A: What are the five primary types and functions of Portland cement? Describe an application for each type. B: A center-point loading flexural test was performed on a concrete beam with a cross section of 100 mm * 100 mm and a span of 200 mm. If the failure load was 26.9 kN, find the flexure strength. Find the Split tension strength on 150 mm * 300 mm cylinder with failure load 237.2 kN.

Q: A B Rate of deformation, duldy Shear stress, 7

A: There are several properties defined for fluid such as density, specific gravity, viscosity, etc. In…

Q: A cylinder has a of 0.35 MPa. What i

A: The minimum allowable thickness is thickness of sheet required to sustain pressure of system

Q: A machine rotates at 8800 rpm and decelerates at 95 rad s^-2 . Find how long it takes the machine to…

A: The objective of the question is to find out the time it takes for the machine to stop from its…

Q: 3. Define the hydraulic and energy grade lines, and explain the method of calculating and drawing…

A: It is asked to define the Hydraulic grade line and energy grade line  and explain the method of…

Q: pipe, g/cm', and the melt has a dynamic viscosity of 3.12 g

A: 1. diameter= 10cm = 10*10-2m 2. Density = 7.8 g/cm3= 7800 kg/m3 3. dynamic viscosity= 3.12g/ms=…

Q: 3.) A steel bar 100 mm long and having a square cross section 20 mm on an edge is pulled in tension…

A: Given: Length of steel bar=100 mm=100×10-3mCross section of the steel bar=20 mm=20×10-3mForce=89000…

Q: A single crystal is oriented such that the normal to the slip plane and the slip direction are at…

A: Angle between normal to slip  = 60 0 Angle of slip direction = 350 Critical resolved shear stress =…

Q: The following creep data were taken on an aluminum alloy at 48 °F) and a constant stress of 0 psi).…

A: Given -creep strain vs time data for an Al alloy at a certain stress and temperature  To find steady…

Q: (b) The general characteristics of three oil wells selected for artificial lift as production method…

A: Table of 3 well are given.

Q: Compare S.I and C.I engines with respect to fuel used

A: CI engine - Compression ignition engine SI engine - spark ignition engine

Q: 10. A 6,000 lb of a material goes through a crusher and grinder per hour in succession (on the same…

A: Given that- Mass flow rate of material is,  m= 6000 lb/hr=6000 lbhr× 1hr3600 s=1.666 lb/s Rittinger…

Q: 1. Calculate the surface per unit volume in square centi- meters per cubic centimeter of galena…

A: Mesh%…

Q: The strain of a component, which has a tensile modulus of 6 X 105 MPa, and subjected to a stress of…

A: The strain of the component with the given tensile modulus is to be determined.