A vertical load P = 800 lb applied to the tripod shown in the figure, causes a compressive force of 256 lb in leg AB and a compressive force of 283 lb in leg AC. Determine the force in leg AD and the coordinates xD and zD of its lower D.

Q: The force F1 = 5 kN, F2= 5 kN, F3= 10 kN, F4 = 5 kN are acting on the structure shown. Determine the…

A: According to the given dataWe need to findThe tension in the force BC , BE and EF

Q: Calculate the forces in members AB, BH, and BG. Members BF and CG are cables which can support…

A: Find the force in member AB , BH and BG  Where BF and CG are tension member.

Q: Given: A set of four forces act at corners of a parallelpiped block, as shown below. Find: a)…

A:

Q: want to know how much heat the tube lost due to the material it is made of aluminum or steel. Even…

A:

Q: A wire is stretched tight between two pylons, one of which is shown in Fig. to the xy-plane and…

A: Draw the free-body diagram for joint D.

Q: The light boom AB is attached to a vertical wall by a ball and socket joint at A and supported by…

A:

Q: Problem 4: Consider the two-dimensional truss given in the figure below. If the maximum force that…

A:

Q: The smooth uniform rod AB is supported by a ball-and-socket joint at A, the wall at B, and cable BC.…

A: Given:The mass of the uniform rod is, .The acceleration due to gravity is, .Tension in cable BC is,…

Q: For the shown frame structure, the uniform beam AB weighs 480 lb and the uniform column CF weighs…

A:

Q: For the truss shown, find the magnitude of the force F BE using the figure and the given data. F₁ =…

A:

Q: . Compute the forces in each ball-and-socket joint (A, B, C, D, E) of the given Loaded frame. In the…

A:

Q: 2.A plane is flying up a parabolic path of equation y=0.005².Atx=1,000m, the speed is 300 m/s and…

A:

Q: Determine the force in each member of the truss shown in the figure below. 600 lb 600 lb 600 lb D…

A:

Q: A 3D truss is supporting 2 forces F₁ and F2. F₁ = 1,080 N at and angle alpha= 33 deg. F1 is in the…

A:

Q: The bent rod is supported at A, B, and C by smooth journal bearings as shown in (Eigure 1).

A:

Q: 1. Find the forces in the members  S2, S6 og S11. 2.By applying a horizontal force F4F_4F4​ at point…

A:

Q: Consider the pin jointed truss structure depicted in the accompanying figure and determine the force…

A:

Q: The system consisting of the bar OA, two identical pulleys, and a secti shown in the figure.…

A: The free-body diagram is as follows-

Q: Three hydraulic cylinders control the motion of the backhoe arm and bucket in the given figure. In…

A:

Buckling of columns

The column is described as a vertical member of the structure that carries an axial compressive load, and buckling is a lateral deformation of the column under the application of load.