A wall of m height retains a backfill of dry granular soil that has a level surface and weighs 20 kN/m³. When there is no surcharge above the fill, the overturning moment caused by the total active pressure at a point at the base of the wall is 125 kN-m/m length of the wall. The specifications permit certain amount of uniformly distributed surcharge but state that surcharge must not increase the overturning moment by more than 50%. What surcharge can be allowed if the angle of wall friction is 20° ?

A wall of m height retains a backfill of dry granular soil that has a level surface and weighs 20 kN/m³. When there is no surcharge above the fill, the overturning moment caused by the total active pressure at a point at the base of the wall is 125 kN-m/m length of the wall. The specifications permit certain amount of uniformly distributed surcharge but state that surcharge must not increase the overturning moment by more than 50%. What surcharge can be allowed if the angle of wall friction is 20° ?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

determine the upward seepage force if the Gs=2.6. determine the inter-granular stress at point A if the Gs=2.6.
List down in correct chronological order the necessary water treatment plan processes. Define the purpose of, and describe each process.
A retaining wall with a smooth vertical back retains silt backfill for a depth of 6 m. The backfill has a horizontal surface having following properties c'= 10 kPa, = 20° and y = 17 kN/m³. Calculate the percentage decrement in the magnitude of thrust on the wall when the wall is restrained against yielding to when the wall is free to yield (assume development of tension crack when wall yields). A 32.8% B 45.7% C 50.3% D 61.4%
FDE 002: A retaining wall 7m high supports a cohesionless soil having a dry density of 1620 kg/m³, angle of shearing resistance is 33 degrees and void ratio of 0.68. The surface of soil is horizontal and level with the top of the wall. Neglect wall friction and use Rankine's formula for active pressure of a cohesionless soil. Determine the height above the base of the wall where the thrust acts during the waterlogged condition. Select the correct response: 1.53 m 1.97 m 2.03 m 3.67 m
Given: → 4.5-m high retaining wall . Retaining homogeneous satorated soft clay. O'sat= 19.6 kNĪm³ Cu = 19.3 kN/m² ( undrained shear strergth) -> Diagram: Sopt Clay sat - 19.6 kN/m? Cu- 19.3 kN/m³ 4.5-m Make the necessary calu lation and draw the varialion of Rankine's active pressure on the wall with depth. nclude #te pressure from a waker-filled crack in - Find the depth up to which a tensile crack can occur. Delermink the total active force per unit lengh of the wall bepore the tensile crack gccurs. Assome tension stresses exist ard do not include the force from waler - filled Crack. - Delermine the tolal active force force per wall after the tensile crack occurs. 'Also, find Hhe locathon of the resultant. Neglect tersion shresses and include the force from the wafer-pilled crack. Find: your drawings unit lergth op the
a building will have a sitting wall on the north side of the building to allow for seating during outdoor season. the wall will be 1.5 meter tall. what is the minimum width of the wall to ensure that it will not slide or overturning? the soil behind the wall is a sand with Gamma dry= 18.3 kN/m^3 , gamma buoyant =11.5 Kn/m^3 , gamma water= 9.81 kN/m^3 and phi= 36 degrees. the water table is 0.5 m below the ground surface. to enhance the aesthic value of the seating area, the architect has asked that the wall he made of granite ( gamma granite= 25 kN/m^3. Hand written pls
At-rest: A 17-ft-high basement wall retains a backfill with y = 95 pcf, o' = 33°, c' 0 and OCR = 1.8. (a) Calculate the magnitude of the lateral thrust acting per unit length of wall: (b) Estimate the location of the lateral thrust measured from the bottom of the wall; and (c) Calculate the equivalent fluid pressure for this problem (Ans. 60 pcf). (Problem 13.2, Das and Sobhan, 2014).
Determine the active and passive force acting on a 3 meter high wall that supports clay with an undrained shear strength of 100 kPa and a unit weight of 19.20 kN/m
For the wall shown in the figure: A) Calculate the distribution of pressures according to Rankine, assuming an active state. B) Calculate the Thrust and its point of application. q=2.0 ton/m2 ↓ ↓ ↓ ↓ ↓ ↓ Y = 1.60 ton/m3 ARENA Y' = 0.60 ton/m3 C = 0 ton/m2 = 33° NAF H1 2.0 m H2 = 8.0 m
A retaining wall supports a horizontal backfill that is composed of two types of soil. The first layer is 4.79 meters high. It has a unit weight of 16.61 kN/m3. The second layer is 6.58 meters and has a unit weight of 18.72 kN/m3. If the angle of friction for both layers is 34°, determine the total active force (kN) acting on the retaining wall per unit width. Final answer should be in two decimal places.
A retaining wall is constructed in a clayey soil. The height of the backfill is found to be 9m, the unit weight of the sand is 2t/m³ and the angle of internal friction is 30°. Find out the earth pressure per meter length on the retaining wall with a smooth vertical back.
The following figure shows a section of an anchored retaining wall embedded into a saturated stiff clay layer. The sand has a unit weight of = 18 kN/m³, c' = 0 kPa and o' = 34º. The clay has a unit weight of = 20 kN/m³, c₁ = 80 kPa and = 0°. A uniform pressure of 40 kPa is applied on the soil surface. The short term stability of the wall is considered in an undrained analysis. Use the Rankin's theory of lateral earth pressure to determine the active and passive horizontal stresses. You should apply the requirements of AS 4678 and the partial factors of safety method in estimation of soil pressures. Assume the soil is in-situ and use a structural classification factor of ₁ = 1. 3m 1m Water table 1.5m 40 kPa Not to Scale Sand Clay Ta