a vapor-compression refrigeration system uses R-134a. the evaporator pressure is 200.60 kPa and a condenser pressure of 770.20 kpa. The refrigerant enters the compressor as a saturated vapor and leaves the condenser as subcooled liquid at 20C (there is subcooling from Tsaturated to 20C)

Q: Air is to be compressed from 3 bar and 303K to pressure of 15 bar in a multistage compression…

A: a multipart question about a simply supported beam subjected to a thermal load and an axial point…

Q: The liquid food is flowed through an uninsulated pipe at 90 ° C. The product flow rate is 0.4 kg / s…

A: Given: T1 = 90 oC             T1 = 15 oC Required: Convection coefficient in the pipe hfood =?…

Q: Refrigerant 134-a enters the condenser of a residential heat pump at 800 kPa 35 C at a rate of 0.018…

A:

Q: In order to increase the velocity of steam used as a fluid for a power plant, it was concluded that…

A: Nozzle is a device which is used to increase the velocity of fluid. Given data: Mass flow rate of…

Q: A reciprocating compressor draws in 500 gal per minute of air whose density is 0.079 Ibm/cu ft and…

A:

Q: A piston-cylinder device initially contain 0.4 m3 of 1.8-kg saturated liquid water and steam mixture…

A:

Q: The liquid food is flowed through an uninsulated pipe at 90 ° C. The product flow rate is 0.4 kg / s…

A: Given DataMass flow rate of food=0.4 kg/s

Q: Oil flows at a rate of 1000 kg/min from an open reservoir at the top of a hill 400 m in height to…

A: The mass flow rate of the oil = 1000 kg/min. Height(Z)=400 m. Heat supplied=1800 kJ/min. Work done…

Q: A refrigerator operates on a reversed Carnot cycle whose coefficient of performance is 5.0. The…

A:

Q: 12 kg of air per minute is delivered by a centrifugal air compressor It enters the compressor at a…

A:

Q: Calculate the heat transfer and exit temperature of both

A:

Q: Consider a steam power cycle operating according to the simple ideal Rankine cycle. The steam enters…

A: Hello. Since your question has multiple parts, we will solve the first question  for you. If you…

Q: Refrigerant 134a flows through a horizontal tube with an inside diameter of 5 cm. The refrigerant…

A: Given: The inside diameter of the horizontal tube=5 cm quality at which the refrigerant enters=0.1…

Q: 2.

A: Using the steam table, State 1 at P1= 0.8 MPa T1= Tsaturated= 31.31oC H1 =Hf= 95.47 KJ/Kg and State…

Q: A steam power plant operating in a Rankine cycle has saturated vapor at 4.0 MPa leaving the boiler.…

A: The initial pressure is obtained from the steam table. The enthalpy and entropy of the initial…

Q: To achieve cooling to a lower temperature on an industrial scale, a cascade refrigeration system…

A:

Q: Q2/ Steam at 320 °C and 80 bar enter Nozzle with velocity 70 m/s and leaving by temperature is 100…

A:

Q: It is proposed to design and develop a Rankine cycle Steam Power Plant in which steam at 80 bar and…

A: Note: Since we are entitled to answer only 3 sub-parts, we’ll answer the first 3 subparts. Please…

Q: Water in a tank at 87OC is pumped into a second tank that is located 20 m above the initial tank at…

A: Temperature of water in tank 1 = 87 0C Mass flow rate = 6.5 kg/s Work done by the pump = 500 kJ/s…

Q: (For numbers 4 to 10) A double-pipe heat exchanger (counterflow operation) having an area of 100 m²…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: Problem 1: One kg of water is placed inside a well-insulated piston. The external pressure PE is…

A: External pressure= 10 MPa Initial temperature of water= 20 0C Final temperature of liquid = 400 0C…

Q: Air enters an insulated compressor at ambient conditions, 100 kPa, 20C at the rate of 0.2 kg/s and…

A: Given: P1 = 100kPa T1 = 273+20 = 293K m = 0.2kg/sec T2 = 500K n= 70% Cpo= 1.004kJ/kg.K

Q: The chilling room of a meat plant is 15 m × 18 m × 5.5 m in size and has a capacity of 350 beef…

A: It is very essential to cool beef carcasses as fast as possible to avoid the growth of…

Q: A horizontal coil of water is circulated through it, which is heated from the outside by…

A: Given: The inlet pressure of water=200 kpa The outlet pressure of water=100 kpa The inlet…

Q: A gas refrigeration system using air as the working fluid has a pressure ratio of 5 (see Fig. Q 1).…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: A compressor receives air at 101.3 kPa at a steady rate of 0.5 kg/s and delivers at 700 kPa. At the…

A: Given mass flow rate of air into compressor, v= 0.5 kg/s inlet velocity of air V1=6 m/s exit…

Q: The temperatures of the 12 °C water at inlet 13 °C 15 °C 30 °C The temperatures of the 20 °C water…

A:

Q: 4.3. Steam flows steadily through an adiabatic turbine. The inlet conditions of the steam are 4 MPa,…

A:

Q: A heat pump system which uses R-134a operates on the ideal vapor compression heat pump cycle with a…

A:

Q: A double pipe heat exchanger is used to cool a 15000 lb/hr air from 175°F to 75°F. Air enters on the…

A: Given Parameters are :-  mass flow rate of air = 15000lb/hr Inlet temperature of air = 175 0F Outlet…

Q: liquid water at 294.26 K. flows in a straight horizontal pipe in which there is no exchange of…

A: Enthalpy change of the water for the given flow is to be determined.

Q: The liquid food is flowed through an uninsulated pipe at 90 ° C. The product flow rate is 0.3 kg / s…

A: Given DataMass flow rate of food  m=0.3 kg/sSpecific heat of food  Cp=4 KJ/kg.KThermal conductivity…