a) What is the complex power drawn and delivered by the transformer? (b) Draw a per-phase equivalent circuit diagram showing the R1eq resistance and X1eq reactance on the primary side. Calculate the values of these equivalent circuit components. (c) Calculate the losses of the transformer delivering 1500 kVA at a power factor of 0.82 lagging

Q: What is the main advantage of autotransformers over conventional power transformers? Explain…

A: Dear student, Since you have posted multiple questions, we will provide the solution only to the…

Q: A 10 kVA, 2400/240 V, 60 Hz single phase transformer has Z, = 5.2 + j12.5 ohms and Z2 = 0.06 + j0.12…

A: In this question,  We need to calculate the load voltage if Primary voltage and frequency is rated.…

Q: 4.27 A 10-kVA, 4160/240-V, single-phase transformer has a per-unit resistance of 0.01 and a per-unit…

A:

Q: Equivalent circuit diagram and electromotive force phasor for the idle operation of a step-up phase…

A: A transformer is a static device, it consist of two winding interlinked by common magnetic circuit…

Q: 9. In the design of current transformers, compensation for ratio errors is accomplished by using A.…

A:

Q: Consider a single phase 2-winding 150 kVA, 2400/240 V, 60 Hz transformer with Reg = 0.00425 N, Xeq =…

A: In this question,  Find the efficiency of the transformer If it's operated at rated current and…

Q: Discuss the role of transformers in power distribution. How do step-up and step-down transformers…

A: Transformers are electrical devices which used to change the voltage levels with constant power and…

Q: A transformer on no-load has a core loss of 50W flows a current of 2A (rms) and has an induced emf…

A: The given data is shown below:Neglect winding resistance and leakage flux.

Q: describe the application of transformer oil in power system equipments.

A: Transformer: Transformer is an electric device. It is also known as static device as it doesn't have…

Q: If the open circuit voltage is 227V and the full load voltage is 207V, then the percentage…

A:

Q: ou are employed in transformer fabrication unit. You have to design core of transformer. With regard…

A: Transformer: Transformer is an electrical static device works on the principle of electromagnetic…

Q: A 400/200 volts transformer has pu impedance of 0.05. The HV side voltage required to circulate full…

A: Per unit impedance Z=0.05 pu, 400/200 volts transformer- To Find- The value of the HV side voltage…

Q: How to generate 480V three phase 400Hz ac from 230V three phase 60Hz ac source? (Please specify the…

A:

Q: An 11,000/230-V, 150-kVA, 50-Hz, 1-phase transformer has a core loss of 1.4 kW and full-load Cu loss…

A:

Q: The statement given in which option related to transformers is wrong. A) Power transformers are used…

A: Statement true and false All statement are releted to Transformer .

Q: d) Explain the principle of Merz prize system of protectio used for power transformers. What are the…

A: EXPLAIN: the principle of Merz prize system of protection used for power transformers.…

Q: 1. The RMS value of induced emf in the primary N1 winding is E1 =; E2 = 2. In ideal transformer on…

A:

Q: A single phase transformer has a voltage transformation ratio of 0.4. The resistance and reactance…

A:

Q: A single-phase transformer (assumed to be ideal) with the rated values are given in the figure, is…

A: Two winding transformer rating given S=11KVA Voltage ratings 2200/220V After change in auto…

Q: Explain the importance of transformer and basic insulation level in the distribution system. Justify…

A: The detailed answer to the given question is solved below according to the given parameters and…

Q: The inr - The inr - The inru w residu.

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: A 4 MVA, 66/13.2 Kv, 50 Hz , Delta star connected Three phase transformer has a primary resistance…

A: Question A 4 MVA, 66/13.2 Kv, 50 Hz. Delta star connected Three phase transformer has a primary…

Q: equivalent winding (a) resistance,(b) reactance and (c) impedance referred to the high voltage side.

A:

Q: current flowing in the of a transformer creates an alternating which establishes an alternating flux…

A:

Q: 2) A single -phase power transformer of 150 MVA, 15/200 kV has a Resistance in unit of 1.1% and…

A: Given: 150 MVA 15/200 KV, Single phase Power transformer Resistance per unit R = 1.1% = 0.011…

Q: A 3-phase transformer, ratio 33/6.6-kV, A/Y, 1-MVA has a primary resistance of 8.5 ohms per phase…

A: 3 phase,E1=33kv,E2=6.6kv,Rating of transformer=1MVA,Primary resistance=8.5ohms,Secondary…

Q: List and describe three (3) losses that occur in power transformers.

A: Losses in power transformers: Iron Losses Copper Loss or Ohmic Loss Stray Loss

Q: 2) 50 kVA, 2300 V / 230 V transformer draws 750 W power and 0.5 A current at rated idle primary…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: 4. Write a conclusion for the experiment, stating the role of core loss.component and magnetizing…

A:

Q: A 4 MVA, 66/13.2 Kv, 50 Hz , Delta star connected Three phase transformer has a primary resistance…

A: The given transformer is a 3 phase transformer with primary side in delta connection and secondary…

Q: Problem 2. A 150-MVA, 220/22-kV, three-phase has the following parameters (in 2): R2 = 0.001 X, =…

A: In the question,  All parameters are given of transformer.  Determine the equivalent circuit…

Q: Consider a single phase transformer of rating 150 KVA, 1500/150, 50 Hz. Let the series resistance…

A: Given: Z1=R1+jX1=0.2+j0.45 ΩZ2=R2+jX2=0.002+j0.0045 ΩKVA=150

Q: Q- Electrical machines A single-phase 100 kVA, 1000 V/100 V, 50 Hz transformer has a voltage drop of…

A: Given- Single-phase 100 kVA, 1000 V/100 V, 50 Hz transformer. Voltage drop across series impedance…

Q: The hysteresis and eddy-current losses for a 75-kVA, 480-120 V, 60-Hz transformer are 215 W and I 15…

A: find the explanation below

Q: A 4 MVA, 66/13.2 Kv, 50 Hz , Delta star connected Three phase transformer has a primary resistance…

A: VOLTAGE REGULATION: Voltage regulation is related to variation in the transformer output voltage as…

Q: Two transformers A and B are connected in parallel to a load of (2+j1.5) ohms. Their impedances in…

A: Given,ZL = 2+j1.5  ΩZA=0.15+j0.5 ΩZB=0.1+j0.6 ΩEA=207 VEB =205 V

Q: a 5kva, 757v/ 420V, single-phase transformer has the percentage regulation drops 4%. determine the…

A: KVA rating is given  S = 5 KVA. Primary voltage with no load E1=757 V. Secondary voltage with no…

Distribution System

The final stage in the delivery of the electric power is the electric power distribution system. From the transmission system to the individual customers it carries electricity. The distribution system is connected with the transmission system and is used to lower the voltage of the transmission to medium voltage in the range of 2 kV to 35 kV with the help of transformers. This medium voltage to the distribution transformers located near the customer's premises is carried by the primary distribution system lines. These distribution transformers in turn lower the voltage to utilization voltage used in lightings, household appliances, industrial equipments etc. Through secondary distribution lines often several customers are supplied from one transformer. It is through service drops, the commercial and residential customers are connected to the secondary distribution system lines. Customers who demand a larger amount of power can be connected directly to the primary distribution system level or the sub-transmission level.