a) What are the four heat fluxes (Q) across the sea surface?b) complete the labels for all curves below.0.8green:0.6red:0.2blue:8-0.0magenta:-0.2-0.480°S60°S 40°S 20°S0°20°N40°N60°N 80°NLatitudeHeat input per 1° latitude band (PW)

Four heat fluxes: Short-wave solar radiation, Sensible heat flux, latent heat flux, long-wave…

Answered: a) What are the four heat fluxes (Q)…

a) What are the four heat fluxes (Q) across the sea surface? b) complete the labels for all curves below. 0.8 green: L 0.6 red: 0.2 blue: -0.0 magenta: input per 1° latitude band (PW)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

2.136 The air velocity in the duct of a heating system is to be measured by a Pitot-static probe inserted into the duct parallel to the flow. If the differential height between the water columns connected to the two outlets of the probe is 2.4 cm, then the flow velocity (in m/s) at the tip of the probe is The air temperature and pressure in the duct are 45°C and 98 kPa, respectively. Take the density of water to be p = 1000 kg/m³ and the gas constant of air is R = 0.287 kPa m³/kgK. (Correct up to one decimal place)
A flat sheet is in the shape of a rectangle with sides of lengths 0.400 m and 0.600 m. The sheet is immersed in a uniform electric field of magnitude 60.0 N/C that is directed at 20° from the plane of the sheet (Figure 1). Figure 20% 0.400 m * -0.600 m- 1 of 1 Part A Find the magnitude of the electric flux through the sheet. Express your answer with the appropriate units. O Þ= 4.9 μA 4 m² N с ? The compound unit you entered is not recognized. Review a list of acceptable units. No credit lost. Try again.
A line was determined to be 354.7654 m when measured with a 50-m steel tape supported throughout its length under a pull of 4.567 kg at a mean temperature of35.495°C. Tape used is of standard length at 20.0°C under a pull of 5.435 kg. Cross-sectional area of the tape is 0.036tcm2. Coefficient of thermal expansion is 0.00001160/'C. Modulus of elasticity of tape is 2x106 kg/cm2. Determine the corrected length of the Line.
Estimate the vapor pressure, air pressure, relative humidity, and air density at a height of 1800 m into the atmosphere. The total pressure is 101 kPa, air temperature is 25°C and the dew point temperature is 15°C near the ground, the lapse rate 7.5°C/km, which is constant for both air temperature and dew point temperature. The gas constant R is 287 J/kg-K and constant with respect to altitude. Vapor Pressure at 1500m, in Pa Round to the nearest whole number Add your answer
A line was measured with a 50-m tape which was found to be 532.28 m. the tape is known to be of standard length at 20°C with coefficient of thermal expansion of 0.0000116 m/°C. If the corrected length of the measured line is 532.37 m. long, at what temperature was the measurement made?--. 3.
3. A line was measured with a 50-m tape which was found to be 532.28 m. the tape is known to be of standard length at 20o C with coefficient of thermal expansion of 0.0000116 m/o C. If the corrected length of the measured line is 532.37 m. long, at what temperature was the measurement made?
Calculate the change in 5 m long copper wire when its temperature changesby 60º C.
Situation:A 50m steel tape was standardized and supported throughout its whole length and found to be 0.00329m longer at an observed temperature of 41.6 degrees C and a pull of 12 kilos. This tape was used to measure a line that was found to be 683.21m at average temperature of 49 .8 degrees C at the same pull. Coefficient of the thermal expansion in 0.000016m/m degrees C. -DETERMINE THE STANDARD TEMPERATUREa. 35.93 c. 50.76b. 44.63 d. 68.25-WHAT IS THE CORRECT LENGTH OF THE LINE?a. 633.88 c. 638.23b. 663.28 d. 683.32
2) The temperature distribution in the square chimney is to be analyzed by the finite difference method. Determine the temperature at the nodes of the grid shown. T120 °C T-400 °C 6 cm 12 cm 18 cm
9. What is the direction of the induced current in each scenario below? Acceptable answers are: Clockwise, Counterclockwise, and no induced current. In scenario C, the loop does not cross the wire. In scenario F, the magnetic field only exists in the region outlined by the dashed lines creating a square. A. B. Loop Loop A B C Loop C. D. D E. F. Magnet moving down Loop E Magnet moving S down I Loop Bexternal Area of loop decreasing Current I decreasing in magnitude F I Loop moving down O Loop Be external Angle theta starting at 90 and decreasing to 0 degrees
Match each Question with the correct answer. v Wind farms offshore A. performance line B. v Power coefficient B. is the overall operating characteristics of a wind turbine v The wind speed experienced by a wind turbine C. hydrograph v For estimating the likely energy yield of a site D. mean wind speeds are usually measured with an averaging period of 1 hour v The energy of a hydro scheme E. diffused radiation v flow in a river are described wither by a time series of average daily flow F. proximate analysis G. made up of mean wind speeds, extreme wind speeds and variations in wind speeds v The head and flow of water v run-of-river schemes H. has higher mean wind speeds v Dark wall of large thermal mass separated from a glazed surface by a small airspace 1. azimuth angle greater than 90° v Estimate the future energy consumption for heating or cooling J. руrolysis v Number of heating degree days against the energy consumed in that month K. moisture content L. maximum energy output at the…
Estimate the vapor pressure, air pressure, relative humidity, and air density at a height of 1500 m into the atmosphere. The total pressure is 100 kPa, air temperature is 28°C and the dew point temperature is 16°C near the ground, the lapse rate 6°C/km, which is constant for both air temperature and dew point temperature. The gas constant R is 287 J/kg-K and constant with respect to altitude. Air Density at 1500m, in kg/m3 Round to three (3) decimal places