A vertical triangular gate with its top base horizontal and 2m wide is 3m high. It is submerged in a liquid having sp.gr 1.25 with its top base submerged to a depth of 1.5m. Determine the magnitude and location of the hydrostatic pressure acting on one side of the gate

Q: A long solid cylinder of radius 0.8 m hinged at point A is used as an automatic gate, as shown in…

A:

Q: Problem 4. The gate below is 1.5 m wide and hinged at point B. It rests against a smooth wall at…

A:

Q: Q2. A tainter gate of 90° sector is subjected to water pressure as shown in figure below. Determine…

A:

Q: A square frame 5 m by 5 m in dimension is submerged in water vertically with its top of 3 meters…

A:

Q: a. Horizontal component (indicate the direction) of the total hydrostatic force acting on the gate.…

A: Horizontal component (F) of the pressure force is equal to the projection of the curved surface on…

Q: An isosceles triangular gate with a horizontal base 3 m long and vertex pointing downward is…

A: Using formula

Q: QB.43. A square tied column with a side dimension of 470 mm is reinforced with 12- 25 mm dia. bars…

A: Square tied column b = 470 mm h = 470 mm clear cover = 40 mm The reinforcement = 12 mm Reinforcement…

Q: 6. A circular door having a diameter of 3 m close a horizontal duct from a small dam a shown in…

A: Unit weight of water = 9.79 KN/m3 Determinea. The hydrostatic force acting on the door. b. Location…

Q: A triangular gate with a width equivalent to 1.5 m and its height is 3 m is submerged inversely in…

A: Hydrostatic forces are the resultant force caused by the pressure loading of a liquid acting on…

Q: B- In the water flow over the spillway in the Fig. 3, the velocity is uniform at section 1 and 2 and…

A:

Q: A 1.20 m-diameter(internal) horizontal steel penstock conveys water at the rate of 3.6 m³/s. The…

A: r = D/2 = 1.2/2 = 0.6m v = Q/A = 3.6πx0.62= 3.183m/s H (head) = 60m For instantaneous closure T ⩽…

Q: Each gate of a lock is 5m high and is supported by two hinges placed on the top and bottom of the…

A:

Q: 2. A triangular gate with a width equivalent to 1.5 m and its height is 3 m is submerged inversely…

A:

Q: A circular gate 1.5 m in diameter is inclined at an angle of 45 deg.. Fresh water strands on one…

A:

Q: A 5m long, 2m wide and 2m high tank is filled with water.  a. Solve the resultant hydrostatic force…

A:

Q: The uniform plate, which is hinged at C, is used to control the level of the water at A to maintain…

A: Given: Constant depth=6m, Plate width=4m, Plate mass= 80Mg

Q: An open vat holding oil (s frapezoidal cross-section 3 m wide at the bottom and 5 m wide at the top.…

A:

Q: 3. Determine the magnitude and location of the total hydrostatic force acting on the 2 x 4 m gate…

A: Given, Area of gate = 2m x 4m

Q: An upward flow of oil (mass density 800 kg/m°, dynamic viscosity 0.8 kg/m-s) takes place under…

A: Mass density of fluid (ρ) = 800 kg/m3 Dynamic viscosity (μ) = 0.8 kg/m-s Diameter of pipe (D) = 0.1…

Q: Problem 4. The gate below is 1.5 m wide and hinged at point B. It rests against a smooth wall at…

A:

Q: A 1.5m semi cicular gate is submerged in oil having an SG of 0.95. its base is 2m from the surface…

A: Given data-  Diameter of semi cicular gate (d) = 1.5m Specific gravity  of oil(S.G) = 0.95 Density…

Q: gate

A:

Q: A rectangular gate 1.2 m by 3 m is inclined 60° with the horizontal. The top of the gate is…

A:

Q: Hydrostatic force acting on the wall. .The resisting moment of the dam to overturning in kN-m. -…

A:

Q: Problem 6 A 6 meter high, 5 meter wide rectangular plate blocks the end of a 5 meter deep freshwater…

A:

Q: 1. Determine the magnitude of the roller reaction at E. 400 kN 0.6 m 1.0 m -0.4 m 035

A: We have to find the value of reaction at E.

Q: A square frame 5 m by 5 m in dimension is submerged in water vertically with its top of 3 meters…

A: We need to find out pressure at different locations given

Q: An upward flow of oil (mass density 800 kg/m³, dynamic viscosity (0.8 kg/m-s) takes place under…

A:

Q: 0: The concrete dam shown in Figure is constructed on a soil with coefficient of permeability k =…

A: coefficient of permeability  k=0.05 cm/sec=5×10-4 m/secNo. of flow channels  Nf=3No. of potential…

Q: 45° SG = 0.86 | 50 cm A %3D Hinge 10 cm SG = 1.23 80 cm В

A:

Q: A vertical gate of height 5 m and width of 3 m opposes the water at one of its sides. The deep of…

A:

Q: An upward flow of oil (mass density 800 kg/m³, dynamic viscosity (0.8 kg/m-s) takes place under…

A: Given data  Density of oil = 800 kg/m3 Dynamic viscosity= 0.8 kg/ms  Diameter of pipe (D) = 0.1 m…

Q: A 3-m-wide, 8-m-high rectangular gate CD is located at the end of a rectangular passage that is…

A:

Q: Q.₁ Compute the maximum capillary tension for a tube of 0.12 mm in diameter at 4°C A 1.26 kN/m² B…

A: Diameter- d=0.12 mm,

Q: hydrostatic

A:

Q: What is the minimum width for the base of a dam 30m high if upward pressure beneath the dam is…

A: Depth of water = 30 m Depth of dam = 30 m Top width, b = 6 m Assume the bottom width be B To…

Q: 7. The mass less, 1.2 m wide gate shown in fig. (2.7) pivots about the frictionless hinge (O). It is…

A: Given data 1.2 m wide gateCounter load= 8.9×103N Calculate the water depth  h Consider the equation…

Q: For the quarter circle gate BC with a hinge at C, the force P = ... . . kN to hold the gate…

A:

Q: What is the maximum stress which could be produced in the pipe of Prob. 6-2 as a result of suddenly…

A:

Q: Problem 4. The gate below is 1.5 m wide and hinged at point B. It rests against a smooth wall at…

A: Width of gate = 1.5 m Hinged at point B Specific gravity of sea water = 1.025 To find:- Force on…