A water supply system is being designed to serve a new community with an expected population of 28,000 people. The community will also have a 40,000 square foot auditorium, built of fire-resistive construction. What should be the design flow capacity of the main distribution pipeline (gpm)? What is the needed fire flow (gpm) and duration (hr)? What volume of reservoir or storage tank is required (gal)? Design flow capacity (gpm): .756 Needed Fire Flow (gpm): 17.05 NFF Duration (hr): 39.22 Reservoir capacity (gal): 20.25*10*8

A water supply system is being designed to serve a new community with an expected population of 28,000 people. The community will also have a 40,000 square foot auditorium, built of fire-resistive construction. What should be the design flow capacity of the main distribution pipeline (gpm)? What is the needed fire flow (gpm) and duration (hr)? What volume of reservoir or storage tank is required (gal)? Design flow capacity (gpm): .756 Needed Fire Flow (gpm): 17.05 NFF Duration (hr): 39.22 Reservoir capacity (gal): 20.25108

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: The radius is increasing at mi/hr.

Q: a) The temporary storm storage reservoir mention in task (Concern has been expressed at the local…

A: Given: L = 2,050 m (pipe length) f = 0.011 (Darcy-Weisbach friction factor) Q =100 m3/s (maximum…

Q: A pump operating at 2,304 rpm delivers 188 gpm at 98 ft head. If the pump is operated at 2,121 rpm,…

A: N1=2304rpmQ1=188gpmh=98ftN2=2121 rpmQ2=?

Q: Determine the maximum flow rate for a bleed-down orifice designed to discharge half of a 12.39 ac-…

A: Q = half of 12.39 ac ft t =24 to 30 hours

Q: 39 286 7.900 Determine the possible flow into MH DI from the WWS piping in Chesapeake Bay, which is…

A: Total sewage flow per person = 1200 L/day / 3.1 = 387.1 L/day/personTotal flow into MIH DI ≈…

Q: What is the energy loss if a DN65 Schedule 40 steel pipe flows into a large resevoir at a flow rate…

Q: briefly explain why there is flow observed in the sewer when there is no rainfal

A: INTRODUCTION: Sewer system is designed to transport the waste water . runoff water from the…

Q: During heavy rainstorms, sewer systems in some older cities can be overwhelmed with water. This can…

A: The various impacts of sewage being discharged into waterways are: Now a day’s there is an…

Q: estion about Sanitary Engineering Question: A Water supply scheme has to be designed for a city…

A: The major types of drafts that may be required to be recorded for an average water consumption of…

Q: Determine the required fire flow for a three storeys wood building covering 750 m which connects…

A: Given: The 3 storey building covering area is 750 m2. The 5 storey building covering area is 900 m2.

Q: The sewage collection system is comprised of pipes of three diameters of 1.00m, 0.50m and 0.10m,…

A: Given Data: Diameter of pipe 1 is d1=1 m. Diameter of pipe 2 is d2=0.5 m. Diameter of pipe 3 is…

Q: You are given a task to design a water treatment plant for treating 30 000 m³/d water from screening…

A: The screen chambers consists of a rectangular channel. The flow of the channels is normally 7-15cm…

Q: You have been selected to design a sewer system for a town of 15000 people. If the average domestic…

A: The following design flow of the sewer is estimated by considering flow from domestic sewage only.

Q: A wastewater treatment plant receives, at an average, 75% and 125% of water supply during dry and…

A: Given Data: The average municipal water demand (Liter per capita day)=550 lpcd Do the following to…

Q: Answer question 3-9.Hint – Do not create a route which passes through the bridge (lower right side)…

A: In a solid waste collection process, truckrouting is an important aspect to minimizethe total…

Q: During the winter storm of February 13 to 17 2021, the power company of City of Birds, requested the…

A: Elevation of water at lake birds (ha) = 50 mElevation of water at storage tanks (hb) = 100 mLength…

Q: A rapid sand filter unit has to supply 40 million litres of water per day. 4% of filtered water is…

Q: Determine the footprint area (in ft²) needed for a proposed primary clarifier at a wastewater…

Q: Minimum 10 scholarly sources Question 2 Centralized versus Decentralized WWT systems (3000 words)(a)…

A: The objective of the question is to understand the preference for decentralized wastewater treatment…

Q: QUESTION 4 Water at 10 C flows in a 1.3-cm-diameter pipe at a rate of 1.33 L/min. The hydrodynamic…

A: D = 1.3 cm or 0.013 m Q = 1.33 L/min

Q: Specify a suitable size of new, clean Schedule 40 steel pipe that would carry 300 gal/min of water…

A: A clean Schedule 40 steel pipe is given Discharge, Q = 300 gal/min = 0.668 ft3/sec Length, l = 1200…

Question

100%

A water supply system is being designed to serve a new community with an expected population of 28,000 people. The community will also have a 40,000 square foot auditorium, built of fire-resistive construction. What
should be the design flow capacity of the main distribution pipeline (gpm)? What is the needed fire flow (gpm) and duration (hr)? What volume of reservoir or storage tank is required (gal)?
Design flow capacity (gpm):
.756
Needed Fire Flow (gpm): 17.05
NFF Duration (hr):
39.22
Reservoir capacity (gal): 20.25*10^8

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the maximum population that can be served by an 8-in. sanitary sewer laid at minimum grade using a design flow of 400 gpcd (gallon per capita per day) and a flowing-full velocity of 2.0 ft/sec? (b) Compute the diameter of a storm drain to serve the same population based on population density = 30 persons per acre, coefficient of runoff = 0.40, 10-year rainfall frequency curve, a duration (time of concentration) = 20 min, and a velocity of flow = 5.0 ft/sec.
solve parts 8,9 & 10
A lateral sewer is to be designed to receive flow from 30 acres of a city in an area wherethe population density is 150 people per acre. If the average per capita flow rate is assumedto be 100 gpcd, what should be the design flow rate of the lateral, in gpm and cfs?
Need the answer
Question 4 The following is relevant water demand information for the town of Goodborough for the design year of 2050: Design Population = 10000 Annual average per capita water demand = 250 L/d Assume a water supply system of Type A (NO storage) is considered for the town, determine the following to meet the water needs of the community in the design year, as per Ontario guidelines A) WTP capacity needed to meet needs with NO fire (in ML/d; ignore losses) B) WTP capacity needed to meet needs with fire (in ML/d; ignore losses) C) Design capacity of the WTP (in ML/d; ignore losses)
The sewage from an area of 400.79 or take it 400.8 acres is to be carried by a circular sewer at a velocity not less than 3.0 fps. Manning's n = 0.013. The population density is 16 persons per acre. Considering average water use is 160 gpcd of which 70% flows as sewage water. Find the maximum hourly and minimum hourly flows Determine the pipe size required to handle these flows and the required slope.