature  is The coefficient of expansion for…

Q: The resistance of a wire is given by R = Ro[1+ a(T – T.)] where T. - 20 °C, R. = 6 N ± 0.3 % is the…

A: Formula for resistance; Base temperature Resistance at base temperature Temperature coefficient…

Q: A resistor is wired to a battery in a circuit and dissipates a power P1 as heat.  A second resistor,…

A: Given, Power dissipated by single resistor= P1 The power dissipated by two resisters when in series=…

Q: 13-V storage battery delivers current at the rate of 59 A. In a 25 min period, the heat lost from…

A:

Q: ating appliance uses a current drawn from a 110-V line. (a) What is the resistance of the heater?…

A: GivenPower, P=200 WV=110 V

Q: Q4. A piston-cylinder device initially contains 0.5 m3 of 1.1-kg saturated liquid water and steam…

A: Given:m=…

Q: In preparation for a study of the metabolism of an organism, a small, sealed calorimeter was…

A:

Q: The current I is measured through a sample of an ohmic material as a voltage V is applied. (a) What…

A: Given data: The original voltage is: V The new voltage is: V’ The original current is: I The new…

Q: Q 8. (a) Show the linearized temperature dependent expression for resistance of thermistor and…

A: Given Nominal resistance R0     = 800 Ω Nominal temperature T0 = 15 + 273 = 288 K Specific…

Q: Determine the monthly electric bill of an apartment unit with appliances used as shown In the…

A: The formula for energy consumed by electrical appliances is: Now, using the formula of energy, the…

Q: 7. 6. 650 J of energy are converted into heat in 2 minutes. What power is dissipated? Find the power…

A:

Q: A resistor is wired to a battery in a circuit and dissipates a power P1 as heat. A second resistor,…

A: Dissipated power P =I2R where I is the current flowing R is the resitance In first case, where only…

Q: How much time is needed

A: Given data: The mass of tissue is: m1  = 1g The mass of water is: m2 = 0.5 g The initial temperature…

Q: Current has a heating effect due to the law of conservation of energy. A sealed container containing…

A: If I is the current and V is the voltage ,the heat energy produced in t second due to the current…

Q: At a cost of 9.0 cents/kWh estimate how much this would add to your monthly electric energy bill if…

A:

Q: A typical flash bulb is rated at 310 mA and 2.90 V, the respective values of current and voltage…

A: Page 1

Q: When a 200 ohm resistor, a 300 microfarad capacitor (uF) that's initially uncharged, and a 6-volt…

A:

Q: A heating element in a stove is designed to dissipate 3,475 W when connected to 240 V. (a) Assuming…

A: We have been given that Power (P) = 3475 Winitially V = 240 Volt

Q: Two cities separated by 10,000 ft is connected by telephone wires whose thermal coefficient of…

A:

Q: Compute the cost per day of operating a lamp that draws a current of 1.80 A from a 110 V line.…

A: It is given that

Q: A heating element in a stove is designed to dissipate 2,960 W when connected to 240 V. (a) Assuming…

A: Given Power dissipated in the heating element is P=2960 W Voltage is V=240 V Find the current in the…

Q: Integrated Concepts(a) What is the cost of heating a hot tub containing 1500 kg of water from 10.0oC…

A: (a) Required heat energy is, Q=mcΔT Q=1500 kg4186 J·kg-1·°C-1   =188.4×106 J Rate of cost of…

Q: A two-dimensional conduction resistance and heat rate may be expressed as Rt = and q = SAT₁-2…

A: So, the given formula is of Shape factor (q) which is defined as a measurement of the direct…

Q: In the circuit shown, R,=R,=R, and ɛ2 =. The rate of heat dissipated by the whole circuit is 110…

A: From the given circuit diagram, when the batteries are ideal,

Q: ne 9-volt battery contains 19.7 thousand joules of energy.  A 4-pack of 9-volt batteries cost $10.31…

A: The energy in one battery E =19.7×103 J Total energy of 4 pack 9V battery is 4E The power is 1 Watt…

Q: The resistance of copper wire (with a = 0.00393/C° at 20°C is 119 0. At 60 °C, its resistance would…

A:

Q: A heater is rated to dissipate 2880 W when connected to a 120 V source. The current drawn by the…

A: Given P = 2880 W V = 120 Volts We have  P = V*I

Q: In the circuit shown, R,=R,=R, and &2 = The rate of 2 heat dissipated by the whole circuit is 440 W.…

A: For the given circuit we need to find the power absorbed or supplied by the battery ε2.

Q: a current of 1.50 A at a voltage difference of 5.00 V is passed through the cell for 101 minutes,…

A:

Q: if the heat capacitance for a Container of Aluminum is 270 J/Co and the specific tempreture of…

A:

Q: An immersion heater utilizing 120 V is used to raise the temperature of a 100 g aluminum cup…

A: Total energy supplied by heater is as follows: Et=E1+E2+E3+E4…

Q: 10. A 2 kW kettle containing 1.7 litres of tap water at 15°C is plugged in to the mains (220 V). The…

A: Since you have posted a question with a multiple sub parts, we will solve first three sub - parts…

Q: The conductivity of the material given below is a S/m. Find the resistance between the shaded…

A: