A unity feedback control system has open loop transfer function: 0.4 G(s) = %D s(1+ 0.067s)(1+ 0.004s) Estimate the values to plot Bode plot for the magnitude verses frequency and the phase angle verses frequency.

A unity feedback control system has open loop transfer function: 0.4 G(s) = %D s(1+ 0.067s)(1+ 0.004s) Estimate the values to plot Bode plot for the magnitude verses frequency and the phase angle verses frequency.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A unity feedback control system has open loop transfer function: 0.75 G(s) %3D s(1+ 0.125s)(1 +…

A: Given the open loop transfer function: G(s)=0.75s(1+1.125s)(1+0.0067s) We need to plot bode…

Q: if the feedback loop gain is small, the oscillation increase dies-out stays the same goes back to 1

A: Given & to find: (1) if the feedback loop gain is small. the oscitation ❑ increase ❑ dies-out ❑…

Q: For the circuit given below, suppose that RE = 6.8k2, Rc = 4.7k2, V1 = +6V and V2 = -10V. a) Plot…

Q: How would you increase the passband gain by a factor of five without changing the cutoff frequency?

A: Passband represents the range of frequency at which it will allow the output. The difference between…

Q: Damping ratio of second order system unity negative feedback changed from 0.2 to 0.6. Find value of…

A: Solution: The formula of peak overshoot is given as, Mp=e-πρ1-ρ2 Case (1) Damping factor…

Q: A unity feedback system has the open loop transfer function shown below. What is the phase crossover…

A: Given open loop transfer function is, HG(s)=K(1+s)2s3

Q: band

A: In this question, we have to define pass band, attenuation band and cut off frequency used in…

Q: hat is the relationship between duty cycle and gain bandwidth?

A: Gain bandwidth- The gain bandwidth product is an important parameter for any analog amplifier and it…

Q: Q2: A circuit as in the figure, has a bandwidth frequency of 2400HZ, and resonance frequency of 4000…

A: We need to calculate analyse the series RLC circuit .

Q: A = 100,000. Resistor values are RI – 1000 Ω and Rf…

A: Given circuit is - Given values are - A=100000RI=1000OhmRF=10000Ohm

Q: Question 1: Write the difference between active and passive filters in detail.

A: Since there are multiple questions present, as per the guideline, only the first question has been…

Q: -Bode plot -Ngopost Homework & Dr. Lafta (21 For the following open loop transfer functions. with…

Q: A feedback system root locus graph shown in figure below. For damped frequency 8.04 Hz, the gain K =…

A: Root locus

Q: Define Resonance ?

A: Resonance is a special case of the forced vibrations. when the frequency of an externally applied…

Q: Q6. Which of the following is a significant limitation of a passive filter compare to active filter?…

A: 6. The limitation of the passive filter as compared to active filter is that the precise tuning is…

Q: b. The open loop gain cross over frequency of a continuous-time plant is 2.1 rad/s. Determine the…

Q: QUESTION 6 A unity feedback system has the open loop transfer function shown below. What is the…

A: Given, HG(s)=K1+s21+s4s3

Q: 1. The bode plot for an open loop transfer function, KG(s), with K = 1, is shown below. a. What is…

A: Given Data:The Bode Plot of an open loop system .To Find:The type of the system.Gain and phase…

Q: A closed-loop amplifier is to have a 75° phase margin for 3 = 1. What is the required unity-gain…

A: For a closed-loop amplifier the phase margin is .The value of current gain is .It is given that MHz…

Q: In the Collector-base resistance circuit find, feedback gain, input and out impedance and feedback…

A: Given data, hfe=80h0e=0hre=0VCC=10 Vhie=5000Rb=40 kΩRs=600 RC=2 kΩ

Q: A feedback system root locus graph shown in figure below. The angle of departure theta = Root Locus…

A: In the figure, roots locus graph is showing. What is departure angle of the system?

Q: Q4) Design second (2") order BPF with center frequency 10KHZ and bandwidth = 2KHZ, with overall…

A: Given f = 10 KHz BW = 2 KHz gain = 64

Q: In a short circuit test on 132 kV, 3-phase system, the breaker gives the following results: Power…

Q: Vin ww Ra + Rb ww 741 Figure 2. Vout 2. In Figure 2, Ra = 1k2 and Rb = 40k52. a) Find the midband…

Q: Bode Diagram 50 -50 -100 -150 -90 -180 -270 101 10 Frequency (rad/s) 10° 102 10 Magnitude (dB) (Bap)…

Q: The open loop transfer function of a unity feed back system is given by G(s) = (e-0.1s)/s. The gain…

A: Given- The open loop transfer function of a unity feedback system, Gs=e-0.1ss To find- The gain…

Q: 4) Consider the feedback control system in Figure RU) Controller GAN) G.G(s) = Process GU) 300 (s² +…

Q: 2. Consider the following simple feedback system. G(s)= K S-1 (a) Find the Nyquist plot for the…

A: In this question we need to find the following Draw a Nyquist plot for the given system at K=3 Gain…

Q: R(s) C(s) K G(s)

A: Gain margin and phase margin is calculated for open loop transfer function GA=M=[G(jw)H(jw)] here we…

Q: How many feedback loops in the following signal flow graph? 9 - 4/R, R -1R, 1/R, 1/R O A) Three B)…

Q: The open loop Bode diagram of a feedback system is given. By using this plot, a) Determine the type…

A: The bode plot of the system is

Q: A negative feedback control system is described below. R(s) C(s) G(s) H(s) a G(s) = H(s) = c s2 + b'…

A: Given system is - Given values are - a=4b=2.3c=12.7

Q: b) If ß=-0.015 and A =-5×10“, determine the closed-loop gain Ar.

A: Closed loop gain = A/(1+A*bita) Here all A and bita are given.

Q: A unity feedback system has a forward path transfer function G(s) = 25/(s^2+3.5s+25). Find the…

A: Find the value of delay time, rise time, percentage overshoot, peak time and settling time for step…

Q: In a control system with unity gain feedback, the transfer function of the loop-gain function is…

A: Given transfer function of loop gain is - Ls=9e-0.1sS

Q: Refer to the series resonant circuit of figure Q2. Suppose the circuit has a quality factor of Qs =…

A: it is asked to find the current, voltage ,reactive power, impedance, frequency at resonance for…

Question

A unity feedback control system has open loop transfer function:
0.4
G(s) =
s(1+0.067s)(1+ 0.004s)
Estimate the values to plot Bode plot for the magnitude verses frequency and
the phase angle verses frequency.

Expert Solution

Step 1

Step 2

Step 3

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 5 images

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

consider a sinusoid input with a peak amplitude of 2 mV. If the amplification gain A1 = 500 and k-0.125, the error (E) and the amplitude of the output waveform Vout of the feedback network are: R2 (a) Select one: O a. none of these O b. E=0.031m and Vout= 15.75mV O c. E= 127m and Vout= 15.75 O d. E=127m and Vout= 1V
Q#3: Discuss the surge current in the capacitor-Input filter with the help of schematic diagram.
H4.
1. Derive the lower cut-off frequency for the basic RC high-pass circuit in Figure 1. R, Figure 1.
3-Discuss the effect of negative feedback on the frequency response
control system
Why is the no encirclement about(-1+jo)?
What are the barkhausen criteria for oscillations in a open loop circuit?
Answer all
What is the resonant peak magnitude of a unity feedback closed-loop system with the following open- loop transfer function? Choose the closest answer. G(s) = T6+2) 4 Select one: a. 0.06 dB b. 1.15 dB c. 6.30 dB d. Does not exist X e. 1.25 dB