A uniform water stream, U∞ = 20 m/s and ρ = 998 kg/m3,combines with a source at the origin to form a half-body. At(x, y) = (0, 1.2 m), the pressure is 12.5 kPa less than p∞. (a) Isthis point outside the body? Estimate (b) the appropriatesource strength m and (c) the pressure at the nose of the body.

Q: The tank in Fig.  is fi lled with water and has a venthole at point A. The tank is 1 m wide into the…

A: Understand that the tank accelerates to the right at 5 m/s2 and as the tank accelerates it causes…

Q: A pipeline with roughness ks = 1.0mm and diameter D = 8.8cm connects two reservoirs. The reservoirs…

A: Given:Surface roughness of the pipe, ks=1.0 mmPipe diameter, d=8.8 cm=0.088 mSurface elevation…

Q: Liquid drains from a small hole in a tank, as shown inFig. P4.60, such that the velocity fi eld set…

A: We need to first understand the rotational and rotational flow, Irrotational Flow: Irrotational flow…

Q: A non-viscous fluid is flowing through the pipe as shown. At which location is the pressure the…

A:

Q: Water flows around the vertical two-dimensional bend with circular streamlines and constant velocity…

A: Given data: v=10 m/sp1=62 kpa

Q: Consider a geyser that shoots water to a height of 28 m into the air. Density of water, rho = 1000…

A: Given Data : Height of water Geyser shoot y2 : 28m Density of water ρ : 1000 kg/m3  acceleration…

Q: A fluid with specific weight of 12000 N/m³ and viscosity of 0.002 kg/m.s flows between two parallel…

A: Given, γf=12000 N/m3 μ=0.002 kg/m.s b) H=0.2 cm=0.002 m γm=16000 N/m3 c) L=15 cm=0.15 mU=0.007…

Q: Gasoline is flowing through this 180° pipe bend. The pipe cross-sectional area is 18 in?. Take the…

A: The density of the gasoline in general is assumed as ρ=680 kg/m3=42.41 lbm/ft3. The pipe has a…

Q: An airplane is flying at 350 mi/h at 4000 m standard altitude. As is typical, the air velocity…

A: Given Data The initial velocity of the jet; v1 = 350 mi/h. The altitude of the airplane; h = 4000 m.…

Q: FLUID FLOW xample 5: A liquid food with a density of 800 kg/m³ is being transportec 5 ton/h through…

A: Given data:Density of fluid = 800kg/m3Flow rate Q =5 ton/hr = 5/3600 m3/s

Q: (E) A uniform stream of fluid with speed U at infinity flows two-dimensionally and irrota- tionally…

A:

Q: The velocity magnitude of the normal flow to a streamline is, (a) zero (b) ÷Vr (c) Vr (d) more…

A: 1)Velocity 2)Pressure Force

Q: A piston moves with constant velocity Up in a cylinder having radius R. A liquid having density p…

A:

Q: A liquid of density 1150 kg/m3 flows steadily through a pipe of varying diameter and height. At…

A: Given data as per question The density of liquid =1150 kg/m3 v1 = 9.47 m/s d1 =11.7 cm d2 =17.7 cm

Q: A. A horizontal water jet hits a vertically mounted plate and an obliquely mounted plate as shown in…

A:

Q: engineering problem.   The Reynolds Transport theorem for conservation of mass is as follows…

A: Ans: option (b) is correct.  b. Equal to

Q: An incompressible fluid (water) flows steadily from an open tank. The elevation of point 1 is 10.0m,…

A: Consider the figure:

Q: 2. (i) Water flows through a 5cm diameter pipe which has a 180° vertical bend, as in the Figure…

A:

Q: 6) Air flow though the device shown in figure. Select which set of the following conditions is TRUE…

A: Option  e is correct We know that, AV = constant Just keep on mind my dear where area is large…

Q: Consider air flowing past a hemisphere resting on a flatsurface. If the internal pressure is pi,…

A: The expression for the force on the hemisphere is, From the above expression, the pressure force…

Q: A jet of water strikes a splitter and splits into two streams of equal velocity but unequal…

A: Consider the diagram shown below for the given system. (a) From the conservation of mass, the…

Q: (a) A wing section with a chord of c and a span of b is mounted at zero angle of attack in a wind…

A:

Q: In an oil pool, a small steel ball is released from the surface (y=0) without initial velocity. The…

A: Given that, Mass of ball, m=0.2 kg,Constant, k=0.84355 kg/sec,Acceleration due to gravity, g=9.81…

Q: Water in a vertical (i.e., gravitational force of the fluid in the nozzle plays a role, and the…

A:

Q: A pipe inclined at 45° to the horizontal (Fig. 2) converges over a length l of 2 m from a diameter…

A: According to the continuity equation, the product of fluid velocity and cross-section area of the…

Q: For the pipe-flow reducing section of the figure shown, D₁ = 8 cm, D₂ = 5 cm, and p=1 atm. All…

A: Pls, refer the below explanation:Explanation:Let's solve the problem step by step as below:

Q: Your uncle is in the below-deck galley of his boat while you are spear fishing in the water nearby.…

A: Given data: Hole diameter (d) = 0.9 m Surface area (A) = 1.20 cm2 = 1.20×10-4 m2 Water leaks  = 10 L…

Q: A Closed tank of water with Length, I = 20 ft Height, h = 10.45 ft %3D Width, w = 5.6 ft %3D Pgage =…

A: Given: Length of the tank→L=20 ft Height of the tank→h=10.45 ft Width of the tank→w=5.6 ft Because x…

Q: A viscous laminar fluid between two parallel plates is driven by the top plate moving at a constant…

A:

Q: s 50 kg. Determine the anchoring force needed to hold the elbow in place. Take the momentum-flux…

A: The angle of deflection is: θ=45ο The mass flow rate of water is: mο=30 kg/s The area of the elbow…

Q: In deriving the continuity equation, we assumed, for simplicity,that the mass fl ow per unit area on…

A: Solution : Consider a cuboid of dimension dx ,dy &  dz as shown in figure below :

Q: The P-35  experiences a certain dynamic pressure at its cruising speed of 114.2 m/s at an altitude…

A: Given Data: Altitude h = 4 km. Cruising velocity v= 114.2 m/s. The density of air at 4 km altitude…

Q: A river discharges into a reservoir at a rate of 400,000 ft'/s (cts), and the outflow rate from the…

A:

Q: 1. Consider a three-dimensional steady incompressible flow with components: u=-x(y+2), v= y²,…

A: u = -x(y+z)v = y2w = 12z2 -2yz

Q: Consider water fl owing by gravity through a short pipeconnecting two reservoirs whose surface…

A: Bernoulli's equation:  The Bernoulli's equation states that total energy i.e. pressure, kinetic and…

Q: Take the densilty and pressure values at 7km, and then apply Bernoulli equation. I think this is the…

A: Given:h = 7 kmv1=300 m/sv2=400 m/sTo find:Pressure at that point, p2

Q: The plate is circular and 50 cm in diameter. The jet (D) is 10 cm and the hole (d) is 5 cm in…

A:

Q: When a fluid originally at rest is accelerated on a streamline under steady flow conditions, Select…

A:

Q: If there are no shock waves and the pressure at one ductsection in Fig.  is 55.5 kPa, what is the…

A: given data as per the question The temperature of tank =400 k The pressure of tank =300 Kpa…

Q: A tornado in atmospheric air is simulated by a CCW free vortex as a potential flow field. The…

A: Given: The velocity measured at r1= 1 m from the center is v1=60 m/s, Air density ρ= 1 .0 kg/m3.…

Q: (a) Use the y-momentum equation to show that the pressure gradient across the boundary layer is…

A:

Q: Consider the following figure showing a jet of water supporting a weight of 100 N at aheight of 5 m…

A: A force is an influence that can alter an object's motion. A force can cause an object with mass to…

Q: An airplane is fl ying at 300 mi/h at 4000 m standardaltitude. As is typical, the air velocity…

A: Given data: The velocity of the jet, v1 = 300 mi/h. The altitude of the airplane, h = 4000 m.…

Q: A solid cone of angle 2θ , base r 0 , and density ρ c is rotatingwith initial angular velocity ω 0…

A:

Q: Find the horizontal and vertical forces to hold stationary the nozzle shown in the figure below. The…

A:

Fluid Kinematics

The branch of science that deals with objects which are either in motion or stationary are studied under the branch of classical mechanics. Fluid mechanics is a subcategory of classical mechanics that deals with the behavior of fluids at rest (fluid statics) or in motion (posing some velocity). In fluid kinematics, studies focus on the associated motion of fluid particles or groups of particles, and its associated parameters like displacements, velocity, and acceleration without concerning about the forces that caused the motion. All the laws of classical mechanics are applied in the study of fluid kinematics.